What you need to know before replacing your Dodge Journey battery
Replacing a Dodge Journey battery is a task you can do yourself with basic tools, or you can have a technician handle it. The battery sits in the engine bay on the driver's side, and the whole job usually takes 15 to 30 minutes. You'll need a wrench set, a new battery that matches your Journey's year and engine size, and safety glasses. Before you start, turn off the engine and let it cool, then disconnect the negative terminal first — this prevents electrical shock and protects your vehicle's computer systems.
The cost of a replacement battery ranges widely depending on the type and brand you choose. Standard lead-acid batteries cost less than premium or AGM (absorbent glass mat) batteries. If you buy the battery from an auto parts store, many will install it for free or for a small fee. If you go to a dealership or independent shop, labor costs vary by location and shop rates.
Key Takeaways
- Always disconnect the negative terminal first and the positive terminal second to avoid electrical damage and personal injury.
- Your Dodge Journey battery is located in the engine bay on the driver's side and takes 15 to 30 minutes to replace.
- Write down your radio presets and any security codes before disconnecting the old battery, as some settings may reset.
- After installation, reconnect the positive terminal first, then the negative terminal, and start the engine to confirm the battery is working.
Locating and removing the old battery
Open your Dodge Journey's hood and look toward the driver's side of the engine bay. The battery is a rectangular black box with two cable terminals on top — one red (positive) and one black (negative). Before you touch anything, put on safety glasses and remove any metal jewelry that could cause a short circuit.
Loosen the nut on the negative terminal (black cable) with a wrench and slide the cable off. Do the same for the positive terminal (red cable). If the terminals are corroded or stuck, spray them lightly with penetrating oil and wait a few minutes. Once both cables are disconnected, locate the battery hold-down bracket — usually a metal or plastic bar across the top or sides of the battery — and remove the bolt or bolts holding it in place. Lift the battery straight up and out of the tray. Batteries are heavy, so use both hands and keep your back straight.
Choosing the right replacement battery
Your Dodge Journey's battery size and type depend on the model year and engine. Check your owner's manual or look at the label on your old battery for the group size (usually something like 24F or 35). The manual will also tell you the cold cranking amps (CCA) rating your vehicle needs. Most Journey models use a standard 12-volt lead-acid battery, but some may have an AGM battery if equipped with a start-stop system.
When you shop for a replacement, bring your vehicle's year, make, and engine size to the auto parts store. Staff can cross-reference this information and show you batteries that fit. Compare warranty lengths — many batteries come with a three-year full replacement warranty and a longer prorated warranty. If you plan to keep your Journey for several more years, a longer warranty may be worth the extra cost.
Installing the new battery
Place the new battery in the tray, making sure it sits flat and level. Reinstall the hold-down bracket and tighten the bolts firmly but not so tight that you crack the battery case. Now reconnect the cables in reverse order: positive (red) terminal first, then negative (black) terminal. Tighten each terminal nut until the cable is snug and does not wiggle, but do not over-tighten.
Close the hood and start the engine. It should turn over normally. If the engine cranks slowly or does not start, turn off the ignition and check that both cable connections are tight and fully seated on the terminals. Once the engine starts, let it run for a few minutes. You may notice that your radio presets, clock, or other settings have reset — this is normal and happens because the vehicle lost power while the battery was disconnected. Reprogram these settings as needed.
When to take your Journey to a technician
If you are not comfortable working under the hood or do not have the right tools, a technician can replace the battery quickly and safely. Most auto parts stores offer free or low-cost installation when you buy a battery from them. Independent repair shops and dealerships also offer battery replacement, though dealership prices are usually higher.
You should also see a technician if your Journey does not start after you install the new battery, or if the battery drains quickly after replacement. These signs can point to a charging system problem, a parasitic drain, or a faulty alternator — issues that go beyond a straightforward battery swap. A technician can test your charging system and alternator to find the real cause.
Recycling your old battery
Do not throw an old car battery in the trash. Batteries contain lead and sulfuric acid, which are hazardous to the environment and illegal to dispose of in landfills in most states. Most auto parts stores will take your old battery for free when you buy a new one from them, or they may offer a core charge (a small refund) if you bring it in separately.
If you replaced the battery yourself, ask the store where you bought the new battery whether they will accept the old one. If you had a technician replace it, they will handle disposal as part of the service. Some recycling centers also accept car batteries, so you can call your local waste management facility to ask about drop-off options.
Troubleshooting after battery replacement
If your Journey still will not start after you install a new battery, check the cable connections first. Make sure both terminals are tight and free of corrosion. If the connections look clean and tight, the problem may be with the alternator, starter, or another electrical component — not the battery itself. A technician can run a charging system test to diagnose the issue.
If the battery drains quickly or the check engine light comes on after replacement, the vehicle's computer may need time to relearn its settings. Drive the Journey normally for 50 to 100 miles and see whether the light goes away. If it stays on, a technician should scan the vehicle's diagnostic codes to find out what triggered the light. Sometimes a battery disconnect can set a code that clears on its own after a few drive cycles.
Frequently Asked Questions
Can I replace the battery myself if I have never done it before?
Yes. Battery replacement is one of the simplest vehicle maintenance tasks. As long as you follow the steps in order — disconnect negative first, reconnect positive first — and wear safety glasses, you should have no problems. If you feel unsure at any point, stop and take your Journey to a technician.
What happens to my radio presets and security settings when I disconnect the battery?
Most Dodge Journey radios will lose their presets and clock settings when power is cut. Some vehicles with security systems may also reset. Write down your presets before you start, or ask your technician to note them. Reprogramming usually takes just a few minutes.
How long does a Dodge Journey battery usually last?
Most car batteries last three to five years, depending on climate, driving habits, and how often you use electrical features. Hot climates shorten battery life. If your battery is more than three years old and you notice slow cranking or dimmer lights, replacement may be coming soon.
Should I buy a more expensive battery or a cheaper one?
A longer warranty usually means better quality and longer lifespan. Budget batteries may cost less upfront but may not last as long. Compare the warranty length and price together — a battery that costs $20 more but lasts two years longer is the better value.
What should I do if the battery terminals are corroded?
Spray the corroded terminals with penetrating oil and let them soak for a few minutes. Scrub them gently with a wire brush or old toothbrush to remove the white or blue-green buildup. Rinse with water and dry completely before reconnecting. If corrosion keeps coming back, ask a technician to check your charging system.