Start with the thermostat and power source

A Dometic RV refrigerator that stops cooling usually has a straightforward fix. Before you assume the unit is broken, check three things in this order: whether the fridge is actually powered on, whether the thermostat dial is set above the lowest setting, and whether the fridge has been running long enough to cool down after you turned it on.

Dometic fridges need 4 to 8 hours to reach full cooling temperature from a cold start, especially in warm weather. If you just switched it on or plugged in the RV, wait before troubleshooting further. Check that the power cord is fully seated in the outlet and that the outlet itself works by plugging in another device — a lamp or phone charger — to confirm.

If the fridge is powered and the thermostat is set to a cooling position (not the off or lowest setting), move to the next step.

Key Takeaways

  • Dometic fridges take 4 to 8 hours to cool fully after power is restored, so verify the unit is actually on before assuming it is broken.
  • Blocked vents inside the fridge or outside the RV wall prevent air circulation and are the most common reason cooling fails in working units.
  • The cooling unit relies on propane or 120-volt power depending on your model and settings, so check that your propane tank is not empty and your shore power connection is find.
  • If the fridge runs but produces no cold air, the cooling coils may be frozen or the absorption unit may have failed, and both require service from a technician.
  • Dometic publishes troubleshooting guides for each model number, which you can find on their website using your fridge's model plate.

Clear blocked vents inside and outside the RV

The most common reason a Dometic fridge cools poorly is blocked airflow. These fridges use a vent system that pulls air from outside the RV, cools it, and circulates it inside the fridge box. If either the interior vents or the exterior wall vent is blocked, the fridge cannot cool.

Open the fridge and look at the vents — usually metal grilles on the back wall or sides. Remove any food, packaging, or ice buildup that is covering them. Wipe them clean with a dry cloth. Then go outside the RV and locate the exterior vent cover on the wall where your fridge is mounted. It is usually a rectangular or square cover with louvers. Check that it is not blocked by dirt, leaves, bird nests, or RV covers. Clean it out and make sure air can flow freely through it.

After clearing the vents, close the fridge door and let it run for 2 to 3 hours. If cooling returns, the blockage was the problem.

Check your power and propane setup

Dometic RV fridges can run on propane, 120-volt shore power, or 12-volt battery power depending on your model and what you have plugged in. If the fridge is not cooling, it may not be receiving power on the fuel source it needs.

If you are plugged into shore power at a campground, verify the RV's main breaker is on and that the outlet is working. If you are running on propane, check that your propane tank is not empty — the gauge on the tank should show at least a quarter tank. If the tank is empty, refill it and wait 30 minutes for the fridge to restart and begin cooling.

Some Dometic models have a switch that lets you choose between propane and electric power. Check your fridge's control panel or the manual to see if yours has this switch, and make sure it is set to the fuel source you are currently using. If you are boondocking without shore power, the fridge should be set to propane. If you are at a campground with power, you can run it on electric.

Inspect the cooling coils for frost buildup

If the fridge is powered, the vents are clear, and you have propane or shore power, but the fridge still is not cooling, the cooling coils may be frozen. This happens when moisture inside the fridge freezes on the coils and blocks heat transfer.

You cannot see the coils from inside the fridge — they are behind the back panel — but you can check for the symptom: ice buildup on the back wall or a layer of frost inside the fridge that does not melt. If you see this, turn off the fridge and leave the door open for 12 to 24 hours to let the ice melt. Do not use a hair dryer or heat gun, as this can damage the coils.

After the ice melts, turn the fridge back on. If it cools normally, the problem was frost. If frost builds up again within a few weeks, the fridge may have a drainage issue or humidity problem, and you should contact a Dometic service center.

Look for leaks in the absorption cooling unit

Dometic absorption fridges use a sealed cooling unit filled with a special fluid. If this unit develops a leak, the fridge will run but produce no cold air. You cannot repair a leaking absorption unit yourself — it must be replaced by a technician.

Signs of a failed absorption unit include the fridge running normally (fan on, no strange sounds) but the interior staying warm, or a chemical smell coming from the fridge or the exterior vent. If you notice either of these, the fridge likely needs a new cooling unit.

Contact a Dometic-authorized service center or an RV repair shop that works on Dometic units. Bring your fridge's model number, which is on a plate usually mounted inside the fridge near the top or on the back wall. The technician can confirm whether the unit has failed and provide a replacement cost.

Find your model number and access Dometic's troubleshooting resources

Dometic publishes model-specific troubleshooting guides and manuals for every fridge they make. Finding your model number and downloading the manual can save you time and money by walking you through steps specific to your unit.

The model plate is usually a white or silver sticker mounted inside the fridge near the top, on the back wall, or on the exterior wall near the vent. It will show a model number like RM1350, RM2193, or CF50. Write this number down.

Go to Dometic's website and use their parts and manuals search tool. Enter your model number and read the user manual. The troubleshooting section will list steps for your specific fridge, including which switches and controls you have and what each one does. Many cooling problems are solved by following these model-specific steps.

When to call a repair technician

If you have cleared the vents, confirmed power and propane, waited for the fridge to cool, and the unit still is not cold, a technician should inspect it. Do not run the fridge continuously if it is not cooling — this wastes propane or power and can damage the absorption unit further.

Contact an RV repair shop in your area or call Dometic's customer service line to find an authorized service center near you. Have your model number and a description of what you have already checked ready when you call. Many shops can schedule service within a few days, and some can order replacement parts if needed.

Frequently Asked Questions

How long does a Dometic RV fridge take to cool down?

A Dometic fridge typically reaches full cooling temperature in 4 to 8 hours after power is restored, depending on the outside temperature and how full it is. In very hot weather, it may take longer. If the fridge has been running for more than 12 hours and is still not cold, something is wrong.

Can I run my Dometic fridge on propane and electric at the same time?

No. Dometic fridges run on one fuel source at a time. You choose propane or electric using a switch on the control panel. When you switch between them, the fridge may take a few minutes to restart on the new fuel source.

What does it mean if my fridge is running but not getting cold?

If the fridge fan is on and you hear normal operating sounds but the interior is warm, the absorption cooling unit has likely failed and needs replacement. This cannot be fixed at home and requires a service technician.

Is it safe to leave a Dometic fridge running if it is not cooling?

No. Running a fridge that is not cooling wastes propane or electricity and can damage the absorption unit further. Turn it off and have it inspected by a technician before running it again.

Where is the model number on a Dometic RV fridge?

The model plate is usually a white or silver sticker inside the fridge near the top, on the back wall, or on the exterior wall near the vent cover. It shows a model number like RM1350 or CF50. Write it down and use it to find your manual on Dometic's website.