The oil filter location and part number for your Nissan Altima
Your Nissan Altima's oil filter sits on the driver's side of the engine, mounted vertically on the engine block. The exact location and part number depend on your model year and engine size. For most Altimas from 2007 onward with a 2.5-liter four-cylinder engine, Nissan part number 15208-9E000 or 15208-9E016 is the factory filter. If you have a 3.5-liter V6 (available in some model years), the part number is different—typically 15208-AA100 or similar.
The easiest way to confirm the correct part for your specific year and engine is to check your owner's manual or call a Nissan dealership with your vehicle identification number (VIN). You can also look it up on parts retailer websites like RockAuto, AutoZone, or O'Reilly by entering your year, make, and model. Most aftermarket filters from brands like Fram, Mobil 1, or Bosch will also fit, though they use different part numbers.
Key Takeaways
- Nissan Altima oil filters mount vertically on the driver's side of the engine block, and the correct part number varies by model year and engine size.
- Factory Nissan part numbers for 2.5-liter engines are typically 15208-9E000 or 15208-9E016, while 3.5-liter V6 engines use different numbers like 15208-AA100.
- Aftermarket filters from major brands fit Altimas and often cost less than OEM filters, though you should verify the part number matches your engine before purchase.
- Replacement takes 10 to 20 minutes if you have basic tools and a drain pan, and you can do it in a driveway or parking lot without special equipment.
What tools and supplies you need to change the filter yourself
If you plan to replace the filter yourself, you need an oil filter wrench (a socket-style or band wrench works best), a drain pan to catch spilled oil, a jack and jack stands if you need clearance under the car, and rags or paper towels. Most Altimas sit high enough that you can reach the filter from above without lifting the vehicle, but check your specific model year first.
You do not need the filter wrench if you have a tight grip and the filter is not over-tightened, but the wrench makes the job faster and prevents hand injuries. A drain pan is essential—oil spills are messy and environmentally harmful. You will also need new oil to top off the engine after the filter swap, since some oil drains out with the old filter. A funnel makes pouring oil back in cleaner and safer.
Step-by-step replacement process
Start with the engine cold or warm but not hot—warm is actually better because the oil flows more easily. Locate the filter on the driver's side of the engine block. Position your drain pan underneath it to catch the oil that will spill when you unscrew the filter.
Use the filter wrench to turn the filter counterclockwise until it loosens, then unscrew it by hand the rest of the way. Let the old filter drain into the pan for a minute or two. Wipe the filter mounting surface on the engine block clean with a rag to remove any dirt or old rubber seal.
Take the new filter and explore a thin layer of fresh oil to the rubber gasket on top of the filter—this helps create a good seal and makes removal easier next time. Screw the new filter on by hand until the gasket contacts the engine block, then turn it another three-quarters of a turn. Do not over-tighten; hand-tight plus three-quarters turn is the standard.
Start the engine and let it run for 30 seconds, then turn it off and wait a minute. Check the oil level on the dipstick and add oil as needed to reach the full mark. Dispose of the old filter and oil properly at a recycling center or auto parts store—most accept them for free.
OEM versus aftermarket filters for the Altima
Nissan factory filters cost more upfront but are engineered specifically for your engine and come with Nissan's quality may provide. They typically run $12 to $20 depending on where you buy them. Aftermarket filters from Fram, Mobil 1, Bosch, or Purolator cost $6 to $15 and perform well for most drivers, though some are thicker or thinner than OEM filters and may affect oil flow slightly.
The difference in performance between a quality aftermarket filter and an OEM filter is small for typical driving. The main trade-off is warranty coverage—if something goes wrong, Nissan will stand behind their own filter, while an aftermarket filter's warranty depends on the manufacturer. For routine maintenance, either type works fine as long as the part number matches your engine size and model year.
How often to change your Altima's oil filter
Nissan recommends changing the oil filter every time you change the engine oil. For most modern Altimas, that is every 3,000 to 7,500 miles, depending on your model year and driving conditions. Older Altimas (pre-2010) typically need oil changes every 3,000 miles, while newer models with synthetic oil can go 7,500 miles or longer between changes.
Check your owner's manual for the exact interval for your year. If you drive in severe conditions—frequent short trips, towing, dusty roads, or extreme heat—use the shorter interval. If you mostly drive on highways at steady speeds, the longer interval is usually safe. The filter should never go longer than the oil change interval; they wear out together.
Where to buy Nissan Altima oil filters
Nissan dealerships stock OEM filters and can order them if they do not have your specific part number in stock. Expect to pay a markup over retail prices. Auto parts retailers like AutoZone, O'Reilly, Advance Auto Parts, and NAPA carry both OEM and aftermarket filters and often have them in stock for same-day pickup. Online retailers like RockAuto and Amazon offer lower prices but require shipping time.
Big-box stores like Walmart and Target carry common aftermarket filters but may not have the exact part for your model year in stock. If you need the filter today, a local auto parts store is usually your fastest option. If you can wait a few days, online retailers often have the lowest prices, especially if you buy the filter and oil together.
Frequently Asked Questions
Can I use any oil filter on my Altima, or does it have to be Nissan brand?
You can use any filter that matches your engine size and model year, not just Nissan brand. The part number matters more than the brand name. Fram, Mobil 1, Bosch, and Purolator all make filters that fit Altimas correctly. Check the part number on the box against your owner's manual or a parts retailer website to make sure it matches your specific engine.
What happens if I over-tighten the oil filter?
Over-tightening can damage the rubber gasket and make the filter hard to remove next time. It can also cause the filter to leak oil. The standard is hand-tight plus three-quarters of a turn—you should be able to turn it by hand without a wrench. If you use a wrench, stop as soon as you feel resistance and do not force it further.
Do I need to drain the engine oil when I change just the filter?
No. You can change the filter without draining the oil. Some oil will spill out when you remove the old filter, but you do not need to remove the drain plug. Just position a drain pan under the filter, unscrew it, let it drain for a minute, and install the new one. Top off the oil level afterward if needed.
How much does it cost to have a dealership change my Altima's oil filter?
Nissan dealerships typically charge $30 to $60 for a filter-only service, depending on your location and whether you buy the filter from them or bring your own. Some dealerships offer package deals that include an oil change and filter for less than the cost of both separately. Call ahead for pricing and ask if they have your filter in stock.
Can I change the oil filter without lifting my Altima?
Most Altimas sit high enough that you can reach the filter from above without lifting the car. The filter is mounted on the driver's side of the engine block, usually accessible from the top. If you cannot reach it comfortably, you can use a low jack and jack stands to lift the car slightly, but this is rarely necessary for filter replacement alone.