A suspension lift raises your Forester's ride height by replacing springs, struts, or both
A suspension lift on a Subaru Forester replaces your factory springs and sometimes struts with aftermarket parts that sit taller, raising the vehicle's body 1 to 3 inches off the ground. This is different from a body lift, which spaces the body away from the frame without changing suspension geometry. Most Forester owners choose suspension lifts because they improve off-road clearance, accommodate larger tires, and keep the vehicle's handling closer to stock than a body lift does.
The cost ranges from $800 to $2,500 for parts alone, depending on kit quality and whether you replace struts. Labor typically adds $400 to $800 if you have a shop install it. You'll need to decide whether you want a modest 1-inch lift for tire clearance or a more aggressive 2 to 3-inch lift that changes how the Forester looks and performs on rough terrain.
Key Takeaways
- Suspension lifts cost $800 to $2,500 in parts, plus $400 to $800 in labor, and raise your Forester 1 to 3 inches depending on the kit you choose.
- A 1-inch lift fits larger all-terrain tires without major handling changes; a 2 to 3-inch lift requires new struts and affects steering response and ride comfort.
- Budget brands like Ironman and Dobinsons cost less but wear faster; brands like Bilstein and Old Man Emu hold up longer on rough terrain.
- After installation, you'll need a wheel alignment and should plan for new tires, which can add $600 to $1,200 to your total cost.
- A suspension lift voids no Subaru warranty if done by a dealer, but aftermarket work at independent shops may trigger warranty disputes on suspension-related repairs.
How much lift height you actually need
A 1-inch lift is the entry point for most Forester owners. It gives you enough clearance to fit 31-inch all-terrain tires (up from the stock 28-inch) without rubbing, costs $800 to $1,200 in parts, and requires only new springs—no strut replacement. Handling stays close to stock, and the ride quality doesn't change much. This is the right choice if you want better ground clearance for light off-road driving or just want the vehicle to sit higher without major mechanical changes.
A 2 to 3-inch lift requires replacing both springs and struts, pushing the cost to $1,800 to $2,500. You gain clearance for 33-inch tires and noticeably better approach and departure angles on steep terrain. The trade-off is real: steering becomes slightly slower, body roll increases in hard cornering, and the ride gets bouncier on pavement. This height is worth it if you plan regular backcountry driving or towing in rough conditions, but it's overkill for highway commuting with occasional dirt roads.
Coil spring kits versus strut-and-spring combos
A coil spring-only kit replaces your factory springs with stiffer aftermarket coils but keeps your original struts. This works for a 1-inch lift and costs $800 to $1,200 installed. The springs compress less under load, so the vehicle sits higher at rest. Your original struts will handle the new spring rate for a few years, but they'll wear faster because they're working against stiffer springs. This is a budget-friendly option if you're not planning to keep the vehicle past 100,000 miles or don't drive rough terrain often.
A strut-and-spring combo kit replaces both at once and is necessary for lifts over 1.5 inches. Kits from Bilstein, Old Man Emu, or Fox are engineered to work together—the struts are valved to handle the spring rate, so ride quality and handling stay predictable. You'll pay $1,800 to $2,500 for parts, but the suspension will last 80,000 to 100,000 miles without degradation. If you're lifting more than 1.5 inches or plan to keep the Forester long-term, this is the right choice.
Brand differences and what they cost
Budget brands like Ironman and Dobinsons offer complete kits for $1,000 to $1,400. They work and will lift your Forester, but the struts use simpler valving and the springs lose stiffness faster. Expect to replace them around 60,000 to 80,000 miles if you drive rough terrain regularly. These are fine if you're testing whether you like the lifted look before committing to better parts.
Mid-range brands like Bilstein and ARB cost $1,600 to $2,000 and use better damping technology. Struts last longer, and the ride stays controlled even with stiffer springs. Old Man Emu, which Subaru has used on some factory lifted models, sits in this range and is a solid choice for Forester owners who want reliability without premium pricing.
Premium brands like Fox and King cost $2,200 to $2,500 and are built for serious off-road use. They're overkill for a Forester unless you're running it in extreme terrain regularly. Most owners see no practical benefit over Bilstein or Old Man Emu on typical backcountry roads.
