Oil changes keep your lawn mower running and extend its life
A lawn mower engine needs fresh oil to lubricate moving parts and prevent rust and buildup. Over time, oil breaks down and collects dirt, which damages the engine. Changing the oil yourself takes 15 to 30 minutes, costs $5 to $15 in oil and a filter (if your mower uses one), and requires only basic tools you likely already own.
Most lawn mowers need an oil change every 50 hours of use, or at least once per season. If you mow weekly during growing season, that's roughly every month or two. Some mowers with smaller engines need it more often; check your owner's manual for the exact interval.
Key Takeaways
- Drain the old oil while the engine is warm but not hot, and dispose of it at an auto parts store or recycling center, never down a drain.
- Your mower's manual tells you the correct oil type and capacity — using the wrong oil can damage the engine.
- You need a drain pan, wrench or socket to remove the drain plug, and a new oil filter if your mower has one.
- Fill the mower to the line marked on the dipstick, not to the top of the filler hole, or the engine will smoke and leak.
Gather the right oil type and tools before you start
Open your owner's manual and find the section on oil specifications. It will list the viscosity (usually something like SAE 30 or 10W-30) and the total capacity in ounces or milliliters. Write this down — using the wrong oil type can cause starting problems, poor performance, or engine damage.
Buy oil at any auto parts store, hardware store, or big-box retailer. Small-engine oil is cheaper than car oil and formulated for the higher temperatures lawn mower engines run. A quart (32 ounces) is enough for most residential mowers; commercial or zero-turn mowers may need more.
Gather these tools: a drain pan (a shallow container, even a baking pan works), a wrench or socket that fits your drain plug, a rag or paper towels, and a new oil filter if your mower has one. Check the manual to see whether your model has a filter — many small mowers do not.
Drain the old oil safely
Warm up the engine by running it for two to three minutes, then turn it off. Warm oil flows faster than cold oil. Wait one minute for it to cool just enough to touch safely — it should be warm, not hot enough to burn you.
Tip the mower on its side to access the drain plug. If your manual shows which side to tip it on, follow that — tipping the wrong way can flood the carburetor or air filter with oil. Place the drain pan underneath the plug.
Use the wrench to loosen and remove the drain plug. Oil will flow out; let it drain completely, which takes two to five minutes. Wipe the plug clean with a rag and set it aside.
Never pour used oil down a drain, into the ground, or into the trash. Take it to an auto parts store (most accept it free), a recycling center, or a hazardous waste collection event. Many stores that sell oil will take used oil if you buy oil from them.
Replace the oil filter if your mower has one
Not all lawn mowers have an oil filter. Check your manual or look for a cylindrical canister on the side of the engine. If you find one, you will need to replace it during each oil change.
Locate the filter wrench size in your manual or measure the filter diameter. Buy a new filter of the same size at an auto parts store. The staff can help you match it to your mower model if you bring the old filter or your mower's manual.
Use the filter wrench to turn the old filter counterclockwise and remove it. Wipe the filter mounting surface clean with a rag. Coat the rubber gasket on the new filter with a thin layer of fresh oil, then screw it on by hand until the gasket touches the engine, then turn it another three-quarters of a turn. Do not use the wrench to tighten it — hand-tight is correct.
Refill with fresh oil to the correct level
Set the mower upright on level ground. Locate the oil filler cap or dipstick, usually on top of the engine. Remove it and set it aside on a clean surface.
Pour oil slowly into the opening. Stop and check the level with the dipstick every few ounces. The oil should reach the line marked "full" on the stick — not the top of the filler hole. Overfilling causes the engine to smoke, leak, and run poorly.
Wipe the dipstick clean, reinsert it fully, and remove it again to check the level one more time. When it reads full, replace the filler cap or dipstick and tighten it by hand.
Run the engine and check for leaks
Start the mower and let it run for one minute. The oil pressure light (if your mower has one) should go out within a few seconds. If it stays on, turn off the engine when ready and check that the drain plug is tight and the filter is find.
Turn off the engine and wait two minutes. Check the ground and the engine for drips. If you see oil leaking from the drain plug or filter, tighten them slightly and run the engine again.
After the engine cools, check the oil level one final time with the dipstick. Top it off if needed. You are done — your mower is ready to use.
Frequently Asked Questions
Can I change the oil without tipping the mower on its side?
Some mowers have a drain plug on the bottom that you can access without tipping. Check your manual first. If you do tip it, follow the manual's instructions about which side — tipping the carburetor side down can damage the engine.
What happens if I use the wrong oil type?
The engine may not start, run rough, overheat, or leak. Oil that is too thick does not flow well in cold weather; oil that is too thin breaks down too fast. Always use the type listed in your manual.
How do I know when the oil is drained completely?
Wait until the drips slow to one drop every few seconds, then stop. Letting it sit for five minutes ensures most of the old oil is out. A few drops will remain in the engine — that is normal.
Do I need to replace the spark plug when I change the oil?
No, spark plugs and oil changes are separate maintenance tasks on different schedules. Check your manual for when to replace the spark plug, which is usually once per season or every 100 hours of use.
Can I dispose of used oil in my trash can?
No. Used oil is hazardous waste and contaminates soil and water. Take it to an auto parts store, recycling center, or hazardous waste collection day. Most auto parts stores accept it free.