New motor costs range from $3,000 to $10,000 installed, depending on your vehicle type and whether you choose a factory engine or a rebuilt one
A new motor is one of the largest repairs you'll face as a vehicle owner. The total cost breaks into two parts: the engine itself and the labor to install it. A brand-new factory engine typically costs $4,000 to $8,000 before installation. Rebuilt engines—which have been disassembled, inspected, and reassembled to factory specifications—run $2,500 to $4,500. Labor adds another $1,000 to $3,000 depending on how accessible your engine is and how long the job takes.
Your actual bill depends on what kind of vehicle you drive. A four-cylinder sedan costs less to replace than a V8 truck or a luxury car with a complex engine bay. Independent mechanics typically charge $80 to $150 per hour; dealerships charge $150 to $250 per hour. A straightforward engine swap on a common vehicle might take 15 to 20 hours. A difficult one can stretch to 30 or 40 hours.
Key Takeaways
- Factory new engines cost $4,000 to $8,000; rebuilt engines cost $2,500 to $4,500; labor adds $1,000 to $3,000 depending on your vehicle and mechanic.
- An independent shop is usually 30 to 50 percent cheaper than a dealership for the same engine replacement work.
- Rebuilt engines come with a warranty—typically 12 months or 12,000 miles—but carry slightly higher failure risk than factory new engines.
- Getting a second estimate before committing saves money; some shops will quote over the phone if you provide your vehicle's year, make, model, and current mileage.
Factory new versus rebuilt engines
A factory new engine comes directly from the manufacturer and has never been installed in a vehicle. It carries the full manufacturer warranty, usually three years or 36,000 miles. You pay the highest price, but you get the lowest risk of early failure. Most dealerships stock factory engines or can order them within a week.
A rebuilt engine has been completely disassembled, cleaned, inspected, and reassembled to factory specifications by a specialist shop. Worn parts like pistons, rings, and bearings are replaced; the block and heads are checked for cracks. Rebuilt engines cost 40 to 50 percent less than factory new. They come with a warranty—typically 12 months or 12,000 miles—but that warranty is shorter and comes from the rebuilder, not the manufacturer. Failure rates are higher than factory new, but most rebuilt engines perform reliably if purchased from a reputable rebuilder.
A third option, used engines, pulls a working engine from a salvage vehicle. These cost $1,500 to $3,000 but usually carry no warranty or a very short one (30 to 90 days). You have no way to know how many miles the engine actually has or how it was maintained. Used engines make sense only if your budget is extremely tight and you accept the risk.
Labor costs and where to get the work done
Independent repair shops charge $80 to $150 per hour for engine replacement labor. Dealerships charge $150 to $250 per hour. A typical engine swap takes 15 to 25 hours on a common vehicle; luxury cars, trucks with complex engine bays, or vehicles with integrated computer systems can take 30 to 40 hours or more.
An independent shop will usually cost you $1,200 to $3,750 in labor. A dealership will cost $2,250 to $10,000 in labor on the same job. The dealership advantage is warranty coverage on their work—typically one year—and access to factory parts. The independent shop advantage is lower cost and often faster turnaround because they're not backed up with warranty recalls.
Before choosing a shop, call three places with your vehicle's year, make, model, and current mileage. Ask for a labor estimate and how long the job typically takes. Ask whether they source their own engines or whether you need to buy one separately. Some shops require you to buy the engine from them; others let you source it yourself and charge only for installation.
Additional costs you may encounter
The engine itself and labor are not the only expenses. Replacing hoses, belts, gaskets, and seals while the engine is out costs $500 to $1,500 depending on the vehicle's age and condition. A new radiator or transmission fluid flush may be recommended and adds $200 to $600. If your vehicle has been sitting or the old engine failed catastrophically, metal debris may have circulated through the cooling system or transmission, requiring a flush or replacement of those systems as well.
