What Firestone Air Suspension Is

Firestone air suspension is an aftermarket suspension system that replaces your vehicle's factory springs with air-filled bellows. Instead of metal coils or leaf springs holding your car up, pressurised air does the work. A compressor fills and maintains those air bags, and an onboard computer adjusts the pressure to keep your ride height level no matter what weight you're carrying or how rough the road gets.

Firestone makes several versions: the Ride-Rite line for trucks and SUVs, the AirLift line for cars and light trucks, and the LoadLifter line specifically for towing and hauling. Each system includes air springs, a compressor, an air tank, lines, fittings, and either manual or electronic controls. You install it yourself or have a shop do it, and it becomes your new suspension.

The appeal is straightforward: you get a smoother ride, you can raise or lower your vehicle on demand, and you can level a sagging rear end when you're towing or carrying heavy cargo. But it's not a repair—it's a replacement of your entire suspension geometry, and that matters for how your car handles and wears.

Key Takeaways

  • Firestone air suspension replaces your factory springs with pressurised air bags controlled by a compressor and electronic valve block.
  • The system can be adjusted to raise, lower, or level your vehicle, which is useful for towing but changes how your suspension geometry works.
  • Installation requires removing your factory suspension components and routing air lines and electrical connections, a job that takes a full day or more.
  • Air suspension requires regular maintenance: checking air pressure, inspecting hoses for cracks, and replacing the compressor or air springs when they fail.
  • Firestone air suspension is an aftermarket upgrade, not a factory system, so warranty coverage and repair availability vary by installer and location.

How the System Actually Works Under Your Car

When you turn the key, the compressor draws air from the atmosphere, pressurises it, and stores it in an air tank. That tank feeds four air springs—one at each wheel corner—through a valve block that acts like a traffic controller. The valve block receives signals from a height sensor at each wheel, and an onboard computer reads those sensors constantly.

If you hit a pothole, the wheel drops and the sensor detects it. The computer tells the valve block to send more air to that spring, pushing the wheel back up. If you load 500 pounds in your truck bed, the rear sensors see the vehicle sag, and the system automatically adds air to the rear springs to keep the ride height level. If you press a button to raise the vehicle for off-road clearance, the computer vents air from the springs and lets them expand, lifting the chassis.

The compressor runs only when needed—when pressure drops below a set threshold or when you manually command a height change. This is why air suspension is quieter than you might expect: the compressor isn't running all the time. But it also means if the compressor fails or a hose ruptures, you lose pressure gradually and the vehicle sags. You don't get a sudden collapse, but you do lose the benefit of the system.

Installation: What Happens and What It Costs

Installation is not a bolt-on job. A technician has to remove your factory suspension—springs, shocks, struts, or whatever your vehicle came with—and install the air springs in their place. This means lifting the vehicle, removing wheels, unbolting suspension components, and often modifying brackets or control arms to fit the new air springs. The compressor and air tank mount in the engine bay or under the vehicle, and air lines run to each corner, requiring careful routing to avoid heat sources and moving parts.

Electrical work is equally involved. The height sensors, valve block, and compressor all need wiring routed through the vehicle and connected to a control module. If you want manual controls, a switch panel goes in the cabin. If you want electronic controls, the system integrates with your vehicle's existing electrical system or adds its own control unit. A full installation typically takes 8 to 16 hours, depending on your vehicle and whether the installer has to fabricate custom brackets.

Cost varies widely. A basic manual system for a truck might run $1,500 to $2,500 installed. A fully electronic system with all four corners independently adjustable can reach $3,500 to $5,000 or more. Labour is usually $75 to $150 per hour, so a 12-hour job adds $900 to $1,800 to the parts cost. Some shops offer kits you can install yourself, which saves labour but requires mechanical skill and access to a lift.

Why Air Suspension Changes How Your Vehicle Handles

Your factory suspension was engineered as a complete system: springs, shocks, control arms, and anti-roll bars all work together to control how the chassis moves, how weight transfers during cornering, and how the wheels stay in contact with the road. Air suspension replaces the springs but often keeps the original shocks and control arms. This changes the tuning of that system.

Air springs are stiffer than factory coil springs in most cases, and they don't absorb energy the way a spring does—they resist compression and then push back. Combined with your original shocks, this can make the ride feel different: sometimes firmer, sometimes bouncier, depending on how the compressor and valve block are tuned. The vehicle may sit higher or lower than stock, which changes the angle of your control arms and affects camber (wheel angle). That affects tire wear and handling.

For towing, this is often a benefit. A sagging rear end causes poor weight distribution and can make the trailer sway. Air suspension levels the vehicle under load, which improves stability and tire life. But for daily driving on smooth roads, some owners find the ride less refined than their factory suspension. This is why test-driving a vehicle with air suspension before committing is important—what feels good to one person feels harsh to another.

