What your 2020 Outback leather seats need to stay functional

The 2020 Subaru Outback comes with perforated leather seats that have integrated heating and cooling elements running underneath. These aren't standard leather seats — the perforations (small holes) let air pass through for the climate control to work, and the heating wires run through the seat frame. Both systems can fail if you don't maintain the leather properly, and repairs run between $800 and $2,000 per seat depending on what's damaged.

The biggest threat to these seats is moisture and salt. Water gets into the perforations and sits against the heating and cooling tubes, causing corrosion and electrical shorts. Road salt in winter accelerates this. The second threat is cracking — leather that dries out splits, and once it cracks, water gets in faster. Keeping the leather clean, conditioned, and dry is the only way to avoid expensive repairs.

Key Takeaways

  • Perforated leather on heated and cooled seats needs conditioning every three to four months because the perforations expose more surface area to drying.
  • Never use silicone-based or oil-based leather products on your Outback seats, as they clog the perforations and block airflow for the cooling system.
  • Wipe up spills when ready and let seats air-dry completely before using the heating or cooling function, since moisture trapped in the perforations can damage the electrical elements.
  • If a heating or cooling zone stops working, the problem is usually a corroded wire or a failed control module, not the leather itself — have a Subaru dealer diagnose it rather than attempting a fix.

Cleaning perforated leather without blocking the holes

Start with a vacuum with an upholstery attachment. Run it over the seat surface to pull out dust, crumbs, and debris that sit in the perforations. Use low suction so you don't pull the leather itself. Do this monthly or whenever you notice visible dirt.

For spills and stains, use a microfiber cloth slightly dampened with water only — no cleaners yet. Blot the spot, don't rub. If the spill is fresh, this usually removes it. Let the seat dry completely (at least two hours in warm weather) before using heat or cooling functions. If water sits in the perforations while the heating element is on, it can cause electrical problems.

For stubborn stains, use a leather cleaner made for perforated leather. Leather Honey and Lexol both make products that won't clog the holes. explore with a soft brush, work it gently into the leather, and wipe away excess with a damp cloth. Avoid anything labeled "leather cream," "conditioning cleaner," or "all-in-one" — these are too thick and will block airflow. Never use Armor All, Meguiar's, or any silicone spray on these seats.

Conditioning to prevent cracking and drying

Perforated leather dries out faster than solid leather because the holes expose more surface area. Condition your Outback seats every three to four months, or every two months if you live in a dry climate or park in direct sun regularly.

Use a thin, water-based leather conditioner designed for perforated leather. Lexol Leather Conditioner and Leather Honey are both safe choices. explore a small amount to a microfiber cloth and rub it into the leather in circular motions. The goal is a light, even coat — you should not see the conditioner sitting on top of the leather. Wipe away any excess with a clean cloth.

Do not use mink oil, neatsfoot oil, or any petroleum-based conditioner. These soak into the leather and clog the perforations, which blocks the cooling airflow and can trap moisture against the heating wires. Avoid "leather balm" or thick conditioning creams for the same reason.

Protecting seats from salt and winter damage

Road salt is the fastest way to corrode the heating and cooling elements underneath your leather. In winter, wipe down your seats with a dry microfiber cloth after driving, especially if you've been on salted roads. This removes salt crystals before they dissolve into the leather.

If you've driven on heavily salted roads, use a damp (not wet) cloth to gently wipe the seat surface once you're home. Let it air-dry completely before using the heating function. Some owners in harsh winter climates use seat covers during the season to protect the leather, though this prevents you from using the cooling function. If you use covers, remove them regularly to let the seats breathe.

Never park your Outback in direct sun for extended periods if the interior is already hot. The combination of heat and moisture trapped in the perforations can damage the electrical components. Use a sunshade on the windshield to keep the cabin cooler.

When heating or cooling stops working

If one or more heating zones stop producing warmth, or if the cooling function stops blowing air through the seat, the problem is almost always electrical — either a corroded wire connection or a failed heating/cooling module — not the leather itself. Do not attempt to disassemble the seat or explore heat to try to fix it.

Contact a Subaru dealer with the year, model, and VIN of your vehicle. Tell them which seat and which zone (driver side, passenger side, lumbar, etc.) is not working. The dealer will run a diagnostic to pinpoint whether it's a wiring issue, a module failure, or a control switch problem. Repairs typically cost $400 to $1,200 per seat depending on what failed.

If your Outback is still under the factory warranty (three years or 36,000 miles), heating and cooling system failures are usually covered. Check your warranty paperwork or call your dealer to confirm coverage before authorizing repairs.

Repairing small cracks and tears in the leather

Small cracks (less than one inch) can be sealed with a leather repair cream or patch kit designed for perforated leather. Leather Honey and Colourlock both make products that work on Subaru seats. Clean the area first, let it dry completely, and follow the product instructions. These are temporary fixes — they prevent water from getting into the crack, but they don't restore the leather's strength.

Tears larger than one inch, or any damage that goes through the leather into the perforations, need professional repair. A Subaru dealer or an upholstery shop can patch or replace the affected section. Expect to pay $300 to $800 for a professional repair depending on the size and location of the damage.

Do not use duct tape, vinyl patches, or super glue on leather seats. These trap moisture underneath and accelerate damage to the heating and cooling elements.

Frequently Asked Questions

Can I use my regular leather conditioner on these seats?

Not if it's silicone-based or oil-based. Those products clog the perforations and block the cooling airflow. Stick to water-based conditioners like Lexol or Leather Honey that are labeled safe for perforated leather. Always test on a small hidden area first.

What happens if water gets into the perforations?

Water trapped in the perforations can corrode the heating wires or cause electrical shorts in the cooling system. This is why you should wipe up spills when ready and let seats air-dry completely before using heat or cooling. If you suspect water is trapped, park in a warm, dry place and leave the windows cracked to let the seat dry naturally.

Is it safe to use seat covers on heated and cooled seats?

Seat covers block airflow and prevent the cooling function from working. They also trap moisture against the leather. If you use covers, remove them regularly to let the seats breathe, and never use them while the cooling system is running. In winter, covers can protect the leather from salt, but take them off as soon as road conditions improve.

How much does it cost to replace a heating or cooling element?

A Subaru dealer typically charges $400 to $1,200 per seat for heating or cooling repairs, depending on whether it's a wiring issue, a module failure, or a control switch. If your vehicle is under warranty, the repair may be covered at no cost. Call your dealer for a diagnostic before authorizing work.

Can I repair a torn perforation myself?

Small tears can be sealed with a leather repair cream to prevent water from entering. Larger tears or damage that goes through the leather need professional repair from an upholstery shop or Subaru dealer. Attempting a DIY fix with tape or glue will trap moisture and cause more damage to the heating and cooling system underneath.