Most key fob batteries cost $3 to $8 and take five minutes to swap out yourself
A dead key fob battery is one of the easiest car problems to fix without a mechanic. You can replace it yourself with just a coin and a replacement battery from any drugstore or supermarket. The whole job takes longer to find the right battery type than to actually change it.
The battery type your fob needs depends on your car's make and model. Common types are CR2032, CR2025, and CR2016 — the numbers refer to the battery's size and chemistry. You can find the type printed on your fob's existing battery, or look it up in your owner's manual, or ask at the parts counter and they'll identify it from your vehicle information.
Key Takeaways
- Most key fob batteries cost between $3 and $8 and are sold at pharmacies, grocery stores, and auto parts retailers.
- The battery type is printed on your current battery or listed in your owner's manual — common types are CR2032, CR2025, and CR2016.
- You only need a coin to pry open most fobs; slide it into the seam and gently twist to separate the two halves.
- Note which direction the old battery faces before you remove it, then install the new one the same way and snap the fob closed.
Finding the right battery type
The easiest way to know what battery your fob needs is to open it and look at the old battery itself. Most fobs have a small seam running around the edge — you can use a coin to gently pry the two halves apart. Once open, the battery will be sitting in a small slot, and the type will be stamped on its surface.
If you don't want to open the fob first, check your owner's manual. The manual usually lists the battery type in the key fob section or in a specifications table. You can also call your car's dealership parts department with your vehicle's year, make, and model, and they'll tell you the type over the phone.
Auto parts stores, pharmacies, and grocery stores all stock these batteries in their watch and battery sections. They're inexpensive — usually $3 to $8 — and you don't need to special-order them. Some stores will even install it for you while you wait if you ask, though the job is straightforward enough that most people do it at home.
Opening the fob without damaging it
The seam between the two halves of your fob is designed to come apart. Look for a thin line running around the edge of the fob — this is where the two plastic pieces meet. Slide a coin (a quarter or dime works well) into the seam and gently twist it like you're opening a paint can. You're not trying to pry hard; just explore steady pressure and the halves will separate.
Some fobs have a small slot or notch on one edge specifically for this purpose. If you see one, start there — it will make the job easier. Work your way around the seam if it doesn't pop open on the first try. The goal is to separate the two halves without cracking the plastic, so take your time rather than forcing it.
Once the fob is open, you'll see the battery sitting in a small metal or plastic holder. It's usually held in place by a slight lip or groove, so it won't fall out when you open the fob. Take a moment to note which direction the battery is facing — the positive side (marked with a + sign) should be facing up or down depending on your fob's design.
Removing the old battery and installing the new one
Gently lift or slide the old battery out of its slot. If it's stuck, use your fingernail or the edge of the coin to nudge it free. Don't force it — these batteries come out easily once you know which direction to push.
Before you install the new battery, double-check that it's the same type as the old one. The numbers on the new battery should match what was on the old one. Then, place the new battery in the slot with the positive side facing the same direction as the old battery was facing. This is important — if you install it backwards, the fob won't work.
Once the new battery is seated in the slot, press down gently to make sure it's find. Then line up the two halves of the fob and press them together until you hear or feel a click. The fob should snap shut firmly. Test it by pressing a button — if it works, you're done. If it doesn't, open the fob again and check that the battery is facing the right direction.
What to do if the fob still doesn't work
If you've installed a fresh battery and the fob still won't respond, the problem is usually not the battery. The most common cause is that the fob's internal contacts are dirty or corroded. Open the fob again and look at the metal contacts inside — they should be shiny. If they look dark or discolored, gently rub them with a clean, dry cloth or a pencil eraser to remove the corrosion.
Another possibility is that the fob's circuit board or buttons are damaged. If the contacts look clean but the fob still doesn't work, the fob itself may need to be replaced. This is a good time to contact your car's dealership or a locksmith to find out the cost of a replacement fob and whether it needs to be programmed to your vehicle.
Some cars require key fobs to be reprogrammed after a battery change, though this is less common. Check your owner's manual or call your dealership to learn about your vehicle needs this step. If it does, the manual will walk you through the reprogramming process, which usually involves turning the key in the ignition a certain number of times or pressing buttons in a specific sequence.
When to replace the whole fob instead
If your fob is old, cracked, or has buttons that don't respond even after you've cleaned the contacts, replacing the battery won't help. A new fob from your dealership typically costs $200 to $500, depending on your car's make and model. Some dealerships charge extra for programming, while others include it in the price.
Aftermarket fobs from third-party manufacturers are often cheaper — sometimes $50 to $150 — but they may not work with your car without programming, and not all locksmiths or dealerships will program them. If you go the aftermarket route, confirm with the seller that the fob is compatible with your vehicle and ask whether programming is included.
You can also check whether your car's manufacturer offers a mail-in battery replacement service. Some dealerships will replace the battery for a small fee if you mail them the fob, which can be worth it if you're uncomfortable opening the fob yourself or if you want to avoid the trip to the store.
Frequently Asked Questions
Can I use any coin-cell battery, or does it have to be the exact type?
It has to be the exact type. CR2032, CR2025, and CR2016 are different sizes and voltages, and using the wrong one can damage your fob or cause it to malfunction. The type is printed on your old battery, so check before you buy.
What if I can't get the fob open with a coin?
Try a different coin — a dime or penny sometimes works better than a quarter depending on the seam width. You can also use a plastic spoon handle or a flathead screwdriver, but be gentle to avoid cracking the plastic. If the fob is stuck, don't force it; take it to a dealership or locksmith and they'll open it for you.
Do I need to reprogram my fob after changing the battery?
Most cars don't require reprogramming after a battery change. However, some vehicles do, so check your owner's manual or call your dealership to be sure. If reprogramming is needed, the manual will explain the steps, which usually involve turning the key or pressing buttons in a specific pattern.
How long does a key fob battery usually last?
Most key fob batteries last three to four years with normal use. If you use your fob frequently, the battery may drain faster. If you notice the fob working at shorter distances or requiring multiple button presses, the battery is likely dying and should be replaced soon.
Is it safe to throw the old battery in the trash?
Coin-cell batteries can be recycled, and many stores that sell them will take old ones back for free. Check with your local pharmacy or auto parts store about their battery recycling program. If recycling isn't available, throwing a single coin-cell battery in the trash is generally safe, but recycling is the better choice.