What you need before you start
Changing your own oil requires five things: the right oil for your car, a new filter, a wrench or socket that fits your drain plug, an oil filter wrench, and a container to catch the old oil. You also need a safe place to work — level ground where you can get under the car without it rolling, and ideally a ramp or jack stands so you're not working directly underneath a vehicle supported only by a jack.
Find the correct oil type and viscosity in your owner's manual or on a sticker under the hood. The manual also tells you how much oil your engine holds. Do not guess at either — using the wrong oil or the wrong amount can damage your engine. Most cars need between 4 and 6 quarts, but this varies widely.
You can buy oil, a filter, and a drain pan at any auto parts store. A basic oil filter wrench costs $10 to $20 and is reusable. If you don't own a jack and stands, you can rent them from most auto parts stores for $10 to $15 per day, or borrow them from someone who does this work regularly.
Key Takeaways
- Drain the old oil while the engine is warm but not hot, then replace the drain plug and tighten it by hand plus a quarter turn with a wrench — overtightening strips the threads.
- Remove the old filter by turning it counterclockwise by hand, then coat the rubber gasket on the new filter with a thin layer of fresh oil before screwing it on until the gasket touches the engine, then turn it another three-quarters of a turn.
- Pour new oil through the filler cap on top of the engine, check the level with the dipstick after a minute, and add more if needed — overfilling causes leaks and engine damage.
- Run the engine for 30 seconds to circulate the new oil, turn it off, wait a minute, then check the level again and top off if the reading is low.
- Dispose of old oil at an auto parts store, service station, or municipal hazardous waste facility — never pour it down a drain or into the ground.
Warm the engine and get underneath safely
Start the engine and let it run for two or three minutes so the oil warms up and flows more easily. Warm oil drains faster and more completely than cold oil. Then turn the engine off and wait five minutes — you want the oil warm enough to flow, not so hot that it burns your skin.
Raise the car on a ramp or with a jack and stands. Never work under a car supported only by a jack; a jack can fail and the car can fall on you. If you're using a jack, place jack stands under the frame on both sides before you get underneath. Lower the car onto the stands so it rests on them, not the jack.
Locate the drain plug underneath the engine — it's a bolt sticking down from the oil pan. Place your drain pan directly underneath it. The old oil will be hot and can splash, so position yourself to the side.
Drain the old oil and replace the plug
Use your wrench or socket to loosen the drain plug by turning it counterclockwise. Once it's loose enough to turn by hand, unscrew it the rest of the way by hand and set it aside. Oil will pour out quickly at first, then slow to a drip. Let it drain for five to ten minutes until the flow stops almost completely.
Wipe the drain plug clean with a rag and inspect the rubber or metal washer on it. If the washer is cracked, flattened, or missing, replace it — a bad washer causes leaks. Screw the plug back in by hand until it's snug, then use your wrench to tighten it another quarter turn. Do not overtighten; this strips the threads in the oil pan and creates a leak that's expensive to fix.
Move your drain pan out of the way. You're done underneath for now.
Remove the old filter and install the new one
Locate the oil filter — it's a cylindrical canister about the size of a soda can, usually on the side of the engine. Position your drain pan underneath it because oil will spill when you remove it. Use an oil filter wrench to turn the filter counterclockwise until it's loose, then unscrew it by hand the rest of the way. Expect old oil to drip out.
Before you install the new filter, coat the rubber gasket (the ring around the top) with a thin layer of fresh oil from your new oil jug. This creates a better seal and makes the filter easier to remove next time. Screw the new filter onto the threaded post by hand until the gasket touches the engine, then turn it another three-quarters of a turn. Hand-tight is correct; do not use the wrench to tighten it further.
Lower the car back to the ground if you raised it. You're ready to add new oil.
Pour in new oil and check the level
Open the oil filler cap on top of the engine — it usually has an oil can symbol on it. Pour in the amount of oil your manual specifies, but start with one quart less than the full amount. You'll add the final quart after you check the level.
Wait one minute for the oil to settle in the pan, then pull out the dipstick (a long thin rod with markings on it), wipe it clean with a rag, reinsert it all the way, and pull it out again. The oil should reach the "full" mark. If it's below the mark, add more oil a half-quart at a time, wait a minute, and check again. Do not overfill — oil above the "full" mark can leak out and damage engine seals.
Run the engine and do a final check
Start the engine and let it run for about 30 seconds. This circulates the new oil through the filter and engine. Turn the engine off and wait one minute for the oil to drain back into the pan. Check the dipstick again the same way — wipe it, reinsert it fully, pull it out, and read the level. Add a little more oil if needed to reach the full mark.
Look underneath the car for leaks around the drain plug and filter. A small drip or two is normal right after an oil change, but a steady stream means something is wrong. If you see a steady leak, turn off the engine and check that the drain plug and filter are tight.
Dispose of old oil properly
Old oil cannot go in the trash or down a drain — it contaminates groundwater and harms wildlife. Take it to an auto parts store (most accept it free), a quick-lube shop, a service station, or your city's hazardous waste collection day. Many stores that sell oil will take back used oil in the same container you brought it in, no questions asked.
Keep the receipt or documentation if your city requires proof that you disposed of it properly. Some municipalities track hazardous waste disposal, and you may need to show where the oil went.
Frequently Asked Questions
How often should I change my oil?
Check your owner's manual for the interval your car manufacturer recommends. This varies from 3,000 miles on older cars to 10,000 or even 15,000 miles on newer ones. Some cars use synthetic oil, which lasts longer than conventional oil. Follow your manual, not a general rule.
What if I spill oil on the driveway?
Soak it up with cat litter, sand, or old rags as soon as possible. Let it sit for a few hours, then sweep it up and dispose of the material as hazardous waste. Do not hose it down — that spreads it and makes it harder to clean. For large spills, contact your city's environmental department for cleanup guidance.
Can I reuse the old drain plug?
Yes, if the washer is in good condition. If the washer is cracked, flattened, or the plug threads are stripped, buy a new plug — they cost $5 to $15. A bad plug causes leaks that are much more expensive to fix later.
What if the oil filter is stuck and won't turn?
Tap the filter gently with a hammer to break the seal, then try the wrench again. If it's still stuck, wrap a rubber band or old inner tube around it for better grip. As a last resort, carefully poke a screwdriver through the filter and use it as a lever to turn it — this is messy but works when nothing else does.
Do I need to reset an oil change light after I'm done?
Some cars have an oil change reminder light that you must reset manually. Check your owner's manual for the steps — it usually involves holding a button on the dashboard or using the steering wheel controls while the engine is off. Some newer cars reset automatically after you drive a certain distance.