Charge the GB40 using its USB-C port or a 12-volt vehicle outlet
The Noco Boost Plus GB40 has two charging methods: a USB-C cable (included) that plugs into any standard USB power adapter, or a 12-volt car charger cable (sold separately) that connects to your vehicle's cigarette lighter socket. USB-C is the faster and more practical option for most owners because you can charge at home, in an office, or anywhere with a wall outlet. A full charge via USB-C takes roughly 4 to 5 hours. The 12-volt method is slower — typically 8 to 10 hours — and is mainly useful if you're charging while driving or have no access to household power.
The GB40 arrives partially charged, so you can use it when ready in an emergency. However, you should fully charge it before storing it for more than a few weeks. The device has a built-in battery management system that prevents overcharging, so leaving it plugged in after it reaches full capacity will not damage the unit.
Key Takeaways
- USB-C charging is the standard method and takes 4 to 5 hours from empty to full using any standard USB power adapter.
- A 12-volt car charger cable (purchased separately) charges the GB40 in 8 to 10 hours through your vehicle's power outlet.
- The GB40 ships partially charged and can jump-start a vehicle when ready, but should be fully charged before long-term storage.
- The device will not overcharge if left plugged in after reaching full capacity, thanks to its built-in battery management system.
Using the USB-C cable for home charging
The USB-C cable comes in the box with your GB40. Locate the USB-C port on the side of the unit — it's the small rectangular port with a distinctive shape. Plug the USB-C connector into this port, then connect the other end to a standard USB power adapter (5V, 2A minimum). Any phone charger or tablet charger will work, though a higher-amperage adapter (up to 3A) will charge slightly faster.
The LED indicator lights on the GB40 will show charging progress. During charging, the lights typically display in a sequence or remain illuminated to indicate the battery level. Once all lights are solid or the display shows 100%, the unit is fully charged. You can safely disconnect it at this point, though leaving it connected will not harm the battery.
Charging via a 12-volt vehicle outlet
The 12-volt charging cable is not included with the GB40 but can be purchased from Noco or third-party retailers that carry compatible products. This cable has a connector that fits into a standard cigarette lighter socket (also called a power outlet) in your vehicle. Plug the other end into the GB40's USB-C port using the appropriate adapter or connector.
This method is useful if you're on a road trip or want to keep the GB40 charged while your vehicle is running. Charging will be slower than USB-C because the vehicle outlet typically supplies less power. Do not attempt to charge while the vehicle is off, as this will drain your car battery instead of charging the jump starter.
Checking battery level and storage conditions
The GB40 displays its battery level through LED indicator lights on the device. Press the power button briefly to see the current charge status without turning on the jump-start function. The lights will illuminate to show approximately how much charge remains — typically four lights represent full or near-full capacity, and fewer lights indicate lower charge levels.
Store the GB40 in a cool, dry location away from direct sunlight and extreme temperatures. If you plan to store it for several months without use, charge it to full capacity before putting it away. Lithium-ion batteries (which the GB40 uses) hold their charge better when stored at full capacity than when partially depleted. Check the charge level every three to six months during long-term storage and top it up if needed.
Troubleshooting charging problems
If the GB40 is not charging, first verify that the USB-C cable is fully inserted into both the device and the power adapter. A loose connection is the most common cause of apparent charging failure. Try a different USB power adapter if one is available — some older or low-power adapters may not deliver enough current to trigger charging.
If the device still does not charge, check whether the GB40 has entered a low-battery protection mode. This safety feature can set up if the battery has been completely drained for an extended period. Leave the unit connected to a USB-C charger for at least 30 minutes to allow the protection circuit to reset. If charging still does not begin after this time, the battery or charging circuit may be defective and the unit may need service or replacement under warranty.
Maintaining battery health over time
Lithium-ion batteries degrade gradually with each charge cycle, but proper charging habits extend the GB40's lifespan. Avoid letting the battery drop to zero percent regularly — instead, recharge when the indicator shows one or two lights remaining. Extreme heat accelerates battery degradation, so keep the GB40 away from hot vehicles or direct sunlight for extended periods.
The GB40 is designed to handle hundreds of charge cycles before noticeable capacity loss occurs. Most owners will replace the device for other reasons (damage, loss, or upgrade) long before the battery becomes unusable. If you use the jump starter frequently, charging it after each use ensures it's ready for the next emergency.
Frequently Asked Questions
Can I charge the GB40 with any USB-C charger?
Yes, any standard USB-C power adapter will work. A 5V, 2A adapter is the minimum, but 3A adapters charge slightly faster. Phone chargers, tablet chargers, and laptop chargers with USB-C output are all compatible.
How long does a full charge last if I don't use the jump starter?
The GB40 holds its charge for several weeks under normal conditions. If stored in a cool location, it can retain most of its charge for two to three months. Check the battery level before using it after extended storage.
Is it safe to leave the GB40 plugged in overnight?
Yes, the built-in battery management system prevents overcharging. You can safely leave it connected to a USB-C charger indefinitely without damaging the battery or the device.
What does it mean if the lights don't turn on during charging?
Check that the USB-C cable is fully seated in both the device and the power adapter. Try a different adapter or cable if available. If nothing works after 30 minutes of charging, the device may need service.
Can I charge the GB40 while using it to jump-start a car?
No, do not attempt to charge the GB40 while it is actively jump-starting a vehicle. Charge it fully before using it, or wait until after the jump-start is complete before plugging it in.