What an electric RV heater does and when you need one

An electric heater for an RV supplements or replaces your vehicle's built-in heating system, running off either your RV's battery bank, a generator, or shore power when you're parked at a campground. Most RVs come with a furnace that burns propane, which works well but costs money to refill and can be unreliable in very cold weather. An electric heater lets you heat without propane, though it draws significant power — typically 750 to 1500 watts — so your electrical setup has to support it.

You need an electric heater if you camp in cold climates where propane alone doesn't keep up, if you want to reduce propane use and its cost, or if your furnace has failed and you need heat now. Some RV owners use electric heaters as a primary heat source in mild climates where a small unit covers their needs. Others use them as backup when the furnace isn't working or when they're parked at a site with shore power available.

Key Takeaways

  • Electric heaters for RVs range from 750 to 1500 watts and require either a generator, shore power, or a large battery bank to run without draining your batteries in hours.
  • Portable ceramic and fan-forced heaters are cheapest and easiest to install, while built-in units require running new wiring and may need a dedicated 20-amp circuit.
  • Shore power (30-amp or 50-amp service at a campground) is the most practical way to run an electric heater continuously without depleting your battery.
  • Your RV's electrical panel and wiring must handle the heater's amperage draw, or you risk tripping breakers, overheating wires, and potential fire hazard.
  • Electric heaters cost between $50 and $400 depending on type and power output, plus installation labor if you hire a technician.

Portable versus built-in electric heaters

A portable ceramic or fan heater plugs into any 120-volt outlet in your RV and costs $50 to $150. These units are lightweight, move from room to room, and need no installation. The trade-off is that they draw 750 to 1500 watts continuously, which will drain a battery bank in 4 to 8 hours if you're not plugged into shore power or running a generator. Portable heaters work well for short trips, mild climates, or as a backup when you have shore power available.

A built-in electric heater is permanently wired into your RV's electrical system and costs $200 to $400 plus installation labor. These units are usually mounted in a cabinet or under a cabinet and can be thermostat-controlled. Built-in heaters require running new wiring from your electrical panel, installing a dedicated breaker (usually 20 amps), and sometimes upgrading your panel if it's already at capacity. Installation typically takes 4 to 8 hours and costs $300 to $800 in labor, depending on how accessible your panel is and how far the wiring needs to run.

Choose a portable heater if you camp mostly at sites with shore power or use your RV for short trips. Choose a built-in heater if you want permanent, thermostat-controlled heating and camp frequently in cold weather.

Power requirements and electrical safety

An electric heater on high draws 1500 watts, which equals 12.5 amps at 120 volts. Your RV's electrical system must have a breaker and wiring rated for that load. Most RVs have a 30-amp main service, which means your total load across all circuits cannot exceed 30 amps continuously. If your heater draws 12.5 amps and you're also running lights, a refrigerator, and other appliances, you'll trip the main breaker or overload individual circuits.

Shore power solves this problem: a 30-amp or 50-amp pedestal at a campground supplies power directly to your RV without drawing from your battery or generator. If you want to run an electric heater off-grid (battery or generator), you need either a large lithium or lead-acid battery bank (at least 400 amp-hours) or a generator rated for 2000 watts or more. A typical RV battery bank of 100 to 200 amp-hours will not sustain a 1500-watt heater for more than a few hours.

Before installing a built-in heater, have an RV electrician inspect your panel to confirm there is available breaker space and that the wiring from the panel to the heater location can handle the amperage. Undersized wiring or an overloaded breaker creates fire risk. If your panel is full, you may need to upgrade to a larger panel, which costs $500 to $1200.

Shore power versus battery and generator operation

Shore power is the most practical way to run an electric heater continuously. When your RV is plugged into a 30-amp or 50-amp pedestal at a campground, the heater draws power directly from the grid, not from your battery or generator. You can run a 1500-watt heater indefinitely without depleting anything. Most modern campgrounds offer 30-amp or 50-amp service, though some older or rustic sites may only have 20-amp outlets.

Running an electric heater off a generator works but is expensive and noisy. A 2000-watt generator burns about 0.5 gallons of fuel per hour at full load, costing $2 to $4 per hour depending on fuel prices. Running the heater 8 hours a night for a week costs $112 to $224 in fuel alone. Generators also require maintenance, produce exhaust, and are loud enough to disturb neighbors at a campground.

Running an electric heater off your RV's battery bank is only practical for short periods. A 200 amp-hour lithium battery bank (the largest practical size for most RVs) stores about 2.4 kilowatt-hours of usable energy. A 1500-watt heater will drain it completely in about 1.5 hours. You would need to recharge the battery with a generator or solar, which brings you back to the cost and hassle of generator operation. For this reason, most RV owners use electric heaters only when shore power is available.

Types of electric heaters and their features

A ceramic fan heater is the most common portable option. It uses a ceramic element to heat air, which a fan blows into the RV. These heaters are compact, inexpensive ($50 to $100), and heat a small space quickly. Most have a thermostat and low/high settings (typically 750 and 1500 watts). The downside is that they can be noisy and dry out the air in your RV.

An oil-filled radiant heater is quieter and slower to heat but maintains warmth longer after it shuts off. These cost $80 to $150 and are good for overnight heating or for people sensitive to fan noise. They take 20 to 30 minutes to reach full heat and are heavier than ceramic heaters, making them less portable.

