Check your oil with the engine off, on level ground, using the dipstick that comes with your car

The dipstick is a long metal rod with two marks on it — a minimum line and a maximum line. You pull it out, wipe it clean, push it back in all the way, then pull it out again to read where the oil sits between those two marks. If the oil level is below the minimum line, you add oil until it reaches the maximum line. That is the entire process, and it takes about two minutes.

The reason you check it is straightforward: oil keeps your engine from seizing. Without enough oil, metal parts grind against each other, heat builds, and your engine can fail in a way that costs thousands to fix or means replacing the whole engine. Checking the level every month or before a long drive catches a slow leak or burn-off before it becomes a crisis.

Some newer cars have electronic oil monitors instead of a dipstick — they show the level on your dashboard and alert you when it drops. If your car has one, you can skip the manual check unless the warning light comes on. But if your car has a dipstick, using it takes less time than checking your phone and gives you information the dashboard might not show until it is too late.

Key Takeaways

  • Always check oil with the engine off and the car parked on level ground, because the oil needs time to settle and gravity needs to work correctly.
  • Pull the dipstick out completely, wipe it on a clean cloth or paper towel, reinsert it all the way, then pull it out again to get an accurate reading.
  • The oil level should sit between the minimum and maximum marks on the stick — if it is below minimum, add the type of oil your owner's manual specifies.
  • Low oil can mean a slow leak, normal burn-off between oil changes, or a problem with your engine that needs attention from a mechanic.

Where to find the dipstick under your hood

Open your hood and look for a handle or loop sticking up from the engine block. The handle is usually yellow, orange, or red, and it has a long thin rod attached to it. That rod is the dipstick. If you cannot spot it, your owner's manual has a diagram showing exactly where it sits — the manual is in your glove box or available free online by searching your car's year, make, and model plus "owner's manual PDF".

Some dipsticks are harder to reach than others depending on your engine layout. If the handle is tucked behind hoses or other parts, you may need to move them slightly to get your hand in, but you should never force anything. If you cannot reach it comfortably, a mechanic can show you the trick for your specific car in about thirty seconds.

The correct way to read the dipstick

The reading is only accurate if you follow the steps in order. First, make sure your engine is off and has been off for at least five minutes — this gives the oil time to drain back down into the pan instead of sitting in the upper parts of the engine. Second, park on level ground. If your car is on a slope, the oil will pool to one side and give you a false reading.

Pull the dipstick straight out. You will see oil coating the rod. Wipe that oil off completely using a clean cloth, paper towel, or old rag — do not use the same cloth you used to wipe your hands, because dirt on the cloth can stick to the dipstick and throw off your reading. Push the dipstick back into its tube all the way until it seats at the bottom. Pull it out again slowly and look at where the oil line sits on the rod.

The dipstick has two marks: a minimum line (sometimes labeled MIN or LOW) and a maximum line (sometimes labeled MAX or FULL). The oil should touch somewhere between those two marks. If it is at the maximum line, your oil is full. If it is at the minimum line, you are at the threshold where you should add oil soon. If it is below the minimum line, add oil now.

What to do if the oil level is low

If the level is below the minimum mark, you need to add oil. Check your owner's manual or the inside of your fuel door for the correct type — it will say something like "5W-30" or "10W-40". Buy a quart of that oil from any auto parts store, gas station, or supermarket. It costs between three and eight dollars depending on the brand.

Open the oil filler cap on top of your engine — it usually has an oil can symbol on it and twists off by hand. Pour about half a quart in, wait a minute for it to drain down, then check the dipstick again using the same process. Add a little more if needed. It is easier to add oil in small amounts than to overfill and have to drain some out. Once the level is between the minimum and maximum marks, screw the cap back on and you are done.

If you are adding oil more than once a month, or if the level drops noticeably between oil changes, you have a leak or your engine is burning oil abnormally. Either way, have a mechanic look at it. A small leak can become a big one, and burning oil usually means something inside the engine is wearing out.

Why the oil level changes between oil changes

Your oil does not stay at the same level from one oil change to the next. Some oil gets burned during normal combustion — the fuel and air mixture ignites, and a tiny amount of oil that has seeped into the combustion chamber burns along with the fuel. This is normal. An engine in good condition might burn a quart over five thousand miles. An older engine or one with worn piston rings might burn a quart every thousand miles.

Oil also leaks slowly from seals and gaskets that wear over time. A slow drip from under your car, a faint smell of oil when the engine is hot, or a thin film on the ground where you park are all signs of a leak. Small leaks do not require when ready repair, but they should be monitored. If the leak gets worse or the oil level drops faster, have it fixed before it becomes a bigger problem.

If the level drops suddenly — more than a quart in a week — or if you see a puddle under your car, do not ignore it. Drive to a mechanic and have them find the source. Sudden loss of oil is not normal and can damage your engine if you keep driving.

Electronic oil monitors versus the dipstick

Many cars built in the last ten years have an electronic oil level sensor instead of a dipstick. The sensor sends a reading to your dashboard, and you see the oil level displayed on your instrument cluster or infotainment screen. Some cars show a percentage, others show a bar graph. When the level gets low, the car displays a warning message.

Electronic monitors are convenient, but they are not always as precise as a dipstick. The sensor can give a slightly different reading depending on the angle of the car or how recently the engine ran. If your electronic monitor shows low oil, trust it and add oil. But if you want to verify the reading or you do not trust the sensor, you can still check with a dipstick if your car has one — some newer cars have both.

If your car has no dipstick and no electronic monitor, or if the monitor is not working, you will need to have a mechanic check the oil for you. Do not drive for extended periods without knowing your oil level, because you have no way to catch a leak or burn-off before it damages the engine.

How often to check your oil

Check your oil at least once a month, and always before a long drive. If you drive a lot — more than fifteen thousand miles a year — check it every two weeks. If your car is older or has higher mileage, check it more often because older engines tend to burn or leak oil at higher rates.

If you have just had an oil change, check the level a few days later to make sure the mechanic filled it correctly. If you notice the level dropping faster than usual, check it weekly until you figure out whether you have a leak or a burn-off problem.

Frequently Asked Questions

Can I check the oil while the engine is warm or running?

No. A warm engine circulates oil throughout the engine block and up into the head, so the dipstick will read low even if the oil level is actually fine. Wait at least five minutes after turning off the engine. Never check oil on a running engine — you risk burning yourself on hot metal or getting your hand caught in moving parts.

What if the dipstick is stuck or hard to pull out?

Wiggle it gently side to side as you pull, rather than pulling straight up with force. If it still will not budge, stop and do not force it — you could bend the tube or break the dipstick. Have a mechanic remove it. Do not use tools or lubricants to try to free it yourself.

Does checking oil use any oil?

No. Checking the dipstick does not remove oil from the engine. A small amount of oil clings to the rod when you pull it out, but you wipe that off and it goes back in when you reinsert the stick. The only way to remove oil is to drain it during an oil change.

What if I overfill the oil?

If you add too much oil and the level goes above the maximum mark, you need to remove the excess. You can use a turkey baster or a small pump to suck oil out through the filler hole, or you can drive to a mechanic and have them drain a quart. Overfilled oil can damage your engine because it foams up and does not lubricate properly.

Why does my oil look dark or dirty?

Oil darkens as it circulates through the engine and picks up tiny particles of metal and carbon. Dark oil is normal and does not mean you need an oil change — your oil change interval is based on time or mileage, not color. If the oil looks thick, gritty, or smells burnt, those are signs it is time for a change even if you have not hit your scheduled interval.