What a delete kit removes from your 2017 6.7 Powerstroke
A delete kit for a 2017 6.7 Powerstroke removes or bypasses emissions control systems — specifically the diesel particulate filter (DPF) and exhaust gas recirculation (EGR) system. These components are factory-installed to reduce emissions but also restrict exhaust flow and can create maintenance headaches like DPF clogs and EGR cooler failures.
When you install a delete kit, you're removing physical parts and installing new exhaust piping that routes gases around where those systems used to be. The engine then runs without the backpressure those systems created, which changes how it performs and how it sounds.
This is not a modification that falls into a gray area legally. Removing or disabling emissions equipment on a vehicle registered for road use is illegal under federal law and in all 50 states. The EPA and California Air Resources Board (CARB) enforce penalties against both installers and vehicle owners. That said, many truck owners do this work anyway, usually on vehicles they plan to keep off public roads or in jurisdictions where enforcement is rare.
Key Takeaways
- A delete kit removes the DPF and EGR system by installing new exhaust piping, which reduces backpressure and changes engine performance.
- Removing emissions equipment is illegal on any vehicle registered for road use under federal EPA law and state regulations.
- Installing a delete kit will trigger a check engine light and cause the vehicle to fail emissions testing in states that perform it.
- Common reasons owners pursue this modification include avoiding DPF regeneration cycles, preventing EGR cooler failures, and increasing horsepower and fuel economy.
- The cost of a delete kit and installation typically ranges from $800 to $2,500 depending on the shop and whether tuning is included.
Why owners consider delete kits despite the legal risk
The 6.7 Powerstroke's DPF and EGR systems are known failure points. The DPF clogs with soot and forces the engine into regeneration cycles — periods where the truck runs hot to burn off accumulated particulates. These cycles reduce fuel economy, generate excessive heat, and can damage the turbo or create safety issues if they happen while towing. The EGR cooler, which cools recirculated exhaust gases before they re-enter the engine, is prone to internal corrosion and leaks that can cost $1,500 to $3,000 to replace.
Owners who delete these systems report that regeneration cycles stop, fuel economy improves (often by 2 to 4 miles per gallon), and the truck produces more horsepower. A stock 6.7 Powerstroke makes around 440 horsepower; deleted and tuned versions can reach 500+ horsepower. The truck also sounds different — louder and more aggressive — which some owners prefer.
For owners who use their trucks off-road or on private property only, the legal risk feels manageable. For those who drive on public roads, the risk is real: a failed emissions test, a check engine light during a traffic stop, or a roadside inspection can result in fines, vehicle impoundment, or both.
What happens to your truck after a delete
Once the DPF and EGR are physically removed, the engine computer still expects them to be there. The sensors that monitored those systems now read abnormal values, which triggers diagnostic trouble codes and illuminates the check engine light. Most shops that install delete kits also perform a tune — a reprogramming of the engine control module (ECM) — to disable the fault codes and adjust fuel and timing parameters for the new exhaust configuration.
Without a tune, your truck will run but the check engine light will stay on and the engine may enter limp mode, where power is reduced. With a tune, the light goes off and the truck runs normally. However, the tune itself is also illegal under EPA regulations, and a diagnostic scan at any repair shop will reveal that the vehicle has been modified.
Deleted trucks also produce more soot and higher nitrogen oxide (NOx) emissions, which is why the original systems existed. If your state or county performs emissions testing, a deleted truck will fail. Some states test every vehicle annually; others test only in certain counties or only when a vehicle changes ownership. Check your state's emissions testing requirements before deciding.
Cost and installation considerations
A complete delete kit for a 2017 6.7 Powerstroke includes new exhaust piping, gaskets, clamps, and sometimes a new downpipe. Kits alone cost between $400 and $1,200 depending on the brand and whether they include a resonator or muffler. Labor for removal and installation typically runs $400 to $800 at a diesel shop, and a tune adds another $300 to $600.
