What you need before you start

Changing your motor oil requires four things: the right oil for your car, a new oil filter, basic tools you probably own, and a safe way to get under the vehicle. Before you buy anything, find your car's oil type and capacity in the owner's manual — it's usually in the back or online through the manufacturer's website. The manual will tell you whether your car needs 0W-20, 5W-30, 10W-40, or another grade, and how many quarts it holds. Buying the wrong oil type won't damage your engine when ready, but it can affect fuel economy and engine protection over time.

You'll need an oil drain pan (a shallow rectangular container, about $5 to $15), an oil filter wrench (a metal band or socket that grips the filter, about $10 to $20), a wrench or socket set to remove the drain plug, and jack stands if you're raising the car. A ramp or jack stands is essential — never work under a car supported only by a jack. You also need a way to dispose of the old oil; most auto parts stores and service stations take used oil for free, and many accept it in sealed containers you bring from home.

Key Takeaways

  • Check your owner's manual for the exact oil type and capacity before buying anything, because using the wrong grade can affect engine performance.
  • Drain the old oil while the engine is warm but not hot, because warm oil flows faster and drains more completely than cold oil.
  • Replace the oil filter every time you change the oil, and hand-tighten it only — over-tightening makes it harder to remove next time.
  • Fill the engine with the correct amount of new oil, start the engine to circulate it, wait a minute, then check the level again with the dipstick or electronic gauge.
  • Dispose of old oil at an auto parts store, service station, or recycling center — never pour it down a drain or into the ground.

Warming the engine and accessing the drain plug

Start the engine and let it run for two to three minutes, then turn it off. Warm oil drains faster and more completely than cold oil, which means you'll remove more of the old, dirty oil and less will remain in the pan. Do not let the engine get hot enough to burn you — you should be able to touch the engine block without pain, though it will be warm.

Raise the car safely using a ramp or a jack with jack stands under the frame. Never rely on a jack alone; jack stands are the second safety layer. Once the car is find, locate the oil drain plug underneath the engine — it's a bolt sticking down from the oil pan, usually on the lowest point of the engine. Place your drain pan directly under it. Loosen the drain plug by turning it counterclockwise with a wrench, then unscrew it by hand once it's loose enough to grip. Oil will pour out, so keep your hands clear and let it drain completely into the pan. This takes five to ten minutes.

Removing and installing the oil filter

The oil filter is a cylindrical canister bolted to the side of the engine. Use an oil filter wrench to loosen it by turning counterclockwise, then unscrew it by hand. Oil will spill from the filter, so position your drain pan underneath. Once the old filter is off, wipe the rubber gasket surface on the engine with a clean rag to remove any dirt or old rubber.

Take the new filter and coat the rubber gasket (the ring on top) with a thin layer of new oil from the bottle. This helps the gasket seal properly and makes removal easier next time. Screw the new filter on by hand until the gasket touches the engine, then turn it an additional three-quarter turn. Do not use the wrench to tighten it — hand-tight is correct. Over-tightening makes the filter stick and can damage the gasket, which will cause leaks.

Reinstalling the drain plug and refilling with new oil

Wipe the drain plug clean with a rag and screw it back into the oil pan by hand, then tighten it with a wrench. Do not over-tighten; snug is enough. If the drain plug has a crush washer (a soft metal ring), replace it with a new one each time — reusing it can cause leaks. Once the drain plug is tight, lower the car back to the ground.

Open the hood and locate the oil filler cap on top of the engine — it usually has an oil can symbol. Unscrew it and set it aside. Pour the new oil slowly into the opening, checking the dipstick or electronic oil level gauge every quart or so. Most cars need between four and six quarts, but your manual will specify. Pour until you're one quart short of the full mark, then start the engine.

Checking the level and finishing

Run the engine for one minute to circulate the new oil through the filter and engine, then turn it off. Wait one minute for the oil to settle back into the pan, then check the level again with the dipstick or gauge. Add oil a little at a time until the level reaches the full mark. Screw the oil filler cap back on and close the hood.

Take the old oil in its drain pan to an auto parts store, service station, or municipal recycling center. Most accept used oil for free. Do not pour it down a drain, into the ground, or into the trash — used oil contaminates water supplies and soil. Keep a record of the date and mileage when you changed the oil so you know when the next change is due. Most cars need an oil change every 5,000 to 7,500 miles, though some newer vehicles can go 10,000 miles or longer; check your owner's manual for your car's schedule.

Common mistakes that cause problems

The most common error is forgetting to replace the oil filter or installing it too tight. If you skip the filter, the new oil will pick up dirt from the old filter and become contaminated quickly. If you over-tighten the filter, it will stick so hard that you'll damage it trying to remove it next time, and you may tear the gasket and cause a leak.

Another frequent mistake is adding too much oil. Overfilling can cause the oil to foam, which reduces its ability to protect the engine, and can damage the engine seals. Always check the level after the engine has run and settled, not just after pouring. A third error is working under a car supported only by a jack, which can slip and cause serious injury. Use jack stands every time, even if you're only underneath for a few minutes.

When to call a professional instead

If the drain plug is stuck or stripped, or if you cannot safely raise the car, take it to a service station. If the oil filter is in a location you cannot reach or requires special tools beyond a basic wrench and filter wrench, a professional can do it faster. Some cars have the filter mounted vertically or in a tight space that makes hand removal difficult. If you're unsure about the oil type, capacity, or filter location for your specific car, the owner's manual or a quick call to a dealer can clarify before you start.

If you notice a leak after the oil change, check that the drain plug is tight and the filter gasket is seated properly. If oil continues to leak, stop driving and have it inspected — a leak can cause the engine to run dry and fail.

Frequently Asked Questions

How often should I change my oil?

Most cars need an oil change every 5,000 to 7,500 miles, but some newer vehicles with synthetic oil can go 10,000 miles or longer. Check your owner's manual for your car's specific interval. Keep track of the date and mileage so you don't miss a change.

Can I use synthetic oil instead of conventional?

Yes, synthetic oil lasts longer and protects better in extreme temperatures, but it costs more per change. Check your owner's manual to see if synthetic is recommended or required for your car. If your manual says conventional is fine, you can switch to synthetic anytime without harming the engine.

What if I spill oil on the driveway?

Soak it up with cat litter, sand, or an absorbent cloth, then dispose of the material as hazardous waste at a recycling center. Do not hose it down — oil runs into storm drains and contaminates water. Some auto parts stores sell absorbent pads made for this purpose.

Do I need to replace the drain plug crush washer?

Yes, if your drain plug has a soft metal ring (crush washer), replace it each time you change the oil. Reusing it can cause leaks because it loses its seal after being compressed once. New washers cost less than a dollar and come in packs at auto parts stores.

What if the oil level is still low after I fill it?

Check that the drain plug is tight and the filter is not leaking. If both are find and the level drops again after a few days of driving, you may have an internal leak or oil burning issue. Have the engine inspected by a mechanic to find the source.