Most key fob batteries cost $3 to $8 and take five minutes to swap out yourself
You can replace a dead key fob battery without a dealer visit or special tools. The battery itself — usually a coin-cell type like CR2032 or CR2025 — costs a few dollars at any pharmacy, grocery store, or hardware store. The whole job takes a flathead screwdriver (or sometimes just your fingernail) and about five minutes. You do not need to reprogram the fob after changing the battery; it will work the moment you close it back up.
The main variable is how your specific fob opens. Some pop apart with a slot for a flathead screwdriver. Others have a small button or latch you press to slide the case open. A few use a coin to twist a seam. Once you know which type you have, the rest is straightforward.
Key Takeaways
- Coin-cell batteries for key fobs cost $3 to $8 and are sold at pharmacies, grocery stores, and hardware stores without any special ordering.
- You need only a flathead screwdriver or coin to open most fobs; check your owner's manual or search your fob model online if you are unsure how yours opens.
- Note which side of the battery faces up before you remove it, because the new battery must go in the same way or the fob will not work.
- The fob does not need reprogramming after a battery swap — it will work when ready once you close the case.
- If the fob still does not work after a new battery, the problem is likely a worn button contact or internal damage, not the battery itself.
Find out what battery your fob uses
The battery type is usually printed on the inside of the fob case or on the old battery itself. Common types are CR2032, CR2025, and CR2016 — the numbers tell you the size and voltage. If you cannot find it printed anywhere, search online for your car's make, model, and year plus "key fob battery type." You can also take the old battery to a pharmacy or store and match it by sight.
Do not guess the type. Putting the wrong battery in will not damage the fob, but it will not work either. A CR2032 and a CR2025 look nearly identical but have different thicknesses, and the fob case is built for one or the other.
Open the fob case
Look for a seam or slot on the edge of the fob. Most fobs have a thin slot where you can slide a flathead screwdriver to pry the case apart — insert the screwdriver gently and twist slightly, and the case will pop open. Some fobs have a small button or latch on the back that you press to release the case. A few use a coin slot: you insert a coin into a groove and turn it like a screw to unlock the case.
If you cannot see an obvious opening, check your owner's manual or search your fob model on YouTube — someone has almost certainly posted a video of the exact opening method. Forcing a fob that does not want to open can crack the plastic, so take a moment to find the right approach first.
Remove the old battery and note its position
Once the case is open, you will see the battery sitting in a small metal holder or slot. Before you touch it, look at which side is facing up — the flat side or the side with the raised edge. This matters. Take a photo with your phone if you want to be certain.
Gently pry the battery out with your fingernail or the edge of the screwdriver. It should come free with light pressure. If it is stuck, try wiggling it slightly rather than forcing it. Do not touch the flat sides of the new battery with your bare fingers; skin oils can reduce its lifespan.
Insert the new battery the same way
Place the new battery into the holder with the same side facing up as the old one. If the positive side (+) was facing up before, the positive side goes up now. If you are unsure, the raised edge (positive terminal) typically faces up in most fobs, but your photo or the old battery will confirm it.
Press the battery down gently until it sits flat in the holder. You should hear or feel a small click as it settles into place. Do not force it; it should sit snugly but not require pressure to stay down.
Close the fob and test it
Snap or slide the case back together. You may hear a click when the two halves lock. Point the fob at your car and press a button — lock, unlock, or trunk, depending on what your fob does. The car should respond when ready. If it does not, open the fob again and check that the battery is seated properly and facing the right direction.
If the fob still does not work after a second battery swap, the problem is likely worn button contacts inside the fob or internal circuit damage, not the battery. At that point, a replacement fob from the dealer or a third-party supplier is usually the next step.
Where to buy the battery
Coin-cell batteries are stocked at pharmacies (CVS, Walgreens), grocery stores, hardware stores (Home Depot, Lowe's), and big-box retailers (Target, Walmart). They are also sold online through Amazon and eBay. Prices range from $3 to $8 per battery depending on the brand and where you buy. Some stores sell them in multipacks if you want spares on hand.
You do not need a prescription or membership to buy these batteries. Walk into any pharmacy or store, find the battery section (usually near the checkout or in the electronics aisle), and grab the type you need. If you cannot find it, ask a store employee — they can point you to the right shelf or tell you if they stock that type.
Frequently Asked Questions
Do I need to reprogram my key fob after changing the battery?
No. The fob will work the moment you close the case. Reprogramming is only needed if you replace the entire fob with a new one, not when you change the battery inside an existing fob.
What if I put the battery in backwards?
The fob will not work, but it will not be damaged. Open it back up, flip the battery around so the positive side faces the same direction as before, and close it again. It will work when ready.
How long does a key fob battery last?
Most coin-cell batteries last three to four years in a key fob, depending on how often you use it. If you press the buttons dozens of times a day, the battery may wear out sooner. There is no way to predict the exact lifespan, so just replace it when the fob stops responding.
Can I use a rechargeable battery in my key fob?
Rechargeable coin-cell batteries exist, but most key fobs are designed for single-use alkaline batteries. A rechargeable battery may not provide enough voltage or fit properly in the holder. Stick with the standard alkaline type that matches your fob's original battery.
What should I do with the old battery?
Coin-cell batteries can be recycled at most pharmacies and electronics retailers. Many Best Buy locations, for example, have battery recycling bins near the entrance. You can also check Earth911.com or call your local waste management to find a recycling center near you.