Total cost is usually $800 to $2,500. Some shops bundle the kit, installation, and tune into a single package price. Before choosing a shop, ask whether the tune is included, what warranty they offer on the work, and whether they provide any documentation of what was done (some owners keep records in case they need to reverse the modification later).
Installation takes 4 to 8 hours depending on how much of the original system needs to be removed and whether any exhaust components need to be modified to fit the new piping. Most shops can complete the work in one day.
Reversing a delete or selling a deleted truck
If you later decide to reverse the modification — to pass emissions testing, sell the truck, or reduce legal risk — you will need to reinstall the original DPF and EGR system and have the ECM tuned back to stock. Used OEM parts can sometimes be found at salvage yards for $500 to $1,000, but labor to reinstall and re-tune will cost another $800 to $1,500. Full new parts from Ford cost significantly more.
Selling a deleted truck is complicated. Private buyers may not care, but dealers will not accept a deleted truck on trade-in, and financing companies may refuse to loan on one if they discover the modification during inspection. If you plan to sell within a few years, factor in the cost of reversal before you delete.
Legal consequences and enforcement
The EPA can fine vehicle owners up to $37,500 for tampering with emissions equipment, though individual enforcement is uncommon. More likely is a failed emissions test, which can result in a failed inspection, registration denial, or fines ranging from $100 to $1,000 depending on your state. Some states also require the vehicle to be brought into compliance before registration can be renewed.
California and other CARB states have stricter enforcement and higher penalties. If you live in or plan to move to a state with active emissions testing, a delete is a significant liability.
Shops that install deletes also face legal risk. The EPA and state environmental agencies have conducted enforcement actions against diesel shops, resulting in fines and closure orders. Many reputable diesel shops will not perform delete work for this reason.
Alternatives to a full delete
If you want to address DPF and EGR problems without a full delete, some owners pursue partial solutions. A DPF delete only (leaving the EGR in place) is less common but reduces some of the backpressure while keeping one emissions system functional. This is still illegal but may feel like a middle ground.
Another option is to replace the factory DPF with a high-flow aftermarket unit that clogs less frequently. These are legal if they maintain emissions compliance, though they cost $1,500 to $2,500 and still require regeneration cycles.
For the EGR cooler specifically, some owners install an upgraded aftermarket cooler designed to resist corrosion better than the factory unit. This does not address the backpressure issue but can extend the life of the cooler and reduce the risk of failure.
Frequently Asked Questions
Will a delete kit damage my engine?
A properly installed delete kit with a quality tune will not damage the engine. The 6.7 Powerstroke is a robust engine and runs fine without the DPF and EGR. However, a poorly tuned delete or one installed by an inexperienced shop can cause issues like excessive soot buildup, turbo damage, or fuel system problems. Choose a reputable diesel shop with experience on 6.7 Powerstrokes.
Can I pass emissions testing with a delete?
No. A deleted truck will fail any emissions test because it produces higher NOx and particulate emissions than the legal limit. If your state tests vehicles annually or at registration renewal, a delete makes your truck unregisterable. Some rural areas do not test, but you cannot know in advance whether you will move or whether testing will expand in your area.
How much horsepower does a delete add?
A delete kit alone adds 20 to 40 horsepower by reducing backpressure. Combined with a tune, total gains are typically 50 to 80 horsepower, bringing a stock 6.7 from around 440 hp to 500+ hp. Gains vary depending on the tune and whether other modifications (like a turbo upgrade) are also done.
What if I only delete the DPF and keep the EGR?
A DPF-only delete is less common but possible. It removes the regeneration cycles and some backpressure while keeping the EGR system in place. This is still illegal and will still trigger a check engine light without a tune. It does not solve EGR cooler failure risk. Most shops offer full deletes because the labor cost is similar and the performance gain is greater.
Can I reverse a delete if I need to sell the truck?
Yes, but it is expensive and time-consuming. You will need to source a used or new DPF and EGR system, have them installed, and have the ECM re-tuned to stock. Total cost is typically $1,500 to $3,000. If you think you might sell within a few years, factor this into your decision to delete.