Oil changes keep your lawn mower engine running smoothly and extend its life

Lawn mower oil breaks down over time from heat and dirt, losing its ability to protect engine parts. Replacing it is one of the simplest maintenance tasks you can do yourself — it takes about 15 minutes and costs $5 to $15 for a bottle of oil. Most mowers need an oil change once a season if you use them regularly, or every 50 hours of operation, whichever comes first.

The process is the same whether you have a push mower, riding mower, or zero-turn: drain the old oil, replace the filter if your mower has one, and pour in fresh oil to the correct level. You do not need special tools or experience. The hardest part is usually finding where the drain plug or drain hole is on your specific model.

Key Takeaways

  • Check your mower's manual to find the oil capacity and the correct oil type — using the wrong viscosity can damage the engine.
  • Drain old oil while the engine is still warm (but not hot) so it flows freely, and let it drain for at least five minutes into a pan.
  • If your mower has an oil filter, unscrew the old one by hand and install a new one hand-tight, not with a wrench.
  • Fill the tank slowly and check the level with the dipstick before starting the engine, because overfilling causes smoke and engine damage.
  • Dispose of old oil at a recycling center, auto parts store, or municipal hazardous waste facility — never pour it down a drain.

Gather the right oil type and tools before you start

Open your mower's manual and write down the oil capacity (usually 0.5 to 2 quarts for push mowers, more for riding mowers) and the viscosity grade. Most lawn mowers use SAE 30 or 10W-30 oil. Using the wrong viscosity can cause poor engine performance or damage, so do not guess. If you cannot find the manual, search the mower's model number online — manufacturers post them free.

Buy a bottle of the correct oil from any hardware store, auto parts store, or big-box retailer. You will also need a drain pan (any shallow container works), a wrench or socket that fits your drain plug, and old rags or paper towels. If your mower has an oil filter, buy a replacement filter for your model at the same time. Some mowers do not have filters — the manual will tell you.

Warm the engine and locate the drain plug

Run the mower for two or three minutes to warm the oil, then turn it off. Warm oil flows faster and drains more completely than cold oil. Wait 30 seconds for the engine to cool slightly — you want it warm, not hot enough to burn your hands.

Tip the mower on its side or back to access the drain plug. Check your manual for the exact location; on most push mowers it is on the side of the engine block, and on riding mowers it is usually underneath. Place your drain pan directly under the plug before you open it. Unscrew the plug by hand if it is loose, or use a wrench. Oil will pour out when ready, so be ready.

Drain the old oil completely and replace the filter

Let the oil drain for at least five minutes. Tilt the mower slightly to help the last bit flow out. While you wait, wipe the drain plug clean with a rag and inspect it for damage — if the threads are stripped or the plug is cracked, you may need to replace it (a hardware store can help you find the right size).

If your mower has an oil filter, locate it now (usually a cylindrical canister on the side of the engine). Unscrew it by hand — if it is too tight, wrap a rag around it for grip, but do not use a wrench. Discard the old filter. Wipe the rubber seal area on the engine clean with a rag. Hand-screw the new filter on until the rubber seal touches the engine, then turn it another three-quarter turn — do not over-tighten. Reinstall the drain plug and tighten it snugly with your wrench, but not so hard that you strip the threads.

Fill with fresh oil and check the level

Set the mower upright on level ground. Unscrew the oil filler cap (usually marked with an oil can symbol) and insert a funnel. Pour in about three-quarters of the amount listed in your manual, then stop and check the dipstick. Pull the stick out, wipe it clean, reinsert it fully, and pull it out again to read the level. The oil should reach the "full" mark on the stick.

Add oil slowly in small amounts until the level is correct. Overfilling causes the engine to smoke, lose power, and foul the spark plug. Once the level is right, screw the filler cap back on and wipe up any spilled oil with a rag.

Start the engine and check for leaks

Start the mower and let it run for 30 seconds. Watch for oil leaking from the drain plug or filter. If you see a drip, turn off the engine when ready and tighten the plug or filter slightly. Let the engine cool for a minute, then check the oil level again with the dipstick — it may have dropped slightly as the new oil circulates through the engine.

Once the level is correct and there are no leaks, you are done. Run the mower normally and check the level again after the first use. Dispose of the old oil at a local recycling center, auto parts store (many accept it free), or municipal hazardous waste facility. Never pour it down a drain or into the ground.

Frequently Asked Questions

How often should I change my lawn mower oil?

Most manufacturers recommend an oil change once per season for homeowners, or every 50 hours of operation for heavy use. Check your manual for the exact interval. If you use your mower weekly during the growing season, once a year is usually enough. If you use it daily or run it for long hours, change it twice a season.

Can I use the same oil I use in my car?

Only if it is the correct viscosity for your mower. Many lawn mowers use SAE 30, which is rarely used in cars anymore. Check your manual first. Using the wrong oil can cause engine damage, so do not assume car oil will work.

What if I spill oil on the ground?

Contain it when ready with rags or kitty litter to prevent it from spreading. Scoop up the contaminated material and dispose of it as hazardous waste. If the spill is large or has soaked into soil, contact your local environmental agency for guidance on cleanup.

Do I need to change the spark plug at the same time?

No, but it is a good time to check it. Spark plugs typically last one to two seasons. If the plug looks black or fouled, replace it. Your manual will tell you the correct type and gap setting.

What should I do with the old oil?

Take it to a recycling center, auto parts store, or municipal hazardous waste facility. Most accept used oil free of charge. Do not pour it down a drain, into the ground, or into the trash — it contaminates water and soil.