The oil light resets differently depending on your model year and whether you have a traditional dashboard or a touchscreen
Toyota Corollas built after 2003 have an oil change reminder light that you must reset manually after you change the oil. The light does not turn off on its own—it stays on until you complete the reset sequence. The steps vary: older models (2003–2010) use dashboard buttons, mid-range models (2011–2018) use a combination of the ignition and dashboard controls, and newer models (2019 and later) often have a touchscreen menu where you can reset it directly.
The reset takes less than a minute and requires no tools or special knowledge. You do not need to visit a dealer. If you have just changed your oil yourself or had it done at an independent shop, resetting the light is your responsibility—many shops will do it for you, but not all, so it is worth asking before you leave.
Key Takeaways
- The oil change reminder light on a Toyota Corolla must be reset manually after every oil change; it will not turn off by itself.
- The reset method depends on your model year: button sequences for older models, ignition and odometer button combinations for mid-range models, and menu navigation for touchscreen models.
- You can reset the light yourself in under a minute without visiting a dealer or using any tools.
- If you had your oil changed at a shop, confirm whether they reset the light before you leave, because many do not do it automatically.
Reset steps for 2003–2010 Toyota Corollas
Older Corollas have a dedicated reset button on the dashboard, usually located to the left of the steering wheel or on the instrument panel itself. Turn the ignition to the "On" position without starting the engine. Look for a button labeled "Reset" or "Trip"—it may be recessed slightly into the dashboard. Press and hold this button for three to five seconds until the oil light blinks and then disappears.
If you cannot locate a reset button on your dashboard, check your owner's manual for the exact location—some models have it in a less obvious spot. If the light does not go out after holding the button, turn the ignition off, wait ten seconds, and try again. The light should extinguish on the second attempt.
Reset steps for 2011–2018 Toyota Corollas
Mid-range Corollas do not have a dedicated reset button. Instead, you use the odometer button (usually on the turn signal stalk or the dashboard) combined with the ignition. Turn the ignition to "On" without starting the engine. Press the odometer button repeatedly until the odometer display shows "Trip A" or "Trip B." Once you see the trip display, press and hold the odometer button for three to five seconds. The oil light should blink once and then turn off.
If the light does not reset, turn the ignition off, wait a few seconds, and repeat the sequence. Some 2011–2015 models require you to turn the ignition to "Acc" (accessory) instead of "On"—check your owner's manual if the standard method does not work. The key is holding the button long enough; a quick tap will not trigger the reset.
Reset steps for 2019 and newer Toyota Corollas with touchscreen
Newer Corollas with a touchscreen display have an on-screen menu for resetting the oil light. Turn the ignition to "On" without starting the engine. On the touchscreen, navigate to the "Settings" or "Vehicle" menu—the exact wording varies by model year. Look for an option labeled "Oil Change Reminder," "Maintenance," or "Service Reminder." Select it and choose "Reset" or "Clear." The light should turn off when ready.
If you cannot find the menu option, consult your owner's manual or the quick-reference card that came with your vehicle. Some models hide the reset function under "Driver information" or "Customization." Once you have reset it once, you will remember where the menu is for future oil changes.
What to do if the light stays on after you reset it
If you have followed the correct steps for your model year and the light is still on, the most common cause is that you did not hold the button or menu selection long enough. Try the reset sequence again, this time counting to five slowly while holding the button or waiting for the screen to confirm the reset.
A second possibility is that the light is not actually the oil change reminder but an oil pressure warning light, which looks similar but means something different. The oil change reminder is usually labeled "Oil Change Due" or shows an oil can icon with text. An oil pressure warning light typically shows an oil can with a thermometer or a red exclamation mark and means your engine oil pressure is low—this is a safety issue and you should not drive the car. Check your owner's manual to confirm which light you are looking at.
If you are certain you have the right light and the reset method is not working, the light bulb itself may be faulty, or there may be an electrical issue with the reminder system. This is rare, but a Toyota dealer can diagnose it with a scan tool if needed.
Why the oil light does not reset at the gas station or automatically
Toyota's oil change reminder is a maintenance counter, not a sensor. It does not measure how much oil is in your engine or how dirty the oil is—it straightforward counts down from the last reset. This is why it must be reset manually: the car has no way to know that you actually changed the oil unless you tell it by completing the reset sequence.
Some owners assume the light will turn off after a certain number of engine starts or miles driven, but it will not. It will stay on continuously until you reset it, which is why it is important to do this step right after an oil change. If you forget to reset it, the light will remain on for weeks or months, and you will lose the benefit of the reminder for your next oil change interval.
Resetting the light after an oil change at a shop
When you take your Corolla to a quick-lube shop, dealership, or independent mechanic for an oil change, ask them before you leave whether they reset the oil light. Many shops include this as part of the service, but some do not—it depends on their standard procedure and how busy they are. If they did not reset it, you can do it yourself using the steps above, or you can ask them to do it while you wait.
If you are doing the oil change yourself, reset the light as soon as you finish and before you drive the car. This way, the reminder will be accurate for your next oil change interval. Write down the date or mileage when you reset it so you know when the next change is due.
Frequently Asked Questions
Does resetting the oil light mean I have actually changed my oil?
No. The reset just tells the car to start counting down again. If you reset the light without changing the oil, the reminder will be inaccurate. Only reset the light after you have actually changed the oil and filter.
What if I reset the light by accident before my oil change?
You can reset it again when ready after you change the oil. There is no penalty for resetting it twice. Just make sure you do the reset after the oil change is complete, not before.
Will the oil light come back on if I ignore the reset?
No. The light will stay on continuously until you reset it manually. It does not cycle on and off. This is why it is straightforward to notice—you cannot miss it.
Can I reset the oil light while the engine is running?
It is safest to reset it with the engine off and the ignition in the "On" or "Acc" position. Some models allow reset while the engine is running, but turning off the engine first eliminates any confusion about which mode you are in.
Is there a way to reset the oil light from my phone or using the Toyota app?
No. The oil light reset must be done using the dashboard controls or touchscreen in the car itself. There is no remote reset option through a mobile app or website.