Maintenance and Common Failure Points

Air suspension requires more regular attention than factory springs. You should check air pressure every few months, especially before towing or carrying heavy loads. Pressure that's too low reduces the system's ability to support weight; pressure that's too high makes the ride harsh and can damage the air springs. The correct pressure is usually printed on a sticker in the driver's door jamb or in the Firestone documentation.

Air hoses are the most common failure point. They're rubber and they flex constantly. Over time, especially in cold climates or under UV exposure, they crack or develop pinhole leaks. A slow leak means the compressor runs more often to maintain pressure, and eventually the system can't keep up. You'll notice the vehicle sagging or the compressor running constantly. Hose replacement is straightforward but requires access to the lines, which may mean removing trim or suspension components.

Air springs themselves can fail, usually after 80,000 to 150,000 miles depending on driving conditions and maintenance. A failed spring loses pressure and can't be repaired—it must be replaced. The compressor can also fail, though this is less common. Replacement compressors run $400 to $800, and air springs run $200 to $400 each. Because this is an aftermarket system, you typically can't walk into a dealership and have it serviced; you need a shop familiar with Firestone products or the installer who put it in.

Warranty and Long-Term Reliability

Firestone air suspension systems come with a manufacturer's warranty—typically 3 years or 36,000 miles for parts, though this varies by product line and retailer. That warranty covers defects in the components themselves, not wear items like hoses or compressor seals. It does not cover installation labour or damage from improper maintenance.

Your vehicle's factory warranty is usually not affected by air suspension installation, but any suspension-related issues that arise after installation may not be covered by the dealer. If a wheel bearing fails or your steering feels loose, the dealer may argue that the air suspension installation altered the suspension geometry and caused the problem. This is a real risk, which is why choosing an experienced installer matters. A shop that has installed hundreds of systems knows how to do it without creating new problems.

Long-term reliability depends heavily on maintenance and climate. In dry climates with well-maintained roads, air suspension systems often last 150,000 miles or more. In cold, salty climates where roads are treated with de-icing chemicals, hoses and fittings corrode faster and failures are more common. Regular inspection—looking for cracks in hoses, corrosion on fittings, and listening for compressor noise—catches problems early.

Air Suspension vs. Coil-Over and Leaf Spring Upgrades

If you're looking to improve your suspension, you have other options. Coil-over kits replace your springs and shocks with a matched pair that can be adjusted for ride height and stiffness. They're cheaper than air suspension—typically $800 to $2,000 installed—and they don't require a compressor or electronics. You adjust them once and they stay put. The trade-off is that you can't adjust on the fly, and they don't automatically level under load.

Leaf spring upgrades, common on trucks, add extra leaves or replace the factory pack with a heavier-duty one. This costs $400 to $1,200 and raises the vehicle's load capacity without electronics. But it also raises the ride height permanently and can make the ride harsher on empty roads.

Air suspension wins if you tow regularly, carry variable loads, or want the ability to adjust your ride height without tools. It loses if you want simplicity, lower cost, or a suspension that doesn't require ongoing maintenance. For a truck that tows occasionally, a leaf spring upgrade might be enough. For a truck that tows weekly or carries heavy loads regularly, air suspension pays for itself in tire life and stability.

Frequently Asked Questions

Can I install Firestone air suspension myself?

Yes, if you have mechanical skill, a lift, and time. Firestone sells DIY kits with instructions, and many owners install them in a weekend or two. However, the electrical work and brake line routing require care—mistakes can affect safety. Most people hire a shop, which costs more but guarantees the job is done correctly.

What happens if the compressor fails while I'm driving?

The vehicle doesn't drop suddenly. Air pressure in the springs and tank keeps the vehicle up for hours or even days, depending on how much air is stored. You'll notice the compressor running constantly or the vehicle slowly sagging. You can still drive, but you should get it serviced soon. Continuing to drive on a failed compressor can damage the air springs.

Does air suspension affect my vehicle's warranty?

Your factory warranty typically remains valid for non-suspension items. However, any suspension-related failure after air suspension installation may not be covered by the dealer, who may claim the aftermarket system caused the problem. The Firestone warranty covers the air suspension components themselves, not factory parts that interact with it.

Is air suspension better for towing than factory suspension?

Yes, for most towing scenarios. Air suspension automatically levels the vehicle under load, which improves weight distribution, reduces trailer sway, and extends tire life. Factory suspension on many trucks sags under a heavy trailer, which can cause poor handling and accelerated tire wear. If you tow regularly, air suspension is a practical upgrade.

How often do I need to service air suspension?

Check air pressure every few months and before towing. Inspect hoses and fittings annually for cracks or corrosion. Have the system serviced by a shop if you notice the compressor running constantly, the vehicle sagging, or any loss of ride height control. Most systems need no major service if maintained properly, but components like hoses and compressors eventually wear out.