A built-in forced-air heater is a permanent installation that ties into your RV's existing ductwork or uses its own ducting to distribute heat throughout the RV. These cost $200 to $400 and can be thermostat-controlled. Installation requires running wiring and possibly new ducts, so labor costs are higher. The advantage is that you get whole-RV heating without moving a portable unit around.

A heat pump is an efficient alternative that heats and cools your RV. These cost $1500 to $3000 installed and require 240-volt service or a large generator. Heat pumps are most practical for RVs that spend extended time at sites with 50-amp shore power. They are more efficient than electric resistance heaters but require professional installation.

Installation steps for a portable heater

Installing a portable electric heater takes minutes and requires no tools or electrical knowledge. Unbox the heater, place it on a flat, stable surface away from curtains, bedding, and propane appliances. Plug it into a 120-volt outlet in your RV — do not use an extension cord, as the heater draws too much power and an extension cord can overheat. Turn on the heater and set the thermostat to your desired temperature. Most portable heaters have an automatic shutoff if they tip over, so keep them upright and away from foot traffic.

If you want to run the heater while boondocking (off-grid), you need a generator. Plug the heater into a 120-volt outlet on the generator's output panel, not into your RV's outlets, because your RV's wiring is not designed to handle the heater's load when running off a generator. This requires running a heavy-duty extension cord from the generator to the heater, which is awkward but safe if the cord is rated for the heater's amperage (usually 15 amps minimum).

Installation steps for a built-in heater

Installing a built-in electric heater requires electrical work and is best done by an RV technician. The basic steps are: (1) turn off power at the main breaker, (2) run new 12-gauge or 10-gauge wire (depending on amperage) from the electrical panel to the heater location, (3) install a 20-amp dedicated breaker in the panel, (4) connect the heater to the new wire, (5) test the heater and confirm it does not trip the breaker under load, and (6) seal any holes in the RV's walls or floor where wiring passes through.

The most common mistake is undersizing the wire. A 1500-watt heater at 120 volts draws 12.5 amps, which requires 10-gauge wire if the run is longer than 50 feet, or 12-gauge if shorter. Using 14-gauge wire (common in RVs for lighting circuits) will overheat and create fire risk. If you are not confident in electrical work, hire a technician. The cost of a mistake — a fire or electrocution — far exceeds the labor cost.

Cost comparison and budget planning

Heater TypeUnit CostInstallation CostTotalBest For
Portable ceramic$50–$100$0$50–$100Shore power camping, short trips
Oil-filled radiant$80–$150$0$80–$150Quiet, overnight heating
Built-in forced-air$200–$400$300–$800$500–$1200Frequent cold-weather camping
Heat pump$1500–$3000$500–$1500$2000–$4500Year-round heating and cooling

A portable heater is the lowest-cost entry point and makes sense if you camp mostly in mild climates or at sites with shore power. If you camp frequently in cold weather and want permanent heating, a built-in heater costs more upfront but eliminates the need to move a portable unit and gives you thermostat control. A heat pump is the most expensive option but is the most efficient and provides both heating and cooling.

Budget for ongoing costs as well. If you use a generator to run an electric heater, expect to spend $2 to $4 per hour in fuel. If you use shore power, the cost is included in your campground fee (typically $30 to $60 per night for a 30-amp site). Propane heating costs vary by location and propane prices but typically runs $1 to $3 per gallon, with a furnace using 0.5 to 1 gallon per day in cold weather.

Frequently Asked Questions

Can I run an electric heater and air conditioner at the same time on 30-amp shore power?

No. A 1500-watt heater draws 12.5 amps, and a typical RV air conditioner draws 13 to 15 amps, totaling 25 to 27.5 amps. A 30-amp service has only 30 amps available, leaving almost no room for other appliances. If you run both, you will trip the main breaker. Use the heater in winter and the air conditioner in summer, or upgrade to 50-amp service if your campground offers it.

Will an electric heater work in my RV if I have a small battery bank?

Only for short periods. A 100 amp-hour battery bank stores about 1.2 kilowatt-hours of usable energy. A 1500-watt heater will drain it in less than an hour. If you want to heat off-grid, you need either a large battery bank (400+ amp-hours), a generator, or both. Most RV owners use electric heaters only when plugged into shore power.

Is it safe to leave a portable heater running overnight?

Yes, if it has an automatic shutoff switch (most modern heaters do). Keep it away from curtains, bedding, and propane appliances, and place it on a flat, stable surface. Do not block the heater's air intake or exhaust vents. If your heater does not have an automatic shutoff, turn it off before sleeping.

What size heater do I need for my RV?

A 750-watt heater is adequate for a small RV (under 25 feet) in mild climates. A 1500-watt heater is better for larger RVs or cold climates. If you are unsure, start with a portable 1500-watt heater on low setting and see if it keeps you warm. You can always upgrade to a larger unit or a built-in heater later.

Can I use an electric heater with a generator while boondocking?

Yes, but it is expensive and loud. A 2000-watt generator running a 1500-watt heater for 8 hours per night costs $112 to $224 per week in fuel. Generators also require maintenance and produce exhaust. Most RV owners use electric heaters only when shore power is available and rely on propane or a smaller generator for boondocking.