What the Vehicle Upgrade Console Does
The Vehicle Upgrade Console is a fabricator module in Subnautica that installs upgrades directly into your submarine or Prawn Suit. You build it inside your base, place it near a vehicle, and use it to add modules that improve speed, depth rating, energy efficiency, and defensive capabilities. Unlike crafting upgrades in your inventory, the console lets you swap modules in and out without destroying the old ones — you can remove an upgrade and use it elsewhere.
The console works only with vehicles docked or positioned next to it. You cannot upgrade a vehicle that is floating in open water or parked across the base. Once you have the console built and powered, you interact with it, select which vehicle to modify, and choose from available upgrades your base has the materials to craft.
Key Takeaways
- The Vehicle Upgrade Console is built inside your base and requires power to operate, so place it near a power source or run a power conduit to it.
- You can only upgrade vehicles that are docked at or positioned directly next to the console, not vehicles parked elsewhere in the world.
- Upgrades installed through the console can be removed and reinstalled on different vehicles without loss, unlike some inventory-crafted modules.
- The console requires the same materials as crafting upgrades normally, but saves inventory space and lets you experiment with different module combinations.
- Both the Seamoth and Prawn Suit can use the console, but each vehicle has different upgrade slots and compatible modules.
Where to Build the Console and How to Power It
You unlock the Vehicle Upgrade Console blueprint by scanning the fabricator modules inside the Aurora or by finding the blueprint in wrecks around the map. Build it in a multipurpose room, large room, or any base compartment that has floor space. The console takes up one floor tile and does not require a specific orientation.
The console draws power from your base's power grid. If your base has a power conduit running through the room, the console connects automatically. If not, run a power line from your reactor or solar panels to the room where you place it. A single console uses minimal power when idle, but drawing power while crafting upgrades will drain your batteries faster — plan accordingly if you are running on solar power alone.
Docking Your Vehicle and Installing Upgrades
Drive your Seamoth or Prawn Suit directly next to the console until the interaction prompt appears on screen. For the Seamoth, position it so the side of the vehicle faces the console. For the Prawn Suit, park it close enough that you can interact with the console while standing on the seafloor beside it. The vehicle does not need to be perfectly aligned, but it must be close — if the prompt does not appear, move the vehicle a few meters and try again.
Once docked, interact with the console and select the vehicle you want to upgrade. The interface shows available upgrade slots for that vehicle and lists which upgrades you can craft with materials currently in your base storage. Select an upgrade, confirm the crafting cost, and the console builds and installs it automatically. The process takes a few seconds per module. You can install multiple upgrades in one session without moving the vehicle.
Removing and Reusing Upgrades
To remove an installed upgrade, interact with the console while the vehicle is docked, navigate to the upgrade you want to remove, and select the remove option. The upgrade is uninstalled and placed in your base storage as a physical item. You can then install it on a different vehicle or store it for later use. This is the main advantage over crafting upgrades in your inventory — you are not locked into one vehicle once an upgrade is installed.
Removing upgrades takes the same few seconds as installing them. There is no penalty or resource loss. If your Seamoth is full and you want to try a Prawn Suit instead, remove the Seamoth's upgrades, dock the Prawn Suit, and install them there. This flexibility lets you test different module combinations without wasting materials.
Upgrade Slots and Compatibility
The Seamoth has four upgrade slots, while the Prawn Suit has six. Not all upgrades fit in all slots — some modules are restricted to specific slot types. For example, the Depth Module MK1 goes in a depth slot, while the Seamoth Sonar Upgrade goes in a sonar slot. The console interface shows which slots are available on your vehicle and which upgrades are compatible with each one. If an upgrade is grayed out, your vehicle does not have a compatible slot for it.
Common Seamoth upgrades include depth modules, engine efficiency modules, and the sonar upgrade. The Prawn Suit accepts depth modules, grappling arm upgrades, and thermal reactor modules. Check the console interface for the full list of what your specific vehicle can accept — the list changes as you progress and unlock new blueprints.
Common Mistakes and Troubleshooting
The most frequent problem is parking the vehicle too far away. The console has a limited interaction range — if you cannot see the prompt, move the vehicle closer. Another issue is forgetting to power the console. If the console is dark or unresponsive, check that your base has power and that the console is connected to the power grid. A powered console will glow and respond to interaction.
If you try to install an upgrade and the console says you lack materials, check your base storage containers. The console draws from all connected storage in your base, not just containers in the same room. If materials are in a locker on another floor, the console can still access them. If the upgrade still will not craft, you may not have the blueprint unlocked yet — scan the required fragments or find the blueprint in a wreck first.
Frequently Asked Questions
Can I upgrade a vehicle that is not docked at the console?
No. The vehicle must be positioned directly next to the console for the interaction prompt to appear. You cannot upgrade a vehicle parked elsewhere in the world or in a different base. If you want to upgrade a vehicle at a remote location, you need to build a second console there or transport the vehicle back to your main base.
What happens if I remove an upgrade and my vehicle loses depth rating?
Your vehicle's depth rating drops when ready. If you remove a depth module and then try to dive deeper than your new rating allows, the vehicle will take damage and eventually implode. Remove depth modules only if you are certain you will not need that depth rating, or reinstall them before diving deep.
Do I need a separate console for each vehicle?
No. One console can upgrade both your Seamoth and Prawn Suit. Dock one vehicle, make changes, undock it, dock the other vehicle, and make changes to that one. You do not need multiple consoles unless you want to upgrade vehicles at different bases simultaneously.
Can I craft upgrades in the console if I do not have a vehicle docked?
No. The console only works when a compatible vehicle is docked next to it. If you want to craft upgrades without a vehicle present, use a regular fabricator instead. The Vehicle Upgrade Console is designed specifically for installing modules into vehicles, not for general crafting.