What changes after you install a lift
Your Forester will sit 1 to 3 inches higher, which changes how it looks and feels. The center of gravity rises slightly, so body roll in hard turns increases—not dangerously, but noticeably. Steering response slows a bit because the suspension geometry changes. Ride comfort on pavement gets firmer, especially with a 2 to 3-inch lift, because the springs are stiffer.
Ground clearance improves by the full lift height, so you can clear rocks and ruts that would have scraped the stock Forester. Approach angle (the angle at which the front bumper hits terrain) improves more than departure angle, so steep downhill exits are still limited by the rear bumper. If you're planning serious rock crawling, a lift alone won't solve that—you'll also need skid plates and possibly a different bumper.
Fuel economy drops slightly, typically 1 to 2 miles per gallon, because the taller stance increases wind resistance and the heavier suspension components add weight. Towing capacity doesn't change, but the higher center of gravity means you should be more careful with heavy loads on uneven terrain.
Tires, alignment, and hidden costs
After lifting, you'll need new tires. A 1-inch lift fits 31-inch all-terrain tires; a 2 to 3-inch lift fits 33-inch tires. A set of four 31-inch all-terrains costs $600 to $900; 33-inch tires run $800 to $1,200. This is not optional—your stock tires will look comically small, and you'll lose the clearance benefit of the lift.
A wheel alignment is mandatory after installation. Most shops charge $150 to $250 for a four-wheel alignment on a lifted vehicle. Skipping this causes uneven tire wear and steering problems. Some lift kits come with camber-correction bolts to make alignment easier; others require shims or new control arms if the lift is over 2 inches.
Budget $100 to $200 for miscellaneous hardware—new brake lines if they're too short, extended sway bar links, and possibly new CV axles if the lift is aggressive. A good shop will flag these during installation, but ask upfront what's included in the labor quote and what costs extra.
Warranty and insurance implications
Subaru's factory warranty does not cover suspension modifications, but the warranty itself is not voided. If you have a suspension-related failure after a lift, Subaru can deny the claim. If you have an unrelated failure—say, a transmission problem—Subaru must cover it. The distinction matters: a lifted Forester with a bad transmission will still be covered; a lifted Forester with worn struts will not.
If you have the lift installed at a Subaru dealer, the dealer will document it and you'll have a clear record. If you use an independent shop, keep the receipt and photos. Insurance companies rarely care about suspension lifts on personal vehicles, but some will charge slightly more for modified vehicles. Call your insurer before installation to confirm there's no premium increase or coverage gap.
Frequently Asked Questions
Will a 1-inch lift void my Subaru warranty?
No, but Subaru can deny claims for suspension-related failures after a lift. Non-suspension repairs are still covered. Keep your installation receipt to prove the work was done professionally. A dealer installation is the safest route if warranty protection matters to you.
Can I install a lift myself?
Yes, if you have basic mechanical skills and a spring compressor. Coil spring replacement is straightforward. Strut replacement is harder because you need to compress the spring safely and align the new strut correctly. Most owners save money by doing springs themselves and paying a shop for struts, or doing the whole job at a shop for $400 to $800 labor.
How long do lifted suspensions last?
Budget kits last 60,000 to 80,000 miles on rough terrain; mid-range kits last 80,000 to 100,000 miles. On pavement only, any kit lasts longer. Struts wear faster than springs because they're working harder, so expect to replace struts before springs if you drive rough roads regularly.
Do I need to replace my brakes or steering components?
Brakes don't need replacement, but brake lines may be too short on a 2 to 3-inch lift—a shop will extend them during installation. Steering components don't require replacement unless the lift is over 3 inches or you're adding extreme angles. Most 1 to 2-inch lifts don't touch steering geometry enough to matter.
What's the difference between a suspension lift and a body lift?
A suspension lift replaces springs and struts to raise the chassis; a body lift spaces the body away from the frame without changing suspension. Suspension lifts improve handling and ground clearance; body lifts are cheaper but make the vehicle feel disconnected and don't improve approach angles. For a Forester, a suspension lift is the better choice.