The 2018 Equinox uses a cartridge-style oil filter located on top of the engine

The 2018 Chevrolet Equinox has a cartridge oil filter — a cylindrical canister that screws into a housing cap on the top of the engine, not a spin-on filter that hangs from the side. This matters because the replacement process is different from older vehicles. You'll remove the cap, pull out the old filter element, and install a new one, rather than unscrewing an entire filter unit.

The filter sits near the front-center of the engine bay, making it relatively accessible. On the 1.5L turbo and 1.6L diesel engines that came in 2018 Equinoxes, the location is the same. You'll need a filter wrench to remove the cap — a standard 86mm cartridge filter wrench works, though some owners use a strap wrench if they don't have the exact size.

Key Takeaways

  • The 2018 Equinox has a cartridge-style filter on top of the engine, not a traditional spin-on filter underneath.
  • You will need an 86mm filter wrench or strap wrench to remove the filter cap; a regular wrench will slip on the plastic housing.
  • Chevrolet recommends replacing the filter every 3,000 to 7,500 miles depending on driving conditions, and the owner's manual specifies which oil viscosity to use.
  • The filter element itself costs $8 to $15 for OEM or quality aftermarket parts; the cap gasket should be replaced each time you change the filter.

What you'll need to buy and have on hand

Purchase a replacement filter element designed for the 2018 Equinox — Chevrolet part number 12640411 is the OEM cartridge. Aftermarket equivalents from Fram, Mobil 1, or Bosch are widely available and cost less. You also need a new rubber gasket for the filter cap; this comes with most replacement cartridges but verify before you buy.

Have an 86mm filter wrench ready. If you don't own one, a strap wrench (also called an oil filter strap wrench) will work in a pinch, though it requires more hand strength. You'll also need a drain pan to catch any oil that spills when you remove the cap, rags or paper towels, and fresh engine oil matching your vehicle's specification — check your owner's manual for the correct viscosity and quantity.

Step-by-step removal and installation

Start with a warm engine (not hot — warm enough that the oil flows but cool enough to touch). Locate the filter cap on top of the engine; it's a black plastic cylinder about 3 inches tall. Place your drain pan underneath to catch spillage. Use your 86mm wrench to turn the cap counterclockwise until it comes free — it will take some force the first time.

Once the cap is off, pull the old filter element straight up and out of the housing. Inspect the rubber gasket on the underside of the cap; if it's cracked, hardened, or stuck to the housing, replace it. Clean the inside of the housing with a rag to remove any debris or old gasket material. Install the new gasket on the cap (it should sit in the groove), then insert the new filter element into the housing, pushing it down until it seats fully.

Thread the cap back onto the housing by hand first to avoid cross-threading, then use your wrench to tighten it. Chevrolet specifies 18 foot-pounds of torque; hand-tight plus a quarter turn with the wrench is close enough if you don't have a torque wrench. Do not over-tighten — the plastic housing can crack. Start the engine and let it run for 30 seconds, then check the cap and housing for leaks before driving.

Oil filter specifications for different 2018 Equinox engines

EngineFilter TypeOEM Part NumberOil Capacity (with filter)
1.5L TurboCartridge126404115.0 quarts
1.6L DieselCartridge126404115.5 quarts

Both engines in the 2018 Equinox use the same filter cartridge and housing design. The difference is oil capacity — the diesel holds slightly more. Always check your owner's manual for the correct oil viscosity; the turbo typically calls for 0W-20 or 5W-30, while the diesel may specify a different grade. Using the wrong viscosity can affect fuel economy and engine protection.

Common mistakes to avoid

The most frequent error is over-tightening the filter cap. The housing is plastic and will crack if you use excessive force with the wrench. Hand-tight plus a quarter turn is the right amount — you want it snug enough that it won't leak, not so tight that you need a wrench to remove it next time. If you over-tighten and crack the housing, you'll need to replace the entire assembly, which costs significantly more than a filter.

Another mistake is forgetting to replace the gasket. Reusing an old gasket will cause leaks because the rubber loses its seal after one heat cycle. Most cartridge filters come with a new gasket included, but some aftermarket options don't — check the package before you buy. Finally, don't skip the warm-engine step. Cold oil is thick and harder to drain; warm oil flows freely and ensures you remove as much old oil as possible.

When to replace the filter and what the owner's manual says

Chevrolet recommends changing the oil filter every 3,000 to 7,500 miles, depending on your driving conditions. If you drive mostly highway miles at steady speeds, you can go longer. If you drive in stop-and-go traffic, tow a trailer, or drive in dusty conditions, stick to the shorter interval. The 2018 Equinox owner's manual has a maintenance schedule in the back that spells out the exact interval for your driving pattern.

The manual also notes that the engine oil change interval and the filter change interval are the same — you should never change the oil without changing the filter, and vice versa. Some owners try to extend filter life by skipping a change; this defeats the purpose of the filter and can lead to engine sludge buildup. If you're unsure whether your filter is due, check your maintenance records or the mileage since the last change.

Frequently Asked Questions

Can I change the oil filter without changing the engine oil?

Technically yes, but Chevrolet doesn't recommend it. The filter and oil work together — old oil contaminates a new filter, and a new filter in old oil doesn't solve the underlying problem. Change both at the same time to get the full benefit of the service.

What happens if I use the wrong size filter wrench?

A wrench that's too small will slip on the plastic cap and round off the edges, making it impossible to remove without damaging the housing. An 86mm wrench is the correct size for the 2018 Equinox cartridge cap. If you don't have one, a strap wrench is a safer alternative than guessing with a standard wrench.

Is the filter cap gasket really necessary to replace every time?

Yes. The rubber gasket compresses when you tighten the cap and loses its seal after one heat cycle. Reusing it will cause oil leaks around the cap. New gaskets cost $2 to $5 and come with most replacement cartridges, so there's no reason to skip this step.

How tight should the filter cap be when I reinstall it?

Hand-tight plus a quarter turn with the wrench is the correct amount. Chevrolet specifies 18 foot-pounds of torque if you have a torque wrench. Over-tightening will crack the plastic housing and create a much bigger repair job than a straightforward filter change.