Your Dodge Charger key fob runs on a coin-cell battery that typically lasts three to four years

The battery inside your Dodge Charger key fob is a small, flat, round cell—usually a CR2032 or CR2025 depending on your model year. When it dies, the fob stops sending the signal that locks and unlocks your doors or opens your trunk. You'll notice the range shrinking first: you have to stand closer to the car for the buttons to work. Then one day the fob stops responding altogether.

Replacing it takes about five minutes and costs between $3 and $8 for the battery itself. You do not need a dealer or a technician. The fob is designed to open from the side, and the battery slides out and in. This is one of the few car maintenance tasks that genuinely is as straightforward as it sounds.

Key Takeaways

  • Dodge Charger key fobs use a CR2032 or CR2025 coin-cell battery that you can buy at any pharmacy, grocery store, or hardware store for a few dollars.
  • The fob opens by sliding a small metal lever or button on the side; the battery sits in a metal holder and slides straight out.
  • When you install the new battery, the metal side (marked with a + or −) must face the correct direction—check the holder or your owner's manual if you are unsure.
  • If the fob still does not work after you replace the battery, the problem is likely a broken button contact or water damage inside the fob, not the battery itself.

How to open your Dodge Charger key fob

Look at the seam running around the edge of your fob. On most Charger models, you will see a small slot or notch on one side. Insert a flat tool—a coin, a flathead screwdriver, or a plastic pry tool—into that slot and gently twist or lever it to separate the two halves of the fob. Do not force it; if it does not move, you may be working on the wrong seam.

Some Charger fobs have a small button or lever on the side instead of a slot. Press or slide that button, and the fob will pop open. Once the two halves are apart, you will see the battery sitting in a metal holder. It looks like a small silver coin. The holder has a lip or tab that you can use to pry the battery out, or you can straightforward slide it out with your fingernail.

Identifying the correct battery type for your model

The most common battery in a Dodge Charger key fob is the CR2032. This is a 3-volt lithium coin cell that is 20 millimeters across and 3.2 millimeters thick. You will find it at any pharmacy, supermarket, or auto parts store, often in the watch battery or electronics section. A pack of two or four costs between $3 and $8.

Some older Charger models use a CR2025, which is the same diameter but slightly thinner. The easiest way to know which one you need is to look at the battery that just came out of your fob—the type is printed on the flat side. If you cannot read it, check your owner's manual or call a Dodge dealer with your vehicle's year and model. Do not guess; putting the wrong battery in will not damage the fob, but it may not work reliably.

Installing the new battery correctly

Before you put the new battery in, look at the metal holder inside the fob. You will see a + symbol on one side and a − symbol on the other. The battery itself has a flat side (marked +) and a slightly domed side (marked −). The flat side must face the + side of the holder. If you install it backwards, the fob will not work, but you can straightforward flip it and try again—it will not hurt anything.

Slide the new battery into the holder with the correct side facing up. It should sit flat and snug. Now close the two halves of the fob back together. You may hear a small click as they snap into place. Press each button on the fob a few times to make sure it is working. Stand a few feet from your Charger and try locking and unlocking the doors. If the fob responds, you are done.

What to do if the fob still does not work after replacing the battery

If you installed a fresh battery and the fob still does not respond, the problem is not the battery. The most common cause is a worn or corroded button contact inside the fob. Each button sits on a rubber pad with a conductive material on the bottom. Over time, that material wears away or gets dirty, and the button no longer completes the electrical circuit. You can sometimes fix this by gently rubbing the conductive pad with a pencil eraser or a cotton swab dampened with rubbing alcohol, then letting it dry completely before reassembling.

Water damage is another possibility, especially if your fob has been dropped in water or exposed to heavy moisture. If you see corrosion, discoloration, or moisture inside the fob, the circuit board may be damaged beyond a straightforward fix. In that case, you will need a replacement fob. A Dodge dealer can order one, or you can find aftermarket fobs online that work with your Charger's year and model. Prices range widely depending on whether you want a basic fob or one with extra features.

How often you should expect to replace the battery

A CR2032 battery in a key fob typically lasts three to four years under normal use. If you use your fob heavily—pressing the buttons many times a day—the battery may wear out sooner. If you use it lightly, it may last longer. The battery does not "run down" like a rechargeable battery; it straightforward reaches the end of its chemical life and stops producing voltage.

You cannot recharge a coin-cell battery, and there is no way to extend its life once it starts to fail. The moment you notice the fob not responding from your usual distance, replace the battery. Waiting until it stops working completely means you will be stuck without remote access to your car until you can get to a store and buy a new battery.

Where to buy a replacement battery

CR2032 and CR2025 batteries are among the most common batteries in the world. You can find them at pharmacies (CVS, Walgreens), grocery stores (most have a pharmacy or electronics section), hardware stores (Home Depot, Lowe's), auto parts stores (AutoZone, O'Reilly), and online retailers (Amazon). Some dollar stores carry them as well. Prices are similar everywhere—usually $3 to $8 for a pack of two or four.

Buy a name-brand battery if you can: Energizer, Duracell, Panasonic, or Sony. Off-brand batteries are cheaper but may not last as long or perform as reliably. Since you are only replacing it every few years, spending an extra dollar or two for a reliable battery is worth it.

Frequently Asked Questions

Can I use a rechargeable coin-cell battery in my key fob?

Rechargeable coin cells exist, but they are not recommended for key fobs. They have a lower voltage than disposable batteries and may not provide enough power to send a strong signal. Stick with a standard CR2032 or CR2025 disposable battery.

What happens if I put the battery in backwards?

Nothing will break. The fob straightforward will not work. When you realize it is not responding, open the fob again and flip the battery so the flat side faces the + symbol. It will work fine after that.

Do I need to reprogram my key fob after changing the battery?

No. The battery change does not erase any programming. Your fob will work exactly as it did before, as long as the new battery is installed correctly and the fob itself is not damaged.

How do I know if my fob battery is dying versus the fob being broken?

A dying battery shows up as a shrinking range first—you have to stand closer to the car for the buttons to work. If the fob works fine from normal distance one day and stops working completely the next, the battery is likely dead. If the fob never works from any distance, or if some buttons work and others do not, the problem is probably inside the fob, not the battery.

Can I buy a universal key fob instead of replacing the battery?

Yes, but a universal fob will not have the same buttons or features as your original Dodge fob. A replacement fob programmed specifically for your Charger is more reliable. A Dodge dealer can order one, or you can find model-specific aftermarket fobs online.