Diagnostic work before the engine replacement—to confirm the engine is actually the problem—costs $100 to $300. Some shops include this in the final bill; others charge it separately. If the engine failure damaged other components like the transmission, alternator, or water pump, those repairs stack on top of the engine cost.
When to replace versus repair
A new motor makes financial sense when repair costs exceed 50 to 60 percent of the vehicle's current market value. If your car is worth $8,000 and the engine replacement will cost $5,000, replacement is reasonable. If your car is worth $3,000 and the engine replacement will cost $5,000, you're better off selling the vehicle for parts or scrapping it.
Consider also the vehicle's age and overall condition. A 2015 sedan with 120,000 miles and a failed engine might be worth replacing. A 2008 sedan with 180,000 miles, rust, and transmission problems is probably not. Get a pre-purchase inspection from a trusted mechanic if you're unsure whether the rest of the vehicle is sound.
Warranty coverage on replacement engines
Factory new engines come with the manufacturer's warranty, which typically covers three years or 36,000 miles from the date of installation. This covers defects in materials and workmanship but not damage from neglect, overheating, or contaminated fuel.
Rebuilt engines come with the rebuilder's warranty, which varies widely. Most offer 12 months or 12,000 miles. Some high-end rebuilders offer 24 months or 24,000 miles. Read the warranty document carefully—it should specify what is and is not covered. Most rebuilt engine warranties do not cover labor if the engine fails; you pay for removal and reinstallation separately.
The shop's labor warranty is separate from the engine warranty. A dealership typically warrants their installation work for 12 months. An independent shop may offer 6 to 12 months. Ask this question before you commit: "If the engine fails within warranty, who pays for removal and reinstallation—you or me?"
Getting multiple quotes and negotiating
Call at least three shops and provide the same information to each: your vehicle's year, make, model, engine size, current mileage, and a description of the problem (won't start, knocking noise, overheating, etc.). Ask for a written estimate that breaks out the engine cost, labor cost, and any additional parts or services.
Compare not just the total price but what is included. One shop's $5,500 quote might include a new radiator and hoses; another's $4,800 quote might not. The cheapest option is not always the best if it cuts corners on parts or warranty.
Once you have three estimates, you can negotiate. If one shop is significantly cheaper, ask the others whether they can match it. Some will; others won't. If a shop is significantly more expensive, ask what they're including that the others are not. Sometimes the answer is legitimate (better warranty, OEM parts, faster turnaround); sometimes it's just markup.
Frequently Asked Questions
How long does an engine replacement take?
A typical engine swap takes 15 to 25 hours on a common vehicle. Complex vehicles—luxury cars, trucks with integrated engine computers, or vehicles with tight engine bays—can take 30 to 40 hours. Most shops complete the work within one to two weeks, depending on how busy they are and whether they need to order parts.
Can I drive my car to the shop if the engine is failing?
If the engine won't start, no. If it's running but making noise or overheating, drive it slowly and directly to the shop without stopping. Continued driving on a failing engine can cause additional damage to the transmission, cooling system, or other components, raising your total repair bill.
What's the difference between a crate engine and a rebuilt engine?
A crate engine is a brand-new engine shipped in a crate from the manufacturer, typically used for performance builds or specialty vehicles. It costs more than a rebuilt engine but less than buying one through a dealership. A rebuilt engine is disassembled and reassembled by a specialist shop. Crate engines are rarely necessary for standard replacement; rebuilt engines are the cost-effective middle ground.
Will my car run as well after an engine replacement?
A factory new engine will perform identically to the original. A rebuilt engine will perform like a factory new one if it was rebuilt to factory specifications. Used engines vary—they may run well or may fail soon after installation. Proper break-in (straightforward driving for the first 500 miles) helps any replacement engine settle in.
Should I replace the transmission fluid when I replace the engine?
If the old engine failed catastrophically (seized, threw a rod), metal debris may have circulated into the transmission. A transmission flush costs $150 to $300 and is worth doing as insurance. If the engine straightforward wore out and stopped running, a flush is optional but not urgent.