Car key batteries typically last three to four years, but the exact lifespan depends on how often you use the key and which type of battery it holds
Most modern car keys contain a small coin-cell battery — usually CR2032, CR2025, or similar — that powers the remote lock and unlock buttons. When the battery dies, the buttons stop working, but your key's physical blade still opens the door and starts the car if you insert it into the ignition. Replacing the battery is a task you can do yourself in under five minutes with no special tools, or you can have a dealer or locksmith do it for $10 to $50.
The first sign of a dying battery is usually that you have to press the buttons harder or multiple times before the car responds. The range shrinks — you have to stand closer to the car. Eventually the buttons stop working entirely. At that point, the battery is dead and needs replacement.
Key Takeaways
- Most car key batteries cost $3 to $8 and are available at pharmacies, supermarkets, and hardware stores under names like CR2032 or CR2025.
- You can open most key fobs by prying gently at the seam with a coin or flat tool, though some keys have a small screw you must remove first.
- Note which side of the battery faces outward before you remove it, because the new battery must go in the same way or the buttons will not work.
- If replacing the battery does not restore the buttons, the fob itself may be damaged and will need repair or replacement by a dealer or locksmith.
Finding the right battery type for your key
The battery type is usually printed on the inside of your key fob or on the old battery itself. Common types are CR2032 (the most frequent), CR2025, CR2016, and LR44. If you cannot find the type printed anywhere, you can open the fob and look at the battery directly, or call your car's dealer with your vehicle identification number (VIN) and they will tell you which battery your key uses.
Once you know the type, you can buy the battery at a pharmacy, grocery store, hardware store, or online. A single battery usually costs $3 to $8. Buy one or two extras — they are inexpensive and last for years in storage. Do not buy used or old-stock batteries; the manufacturing date matters for battery life.
Opening the key fob safely
Most key fobs open by prying gently at the seam where the two halves meet. Use a coin, a plastic spoon, a butter knife, or a plastic pry tool — anything flat and not sharp. Insert the tool into the seam and twist gently; the two halves will separate. Some fobs have a small screw on the back or side that you must remove with a screwdriver before the halves will come apart. Check for a screw first.
Work slowly and gently. If you force it, you can crack the plastic or damage the circuit board inside. The fob is designed to come apart this way, so if it is not opening, you are probably using the wrong seam or there is a screw you missed. Once the halves separate, the battery will usually be sitting loose inside, held in place by a small metal clip or spring.
Removing and replacing the battery
Before you take the old battery out, look at which side is facing up — the side with the + symbol or the flat side. The new battery must go in the same way. If you put it in backwards, the buttons will not work and you will have to open the fob again and flip it.
Gently lift or slide the old battery out from under the clip or spring. Drop the new battery in, making sure the same side faces the same direction as the old one did. The battery should sit flat and the clip should hold it in place without forcing. If the clip is too tight or too loose, the battery may not make contact with the circuit board and the buttons will not work.
Closing the fob and testing the buttons
Once the battery is in place, press the two halves of the fob back together. You should hear or feel a small click when they snap together. If there is a screw, replace it now. Test the lock and unlock buttons from a few feet away from your car. The buttons should respond when ready and the car should lock and unlock normally.
If the buttons still do not work after you have replaced the battery, the problem is likely not the battery. The circuit board may be damaged, the buttons may be worn out, or the battery contacts may be corroded. In that case, you will need to have the fob repaired or replaced by your car's dealer or a locksmith.
When to replace the whole fob instead
If your key fob is old, has been dropped or exposed to water, or has buttons that stick or do not respond even with a new battery, replacement may be cheaper than repair. A new fob from a dealer typically costs $200 to $500 and requires programming to your car. A replacement from a locksmith or online retailer may cost $50 to $150 but still requires programming, which usually runs $50 to $100 at a dealer or locksmith.
Some newer cars allow you to program a new fob yourself using a sequence of key turns and button presses — your owner's manual or dealer can tell you if yours does. If your fob is under warranty, contact your dealer before buying a replacement; they may cover the cost.
Frequently Asked Questions
Can I use a different battery type if I cannot find the exact one?
No. Different battery types have different voltages and sizes. Using the wrong type can damage the circuit board or cause the buttons to work poorly. Stick with the type specified for your key. If you cannot find it locally, order it online — it will arrive within a few days.
What should I do if the battery is stuck and I cannot remove it?
Do not force it. The battery may be corroded to the clip or the clip may be bent. Try gently rocking the battery side to side while lifting, or use a plastic tool to carefully pry the clip up slightly. If it still will not budge, a locksmith or dealer can remove it without damaging the fob.
How do I know if my key fob battery is dying versus the fob being broken?
A dying battery makes the buttons less responsive or require you to stand closer to the car. A broken fob usually means the buttons do not work at all, even when pressed hard, or they work inconsistently. Replace the battery first — it is cheap and fast. If the buttons still do not work, the fob itself needs repair.
Can I replace the battery in a key fob that is waterproof or sealed?
Some newer fobs are sealed and not designed to be opened by the owner. Check your owner's manual or call your dealer. If your fob is sealed, you will need a dealer or locksmith to replace the battery, which usually costs $20 to $50 in labor plus the battery cost.
Will replacing the battery erase my car's settings or require reprogramming?
No. Replacing the battery does not affect your car's memory or the fob's programming. The fob will work exactly as it did before once the new battery is installed. You do not need to reprogram anything.