What you need before you start
Changing a flat tire takes about 15 to 30 minutes if you have the right tools and a safe place to work. Before you begin, make sure you have a spare tire, a jack, a lug wrench, and wheel wedges (or heavy rocks). Most cars come with these in the trunk. Check your owner's manual to find where they are stored — some vehicles keep the spare under the trunk floor or mounted on the back.
You also need a flat, stable surface away from traffic. If you get a flat on a highway, drive slowly to the nearest exit or pull as far onto the shoulder as possible. Turn on your hazard lights and set up a warning triangle or flares if you have them. Never change a tire on a slope or soft ground — the car can roll or sink.
Before you touch the tire, put on work gloves if you have them. The tire rim and bolts can be sharp or hot if you have been driving. If it is dark, use a flashlight or your phone's light.
Key Takeaways
- You need a spare tire, jack, lug wrench, and wheel wedges, all of which should be in your car already.
- Park on flat, stable ground away from traffic, turn on hazard lights, and loosen the lug nuts before you lift the car.
- Lift the car only high enough to remove the flat tire and install the spare, then lower it and tighten the lug nuts in a star pattern.
- A spare tire is a temporary fix — drive to a tire shop within a few days to have the flat repaired or replaced.
- If the spare is flat, the lug wrench does not fit, or the jack is broken, call roadside information rather than forcing it.
Loosen the lug nuts before lifting the car
This step is straightforward to skip and hard to fix later. While the car is still on the ground, use the lug wrench to turn each lug nut counterclockwise about a quarter turn. You do not need to remove them yet — just break them loose. The weight of the car makes this much easier than trying to loosen them after the tire is in the air.
If a lug nut will not budge, try turning the wrench the other direction to make sure you are going counterclockwise. If it still will not move, spray it with penetrating oil (like WD-40) and wait a few minutes. Do not use a hammer or pipe to extend the wrench — that can strip the nut or break the wrench. If it will not loosen, call roadside information.
Position the jack and lift the car
Look under the car near the flat tire and find the jack point — a reinforced notch or flat spot in the frame. Your owner's manual shows exactly where it is. Place the jack directly under this point, not under the bumper or body panel. If you use the wrong spot, the jack can slip and the car can fall.
Pump or crank the jack handle to lift the car slowly. Raise it until the flat tire is about six inches off the ground — high enough to remove it and fit the spare underneath. Stop lifting once the tire clears the ground. Do not go higher than necessary.
Remove the flat tire and install the spare
Now finish removing the lug nuts by hand and set them in a clean spot where you will not lose them. Pull the flat tire straight toward you with both hands. It will be heavy, so brace yourself. Set it flat on the ground next to you.
Lift the spare tire and line up the holes with the bolts on the wheel hub. Push it straight onto the bolts until it sits flush against the hub. This takes some force — do not be afraid to push hard. Once it is seated, thread the lug nuts back on by hand and tighten them snugly, but do not use the wrench yet.
Lower the car and tighten the lug nuts properly
Slowly lower the car by turning the jack handle or pump in reverse. Lower it until the spare tire touches the ground and the car's weight is resting on it. You can then remove the jack completely.
Now use the lug wrench to tighten the lug nuts. Tighten them in a star pattern — if you imagine the wheel as a clock face, tighten the nut at 12 o'clock, then 6 o'clock, then 3 o'clock, then 9 o'clock, then any remaining nuts. This keeps the wheel balanced and seated evenly. Tighten each nut firmly, but do not over-tighten — you should feel resistance, not have to strain.
Get the flat tire repaired or replaced soon
A spare tire is not meant for long-term driving. Most spares are rated for 50 miles per hour and should not be driven more than 70 miles. Some compact spares are good for only 50 miles. Check the sidewall of your spare to see its speed rating and mileage limit.
Drive to a tire shop within a few days to have the flat tire inspected. If the puncture is small and in the tread, it can usually be patched for $10 to $25. If the sidewall is damaged, the tire cannot be repaired and must be replaced. Keep the flat tire in your trunk until you know whether it can be fixed — you may need it as a spare again.
What to do if something goes wrong
If a lug nut is stuck and will not loosen, or if the jack is broken or does not fit, do not force it. Forcing a stuck nut can strip it, and forcing a jack can damage the car or cause injury. Call roadside information instead. Most auto insurance policies include roadside service, and many credit card companies offer it as a cardholder benefit.
If the spare tire is flat or damaged, you cannot use it. Call a tow truck to take you to a tire shop. If you have a full-size spare (some trucks and SUVs do), follow the same steps as above — the only difference is that you can drive it normally without speed or distance limits.
Frequently Asked Questions
Can I change a tire in the rain or snow?
Yes, but it is harder and takes longer. Wear gloves to keep your hands dry and warm. Work slowly to avoid dropping the lug nuts in the snow. If the ground is very slippery, place wheel wedges or heavy rocks behind the wheels that are still on the ground to prevent the car from rolling.
What if I do not have a spare tire?
Some newer cars come with a tire repair kit instead of a spare. The kit includes a sealant canister that you attach to the tire valve and inflate to seal small punctures. Follow the instructions on the kit. If the puncture is too large or the kit does not work, call a tow truck.
Do I need to tighten the lug nuts again after driving?
Yes. After driving 20 to 30 miles on a newly changed tire, stop and re-tighten the lug nuts with the wrench. The wheel can settle slightly, and the nuts may loosen a bit. Check them again before your next long drive.
Can I change a tire on a hill or slope?
No. The car can roll or the jack can slip on uneven ground. If you get a flat on a hill, drive slowly to flat ground even if it damages the tire further. A new tire costs less than an accident or injury.
What if the lug wrench does not fit the lug nuts?
Some cars have lug nuts that require a special socket or key. Check your owner's manual or the lug nut itself for the size. If you do not have the right wrench, call roadside information. Do not try to force a wrench that does not fit — you can strip the nut.