What happens when you change your own oil

Changing your oil means draining the old, dirty oil from your engine, replacing the oil filter, and refilling with fresh oil. You do this by getting under the car, locating the drain plug at the bottom of the engine, opening it to let the old oil flow out, unscrewing and replacing the filter, then pouring new oil in from the top. The whole job takes 30 minutes to an hour once you know where everything is.

This is one of the few maintenance tasks most car owners can do safely at home with basic tools. You do not need a lift or a garage — a jack and jack stands, or ramps, work fine. The main risk is getting burned by hot oil or the engine, so you wait for the engine to cool slightly before starting.

Doing it yourself saves money on labour, but you still buy the oil and filter. You also become responsible for disposing of the old oil properly — most auto parts stores and service stations take it for free or a small fee.

Key Takeaways

  • You need a drain pan, socket wrench, oil filter wrench, jack and jack stands (or ramps), new oil of the correct grade for your car, and a new oil filter.
  • Always let the engine cool for at least five minutes after running, then raise the car safely before you start draining.
  • The drain plug is at the lowest point of the engine; the filter is usually on the side and screws on by hand.
  • Fill with the amount and grade of oil your owner's manual specifies, then run the engine and check the level again after it settles.
  • Old oil must be disposed of at a recycling centre, auto parts store, or service station — never pour it down a drain or into the ground.

Gather the right tools and materials before you start

You need a drain pan to catch the old oil — a shallow metal or plastic tray at least 5 or 6 quarts in capacity. You also need a socket wrench that fits your drain plug (usually 13mm, 14mm, or 15mm), an oil filter wrench to remove the old filter, and a way to safely raise the car: either a jack and jack stands or ramps. Never work under a car supported only by a jack.

Buy the correct oil grade and quantity for your car. Your owner's manual lists both — for example, "5W-30" or "0W-20". The manual also tells you how much to add, usually between 4 and 6 quarts. Buy a new oil filter that matches your car's make, model, and year; the parts store can cross-reference this for you. You may also want a funnel to pour oil without spilling, and rags or paper towels for cleanup.

Check that you have everything before you raise the car. Once you are under there, you do not want to stop and hunt for a tool.

Safely raise the car and locate the drain plug

Park on a level surface and engage the parking brake. If you are using a jack, place it under a reinforced point on the frame — your manual shows where these are — and raise one side of the car just high enough to work. when ready place jack stands under the frame on both sides for safety. If you are using ramps, drive slowly up them until the front wheels are about 12 inches up the slope, then set the parking brake.

Let the engine cool for at least five minutes if it has been running. Hot oil will burn skin. Slide under the car and locate the drain plug, a bolt at the lowest point of the engine oil pan. It is usually on the underside, toward the front or middle of the engine. If you cannot find it, check your owner's manual or look online for your specific car — there are thousands of videos showing the exact location for each model.

Place your drain pan directly under the plug. Position it so the oil flows into the pan, not onto the ground or your clothes.

Drain the old oil and replace the filter

Using your socket wrench, turn the drain plug counterclockwise to loosen it. Once it is loose enough, you can usually unscrew it by hand — be ready for hot oil to drip. Let it drain completely into the pan; this takes 5 to 10 minutes. While you wait, wipe the drain plug clean with a rag and inspect it for damage. If the threads are stripped or the plug is bent, you may need to replace it.

Next, locate the oil filter, a cylindrical canister usually mounted on the side of the engine. Use your oil filter wrench to turn it counterclockwise until it comes free. It will still contain oil, so keep the drain pan underneath. Unscrew it by hand and set it aside. Wipe the filter mounting surface clean with a rag.

Take your new filter and coat the rubber gasket (the ring around the top) lightly with fresh oil. This helps it seal properly. Screw the new filter on by hand until the gasket touches the mounting surface, then turn it another three-quarters of a turn. Do not use the wrench to tighten it — hand-tight is correct.

Refill with fresh oil and check the level

Reinstall the drain plug, turning it clockwise by hand first, then tightening it with your socket wrench. Do not over-tighten; snug is enough. Wipe away any spilled oil.

Lower the car back to the ground. Open the hood and locate the oil filler cap, usually marked with an oil can symbol on top of the engine. Unscrew it and set it aside. Place your funnel in the opening and slowly pour in the amount of oil your manual specifies — usually 4 to 6 quarts. Pour in about three-quarters of the recommended amount, then stop.

Reinstall the oil filler cap. Start the engine and let it run for 30 seconds to a minute, then turn it off. Wait two minutes for the oil to settle, then pull out the dipstick (a long rod with markings on it, usually yellow or orange), wipe it clean, reinsert it fully, then pull it out again to read the level. The oil should be between the minimum and maximum marks. If it is low, add a little more and check again. If it is overfull, drain a small amount into your drain pan.

Dispose of old oil and record the service

Old motor oil cannot go in the trash or down the drain — it contaminates groundwater and soil. Take it to a recycling centre, auto parts store, or service station. Most accept it for free; some charge a small fee. Many places that sell oil will take your old oil when you buy new oil from them. Call ahead if you are unsure whether a location accepts it.

Write down the date, mileage, oil grade, and filter type in your owner's manual or a maintenance log. This helps you track when the next change is due. Your manual or the sticker on the driver's door jamb tells you the interval — typically every 3,000 to 10,000 miles depending on your car and oil type. Some newer cars use synthetic oil and go longer between changes; check your manual to be sure.

Common mistakes that damage your engine

Overfilling the oil is one of the most common errors. Too much oil foams inside the engine, reducing its ability to lubricate and cool. It can also leak past seals and damage the catalytic converter. Always check the dipstick after filling and remove excess if needed.

Forgetting to replace the drain plug washer is another mistake. The washer is a small metal or rubber ring under the plug that creates a seal. If it is missing or damaged, oil will leak. Most drain plugs come with a new washer; if yours does not, buy one at the parts store.

Not waiting for the engine to cool before draining is dangerous. Hot oil causes severe burns. Even if you are in a hurry, wait at least five minutes. Tightening the oil filter too hard with a wrench can crack it or strip the threads on the engine, leading to leaks. Hand-tight plus three-quarters of a turn is the correct method.

Frequently Asked Questions

How do I know what oil grade my car needs?

Open your owner's manual and look for the oil specifications section — it will list the grade, such as 5W-30 or 0W-20. You can also find a sticker on the inside of the driver's door jamb or under the hood that shows the correct grade. If you have lost your manual, search online for your car's year, make, and model plus "oil grade".

Can I change the oil if the engine is completely cold?

Yes, but warm oil drains faster and more completely. If the engine is cold, you can start it and let it run for a minute or two to warm the oil, then turn it off and wait five minutes before draining. Never drain oil while the engine is hot enough to burn you.

What if I spill oil on the driveway?

Clean it up when ready with rags or paper towels to prevent it from spreading. For larger spills, use kitty litter or an absorbent powder to soak it up, then sweep it into a bag. Do not hose it down — that spreads it and sends it into storm drains. If the stain remains, a degreaser can help, but prevention is easier than cleanup.

Do I need to replace the drain plug every time?

No, the plug itself lasts for years. However, the washer under the plug should be replaced each time to maintain a good seal. Most new drain plugs come with a fresh washer. If yours does not, buy one separately — they cost less than a dollar.

How often should I change the oil?

Check your owner's manual for the interval specific to your car and oil type. Older cars and conventional oil typically need a change every 3,000 to 5,000 miles. Newer cars with synthetic oil may go 7,500 to 10,000 miles or longer. Follow your manual, not a general rule.