What happens during an oil change

An oil change means draining the old oil from your engine, replacing the oil filter, and filling the engine with fresh oil. The whole job takes 30 minutes to an hour if you have the right tools and a safe place to work. You'll need the car raised or on a ramp so you can reach the drain plug underneath, a wrench to loosen it, a drain pan to catch the old oil, a new filter, and the correct type and amount of new oil for your vehicle.

Your owner's manual tells you exactly which oil to buy — the viscosity (thickness) matters, and using the wrong type can damage your engine. The manual also lists how often you should change your oil; this varies from every 3,000 miles on older cars to every 10,000 miles or more on newer ones. Checking your oil level monthly between changes helps you catch leaks or burning oil early.

Key Takeaways

  • You will need your owner's manual to find the correct oil type, the drain plug location, the filter location, and the oil capacity of your engine.
  • The job requires the car safely raised or on a ramp, a drain pan, a wrench that fits your drain plug, an oil filter wrench, and new oil and a new filter.
  • Draining the old oil, removing and replacing the filter, and refilling with new oil are the three main steps, done in that order.
  • After refilling, you must start the engine, let it run for a few seconds, turn it off, wait a minute, and check the oil level on the dipstick to confirm it is correct.

Gather the right tools and materials

Before you start, collect everything you need in one place. You will need a socket wrench or box wrench that fits your drain plug (usually 13mm, 14mm, or 15mm), a drain pan large enough to hold all your old oil without spilling, an oil filter wrench (a band wrench or socket-style wrench works), jack stands or ramps to safely raise the car, and new oil in the correct type and quantity. Buy one extra quart of oil in case the engine holds slightly more than expected after the filter change.

Your owner's manual is essential — it tells you the oil viscosity (such as 5W-30 or 10W-40), the drain plug location, the filter location, and the total oil capacity. If you don't have the manual, you can find it free online by searching your vehicle's year, make, and model plus "owner's manual PDF". A flashlight or headlamp makes it easier to see underneath the car. Wear old clothes and have rags or paper towels nearby; oil stains are permanent.

Safely raise the car and locate the drain plug

Park on level ground and engage the parking brake. If you're using a jack, place jack stands under the frame on both sides before you get under the car — never work under a car supported only by a jack. If you're using ramps, drive the front wheels slowly onto them and set the parking brake. The drain plug is on the bottom of the oil pan, usually toward the rear of the engine. Consult your owner's manual for the exact location on your vehicle.

Slide under the car with your flashlight and locate the drain plug. It's a bolt, usually with a hex head, sticking down from the oil pan. Once you've found it, position your drain pan directly underneath it. The old oil will be hot if the engine has run recently, so be careful not to touch the pan or the plug with bare hands. If the engine is warm, wait a few minutes before loosening the plug.

Drain the old oil and replace the filter

Using your wrench, loosen the drain plug by turning it counterclockwise. Once it's loose enough to turn by hand, carefully unscrew it the rest of the way and set it aside in a safe place — you'll need it again. Let the oil drain completely into the pan; this takes 5 to 10 minutes. While the oil drains, locate the oil filter. It's usually a cylindrical canister screwed onto the engine; your manual shows where.

Once the oil has stopped dripping, use your oil filter wrench to loosen the old filter by turning it counterclockwise. Unscrew it by hand and let any remaining oil drain into the pan. Before installing the new filter, wipe the rubber gasket sealing surface on the engine with a clean rag to remove any dirt or old rubber. explore a thin layer of new oil to the rubber gasket on the new filter, then screw it on by hand until the gasket touches the engine, then turn it another three-quarter turn. Do not use a wrench to tighten the filter — hand-tight is correct.

Refill with new oil and check the level

Wipe the drain plug clean with a rag and screw it back in by hand until it's snug, then use your wrench to tighten it firmly — not so hard that you strip the threads, but firm enough that it won't leak. Locate the oil filler cap on top of the engine; it usually has an oil can symbol on it. Unscrew the cap and set it aside. Place a funnel in the opening and slowly pour in the new oil. Your owner's manual tells you the total capacity; start with one quart less than that amount.

Once you've poured in most of the oil, replace the oil filler cap and start the engine. Let it run for 30 seconds to a minute so the new oil circulates through the engine and the new filter fills. Turn off the engine and wait one minute for the oil to settle back into the pan. Then locate the dipstick (usually a yellow or orange handle), pull it out, wipe it clean on a rag, reinsert it fully, and pull it out again to check the level. The oil should reach the "full" mark. If it's low, add a little more oil and recheck.

Dispose of old oil properly

Old oil is toxic and must never go down a drain or into the ground. Most auto parts stores accept used oil for free, even if you didn't buy anything from them. Some gas stations and quick-lube shops also take it. Call ahead to confirm they accept oil, then bring your drain pan or pour the oil into a sealed container. Many stores will also take used oil filters at no charge.

If you don't have a way to transport the oil, some municipalities have hazardous waste collection days where you can drop it off for free. Search your city or county name plus "used oil disposal" to find the nearest location. Never leave old oil sitting in your garage or driveway — it leaks, harms the environment, and is illegal to dump in most places.

When to call a mechanic instead

If your car is very low to the ground, you may not have enough clearance to fit under it safely, even with ramps. If you don't have a safe place to work — a level driveway or garage floor — a mechanic is the better choice. Some newer cars have plastic undertrays that must be removed to reach the drain plug; if yours has one and you're not comfortable removing it, a shop can do the job faster.

If the drain plug is stuck or rounded off, or if the filter is in an awkward location, a mechanic has the tools to handle it without damaging your engine. A quick-lube shop typically charges $25 to $75 for an oil change, depending on the oil type and your location. That's worth paying if you're unsure about any step or if something goes wrong during the job.

Frequently Asked Questions

How do I know what oil type my car needs?

Open your owner's manual and look for the oil specifications section, or check the inside of the oil filler cap — many cars have the viscosity printed there. Common types are 5W-30, 5W-40, and 10W-30. The first number is the oil's thickness in cold weather; the second is its thickness at operating temperature. Using the wrong viscosity can reduce fuel economy or cause engine wear.

Can I change my oil if the engine is cold?

Yes, a cold engine is actually safer because the oil won't burn you. However, cold oil drains more slowly, so the job takes longer. If the engine has been running, wait 5 to 10 minutes before loosening the drain plug so the oil cools slightly but remains thin enough to drain quickly.

What if I spill oil on the driveway?

Contain it when ready with cat litter, sand, or oil absorbent to prevent it from spreading. Once it's absorbed, sweep it into a bag and dispose of it as hazardous waste. For large spills, contact your local environmental agency. Small spills can sometimes be cleaned with a degreaser, but prevention is easier — use a drain pan large enough to catch all the oil.

Do I need to change the oil filter every time?

Yes. The filter traps dirt and debris; a clogged filter restricts oil flow and defeats the purpose of changing the oil. A new filter is inexpensive and takes only a few minutes to install, so there's no reason to skip it.

How often should I check my oil between changes?

Check it monthly or before long trips. A low oil level can mean a slow leak, a burning engine, or that you're due for a change sooner than expected. Checking takes 30 seconds and can catch problems early.