Check your oil with the engine off, on level ground, at least five minutes after you last drove
You should always check your oil with the engine off. Wait at least five minutes after driving so the oil has time to drain back down into the pan. If you check while the engine is running or when ready after shutting it off, the oil is still circulating through the engine and sitting in passages where you can't see it. Your reading will be too low and you might think you need oil when you don't.
Park on level ground before you check. A slope tilts the oil in the pan and gives you a false reading—either higher or lower depending which way the car is tilted. This matters because the difference between "you're fine" and "you need to add oil now" is often just a quart, and a slope can hide that.
Key Takeaways
- Turn off the engine and wait at least five minutes for oil to settle back into the pan before you look at the dipstick.
- Park on flat, level ground; checking on a slope gives you a reading that is too high or too low.
- Pull the dipstick all the way out, wipe it clean on a rag, reinsert it fully, then pull it out again to read the true level.
- The oil level should sit between the minimum and maximum marks on the stick; if it is below minimum, add the oil type your owner's manual specifies.
- Checking oil takes two minutes and costs nothing, but running low on oil can cause engine damage that costs thousands to repair.
Why the engine must be off and cooled
When your engine runs, the oil pump forces oil through galleries and passages in the engine block, cylinder head, and valve train. Some of that oil is always in motion—coating bearings, cooling pistons, lubricating valve stems. The rest collects in the pan at the bottom. If you check the dipstick while the engine is running or within a few minutes of shutting it off, you are measuring only the oil that has drained back so far, not the total amount in the system.
Heat also affects the reading. Hot oil expands and takes up more space. If you check when ready after driving, the oil is hot and expanded, so the level looks higher than it actually is. Once it cools, it contracts and the real level becomes visible. This is why mechanics and car makers specify waiting at least five minutes—that is roughly how long it takes for most of the circulating oil to drain back and for the temperature to drop enough that expansion is no longer throwing off your measurement.
How to read the dipstick correctly
Pull the dipstick all the way out of its tube. You will see two marks on the stick—usually a minimum line (often labeled "MIN" or shown as a small hole) and a maximum line (labeled "MAX" or "FULL"). The space between them is the safe operating range. Wipe the dipstick clean with a lint-free rag or paper towel so you can see where the oil actually sits on the stick.
Reinsert the dipstick all the way into its tube until it seats fully. Then pull it straight out again and look at where the oil level touches the stick. The oil should wet the stick somewhere between the two marks. If the level is below the minimum mark, you need to add oil. If it is above the maximum mark, you have overfilled the engine, which can damage seals and cause leaks.
Do not rely on a single check. Oil levels can shift slightly depending on how the car is parked or how recently it was driven. If you get a reading that seems off, park on a different level spot, wait another minute or two, and check again. Consistency across two or three checks tells you the real level.
What to do if the oil level is low
Open your owner's manual and find the oil type your engine requires. It will be listed as something like "5W-30" or "10W-40"—the numbers refer to how the oil flows at different temperatures. Using the wrong viscosity can affect engine protection and fuel economy. Buy the correct type and the correct quantity. Most engines take between 4 and 6 quarts, but your manual will tell you exactly.
Locate the oil filler cap on top of the engine—it usually has an oil can symbol on it. Unscrew it and set it aside where you won't lose it. Pour the oil slowly into the opening, checking the level with the dipstick every half-quart or so. It is easier to add a little more oil than to remove oil you have added by mistake. Once the level reaches the maximum mark, replace the cap and close it firmly.
If your oil level drops noticeably between checks—say, a quart or more every few hundred miles—you have a leak or the engine is burning oil. Both are problems that need attention. A slow leak might be a loose drain plug or a worn gasket. Burning oil usually means the engine is older or has high mileage and the piston rings are worn. Either way, have a mechanic look at it before the problem gets worse.
Why checking oil matters for engine life
Oil does three critical jobs: it lubricates moving parts so they do not grind against each other, it carries heat away from the combustion chamber, and it suspends dirt and debris so they do not settle and form sludge. When the oil level drops below the minimum mark, the pump can start to suck air along with oil, which breaks the film of lubrication on the bearings. Metal-to-metal contact follows, and bearing wear accelerates. Once bearings are damaged, the only fix is an engine rebuild or replacement—a cost that runs into thousands of dollars.
Low oil also means less cooling capacity. The oil circulates through passages in the engine block and absorbs heat that would otherwise cook the metal. Without enough oil, hot spots develop and can warp cylinder heads or crack the block. Running low on oil for even a short time can shorten engine life by years.
Checking oil takes two minutes and costs nothing. It is one of the few maintenance tasks you can do yourself without tools or special knowledge, and it is one of the most effective ways to catch problems before they become expensive.
How often to check your oil
Check your oil at least once a month, and always before a long trip. If your car is older, has high mileage, or burns oil, check it every two weeks or before every fill-up at the gas station. Some newer cars with synthetic oil and sealed systems may go longer between checks, but your owner's manual will specify the interval for your vehicle.
Pay attention to warning signs. If your dashboard oil pressure light comes on while you are driving, pull over safely and turn off the engine when ready. Do not drive further until you have checked the oil level and topped it off if needed. That light means oil pressure has dropped, which can happen if the level is low or if the pump is failing. Ignoring it risks catastrophic engine damage.
Frequently Asked Questions
Can I check the oil while the engine is warm but not hot?
Warm oil is still expanded and circulating. Wait at least five minutes after you shut the engine off so the oil cools and drains back into the pan. If you are in a hurry, checking a warm engine is better than not checking at all, but you will get a reading that is higher than the true level. For accuracy, always wait and check on a cold engine.
What if my car does not have a traditional dipstick?
Some newer cars have electronic oil level sensors instead of a dipstick. The level displays on the dashboard or infotainment screen. Check your owner's manual for the exact procedure—you may need to turn the ignition on without starting the engine, or navigate a menu. The same rule applies: check on level ground with the engine off.
Is it bad to overfill the oil?
Yes. Too much oil increases pressure in the crankcase and can force oil past seals and gaskets, causing leaks. Excess oil can also foam, which breaks down its ability to lubricate. If you overfill, you need to drain the extra out. Use a turkey baster or a small pump to remove oil until the level sits at the maximum mark.
How do I know if my engine is burning oil?
If the oil level drops noticeably between oil changes—more than a quart every 1,000 miles—the engine is burning oil. You may also see blue smoke from the exhaust or smell burning oil. This usually means the piston rings or valve seals are worn. Have a mechanic inspect the engine to confirm and discuss repair options.
What happens if I drive with the oil pressure light on?
The oil pressure light means the pump is not delivering enough oil to the engine. Continuing to drive risks bearing damage and engine seizure. Pull over when ready, turn off the engine, and check the oil level. If it is low, add oil and see if the light goes off. If the light stays on after you have topped off the oil, do not drive the car—have it towed to a mechanic.