Find the bonnet release lever inside your car
The bonnet release lever is a handle or pull located inside your vehicle, almost always on the driver's side. In most cars made in the last 20 years, it sits low on the dashboard or on the left side of the steering column, just below the dashboard edge. Look for a lever with a picture of an open bonnet on it — that symbol is the universal indicator.
Some newer vehicles use a button instead of a lever. Check your owner's manual if you cannot find a traditional pull handle; the button is usually marked with the same bonnet symbol and sits in a similar location near the steering column or on the dashboard panel to the left of the steering wheel.
If you have never opened your bonnet before, sit in the driver's seat with the door open and run your hand along the lower left dashboard. You will feel the lever or button within a few seconds.
Pull the release lever or press the button
Pull the lever toward you with steady, firm pressure. You should hear a click or feel a slight give as the bonnet latch releases. Do not yank it — a smooth, controlled pull works better and is less likely to damage the lever itself.
If your car uses a button, press it once and hold for a moment. The bonnet will pop up slightly or you will hear the latch release. Either way, the bonnet is now unlatched from the inside.
Walk to the front of the car and lift the bonnet slightly
After you pull the release, the bonnet will not open on its own. You need to walk to the front of the vehicle and lift it by hand. Grip the front edge of the bonnet — the edge closest to the windscreen — and lift upward with both hands.
The bonnet will rise a few inches, and you will feel a secondary latch underneath. This is a safety catch that keeps the bonnet from flying open while you are driving if the main latch fails.
Release the safety catch and prop the bonnet open
Once the bonnet is raised a few inches, locate the safety catch in the centre or slightly off-centre underneath the bonnet's edge. It is usually a small metal rod or clip. Push or lift this catch to the side or upward — the exact motion depends on your car's design, but it requires only light pressure.
After you release the safety catch, lift the bonnet all the way up. Most bonnets have a prop rod or strut attached to the underside. Pull this rod out and insert the end into the small hole or bracket on the underside of the bonnet to hold it open. If your car does not have a prop rod, the bonnet may stay up on its own or may have a gas strut that holds it automatically.
Key Takeaways
- The bonnet release lever is located inside the car on the driver's side, usually below the dashboard or on the steering column, and is marked with a bonnet symbol.
- Pull the lever or press the button with steady pressure until you hear or feel a click, which means the latch has released.
- Walk to the front of the car and lift the bonnet by hand to access the secondary safety catch underneath.
- Push or lift the safety catch to the side, then use the prop rod or gas strut to hold the bonnet open while you work.
Closing the bonnet when you are finished
To close the bonnet, first remove the prop rod and stow it back in its holder on the underside of the bonnet. Lower the bonnet gently until it is about 12 inches above the closed position, then let it drop the rest of the way. The latch will catch automatically — you should hear a solid click.
Do not slam the bonnet down hard. A controlled drop from a low height is enough to engage the latch properly. If the bonnet does not latch on the first try, lift it again and lower it once more. If it still does not catch, check that the safety catch is fully closed and try again.
Frequently Asked Questions
What if the release lever does not click or move?
The lever may be stuck due to dirt or corrosion. Try pulling it several times with firm, steady pressure rather than one hard yank. If it still will not budge, the cable connecting the lever to the latch may have snapped. You will need a mechanic to repair it, but this is rare in cars less than 15 years old.
Can I open the bonnet if the car is running?
Yes, you can open the bonnet while the engine is running, but it is safer to turn the engine off first. If you must work on the engine while it is running, keep your hands and loose clothing away from moving parts like the fan and belts.
What if the bonnet will not stay open?
Check that the prop rod is fully inserted into its bracket. If the rod is in place but the bonnet still sags, the gas strut may be weak or failed. The bonnet will still stay open if you hold it, but you should have the strut replaced soon so you can work safely with both hands free.
Is there a bonnet release if the battery is dead?
Most cars have a mechanical release lever that works without power, so a dead battery will not prevent you from opening the bonnet. However, some newer luxury vehicles have electronic releases that require battery power. If your car has an electronic release and the battery is dead, consult your owner's manual for an emergency release procedure, which usually involves accessing a cable or lever from underneath the car.