You can replace a Honda Accord key fob battery yourself in about five minutes with a coin and a fresh battery
Your Honda Accord key fob runs on a small coin-cell battery, usually a CR2032 or CR2025, that wears out over time. When the fob stops locking or unlocking your car from a distance, the battery is almost always the culprit—not the fob itself. You do not need a dealer or a locksmith. The battery costs between $3 and $8, and the whole job takes longer to read about than to do.
The process is the same across most Honda Accord model years. You will pry open the fob case with a coin, swap the old battery for a new one, and snap it back together. No tools beyond a coin are required, and nothing can go wrong if you follow the steps in order.
Key Takeaways
- Honda Accord key fobs use a CR2032 or CR2025 coin-cell battery that you can buy at any pharmacy, grocery store, or hardware store for under $10.
- The fob case opens by inserting a coin into the slot on the edge and twisting gently—do not force it, as the plastic can crack.
- When you remove the old battery, note which side faces up so you can install the new one the same way; the positive side usually faces toward you.
- After closing the fob, test the lock and unlock buttons from several feet away before you assume the job is complete.
What battery your Honda Accord key fob uses
Most Honda Accord key fobs from the 1990s onward use either a CR2032 or CR2025 battery. The CR2032 is thicker and more common in newer models; the CR2025 is slightly thinner and appears in some older fobs. Both are 3-volt lithium coin cells, and both cost the same.
You can find the correct battery printed on the inside of your fob case once you open it, or you can check your owner's manual. If you are unsure, buy a CR2032—it is the most common, and any pharmacy or grocery store will have it in stock. If your fob uses a CR2025 instead, the CR2032 will still fit and work, though it may be slightly snug.
How to open your key fob safely
Look at the edge of your key fob for a small slot or seam. This is where the two halves of the plastic case meet. Insert a coin—a dime, penny, or quarter works—into the slot with the edge facing the seam.
Turn the coin gently, as if you were opening a jar lid. You should feel light resistance, and the two halves will begin to separate. Do not force it. If the coin slips or the plastic feels like it might crack, stop, reposition the coin, and try again. The case is designed to open this way, so it should not require much pressure.
Once the halves are loose, use your fingers to pull them apart. Set the metal contact points and any springs aside carefully—they are small and straightforward to lose. The battery will be sitting in a shallow cup on one side of the case.
Removing the old battery and installing the new one
Before you touch the old battery, look at which side is facing up. The positive side (marked with a +) usually faces toward you. This matters because the new battery must go in the same way.
Gently pry the old battery out with your fingernail or the edge of the coin. Do not use a sharp tool that could scratch the battery cup. Once it is out, set it aside—lithium coin cells are not toxic, but they should not be thrown in the trash. Many pharmacies and electronics stores have battery recycling bins near the register.
Take your new battery and orient it so the positive side faces the same direction as the old one did. Slide it into the cup. It should sit flat and snug without any rocking. If it feels loose, the battery may be upside down—flip it and try again.
Closing the fob and testing it
Line up the two halves of the case so the metal contacts and springs sit properly in their grooves. Press the halves together firmly until you hear or feel a click. The seam should be tight all the way around with no gaps.
Walk to your car and stand about 10 feet away. Press the lock button on the fob. If the car locks, press unlock and listen for the unlock sound. Try this from different distances—near the car, across the driveway, and from inside your house. If both buttons work and the car responds, the job is done.
If the fob does not work, open it again and check that the battery is facing the right direction. Flip it and test again. If it still does not work after you have tried both directions, the battery may be defective (rare) or the fob itself may have a deeper problem. In that case, a Honda dealer can diagnose it.
When to replace your key fob battery
You will notice the fob is failing when the buttons work only from very close to the car, or when you have to press them multiple times to get a response. Some people notice the lock and unlock lights on the fob dimming before the buttons stop working altogether. These are all signs the battery is nearly dead.
You do not have to wait until the fob is completely dead. If you notice it working less reliably, replacing the battery now is cheaper and faster than being locked out later. Keep a spare CR2032 in your glove box or at home so you can swap it in without a trip to the store.
What to do if the fob case will not open
If the coin slot is too tight or the case feels stuck, try a different coin with a thinner edge—a dime works better than a quarter for some fobs. Make sure you are inserting it into the actual seam and not a decorative groove. If the fob has been dropped or damaged, the case may be warped and genuinely stuck.
In that case, a Honda dealer or a locksmith can open it for you, usually for $20 to $50. They can also order a replacement fob if the case is cracked or the internal contacts are damaged. This is still much cheaper than replacing the entire fob, which can cost $150 to $300 depending on your Accord model year.
Frequently Asked Questions
Can I use a different battery size if I cannot find a CR2032?
A CR2025 will work in a fob designed for a CR2032, though it may be slightly loose. Do not use a battery with a different voltage—stick to 3-volt coin cells. If your store does not have either size, order one online or try another store; these batteries are common and inexpensive.
How long does a key fob battery last?
Most CR2032 and CR2025 batteries last three to four years in a key fob, depending on how often you use the buttons. Heavy use drains the battery faster. If you use your fob multiple times a day, you may need to replace it every two to three years.
What if I put the battery in backwards?
The fob straightforward will not work. Open it again, flip the battery so the positive side faces the correct direction, and close it. No damage occurs from installing it backwards—the fob just will not transmit a signal until you fix it.
Do I need to reprogram my Honda Accord after changing the battery?
No. The fob does not lose its programming when the battery dies or is replaced. As soon as you install a fresh battery, the fob will work exactly as it did before.
Is it safe to throw away the old battery?
Lithium coin cells should not go in the trash. Take the old battery to a pharmacy, grocery store, or electronics retailer—most have free battery recycling bins. Some auto parts stores also accept them.