What you need before you start
You can change a punctured tyre yourself if you have the right tools and a safe place to work. You will need a spare tyre (check that it holds air), a jack (usually comes with your car), a lug wrench (the cross-shaped tool for loosening wheel bolts), and wheel chocks or heavy objects to block the wheels. A torch is useful if you are changing the tyre in low light. You do not need special training, but you do need to follow the steps in order and work on level, solid ground — not on a slope or soft surface where the car could roll.
Before you start, turn on your hazard lights and move away from traffic if you are on a road. If you are on a motorway, call roadside information instead — changing a tyre in moving traffic is dangerous. For a normal road or car park, find the flattest, most stable spot you can reach and turn off the engine.
Key Takeaways
- Place wheel chocks behind the wheels that will stay on the ground, then loosen the lug nuts before you jack the car up.
- Raise the car only high enough to remove the old tyre, keeping the jack directly under the car's frame — never under plastic trim.
- Put the spare tyre on hand-tight first, then lower the car and tighten the lug nuts in a star pattern with the wrench.
- Drive slowly to a tyre shop or garage to have the punctured tyre repaired or replaced, because a spare is not a permanent fix.
- Check your spare tyre's air pressure every few months so it will hold air when you need it.
Loosening the lug nuts before jacking
This step is straightforward to skip and very hard to fix if you do. With the car still on the ground, use the lug wrench to loosen (but do not remove) each lug nut by a quarter turn. You are breaking the seal, not taking them off. The car's weight makes this much easier than trying to loosen them after the wheel is in the air and spinning freely.
If a lug nut is stuck, do not force it — you can strip the bolt or hurt yourself. Spray it with penetrating oil, wait a few minutes, and try again. If it still will not budge, this is the moment to call for roadside information rather than damage the wheel.
Positioning the jack and raising the car
Place wheel chocks (or rocks, or a heavy piece of wood) behind the wheels that will stay on the ground — both wheels on the opposite end of the car from the punctured tyre. This stops the car rolling while you work. Consult your owner's manual to find the correct jacking point on your car's frame — it is usually a reinforced notch or lip near the wheel. Never jack under plastic trim, the sump, or the fuel tank.
Position the jack directly under the jacking point and raise the car slowly until the punctured tyre is about 15 centimetres (6 inches) off the ground. You only need enough clearance to remove the old tyre and fit the new one. Stop raising once the tyre clears the ground — the higher you go, the less stable the car becomes.
Removing the old tyre and fitting the spare
Now remove the lug nuts completely and set them somewhere you will not lose them — a cup or a cloth on the ground works. Pull the punctured tyre straight towards you with both hands. It may be tight; if so, rock it gently side to side as you pull. Once it is off, set it flat on the ground so it does not roll away.
Lift the spare tyre and align the holes with the bolts on the wheel hub. Push it on firmly until it sits flush against the hub. Screw the lug nuts back on by hand first, turning them clockwise until they are snug but not tight. This keeps the tyre centred while you work.
Tightening the lug nuts and lowering the car
Lower the car slowly until the spare tyre touches the ground and bears some weight, but keep the jack in place. Now use the lug wrench to tighten the lug nuts properly. Tighten them in a star or cross pattern — if the bolts are at 12, 3, 6, and 9 o'clock, tighten 12, then 6, then 3, then 9. This pulls the tyre evenly onto the hub. Tighten each nut firmly, but do not over-tighten — you are aiming for snug, not maximum force.
Once all the lug nuts are tight, lower the car fully by releasing the jack slowly. Remove the jack and the wheel chocks. Check that all the lug nuts are still tight by giving each one a final quarter turn with the wrench.
What to do after you have changed the tyre
A spare tyre is a temporary fix, not a permanent one. Drive slowly — no faster than 80 kilometres per hour (50 miles per hour) — to a tyre shop or garage as soon as you can. The shop will inspect the punctured tyre to see if it can be repaired (most small punctures can be) or whether it needs to be replaced. Once the punctured tyre is fixed or replaced, have it put back on the car and the spare returned to its storage location.
Check your spare tyre's air pressure every few months, even if you have not used it. A spare that has lost air will not help you when you need it. Your owner's manual will tell you the correct pressure for your spare — it is often higher than the pressure for your regular tyres.
When to call for roadside information instead
Do not attempt to change a tyre if you are on a motorway or in heavy traffic, if the car is on a slope or soft ground, if you do not have a working jack and wrench, or if the lug nuts are so tight you cannot loosen them by hand. Call your breakdown cover provider or a local towing service — this is what they are there for, and it is safer than struggling alone in a dangerous location.
If you have changed the tyre but the spare is also flat or damaged, or if you notice the car is pulling to one side or the steering feels wrong after you have fitted the spare, do not drive. Call for information and have the car towed to a garage.
Frequently Asked Questions
Can I drive long distances on a spare tyre?
No. Spare tyres are designed for short journeys to a garage only, usually at low speed. Driving long distances on a spare can damage the wheel, overheat the tyre, and make the car unstable. Get the punctured tyre repaired or replaced as soon as you can.
What if I do not have a spare tyre?
Some modern cars come with a tyre repair kit instead of a spare. Follow the instructions on the kit to seal the puncture temporarily, then drive slowly to a garage. If you have neither a spare nor a repair kit, call roadside information or a towing service.
Do I need to tighten the lug nuts again after driving?
Yes. After driving for a short distance on the spare, stop and check that all the lug nuts are still tight. They can loosen slightly as the tyre settles. Tighten them again in a star pattern if needed.
Can I change a tyre in the rain?
Yes, but it is harder and more slippery. Wear gloves for grip, work slowly, and be extra careful that the car does not roll. If you are on a busy road in heavy rain, it is safer to call for information and wait in the car with hazard lights on.
What if the punctured tyre cannot be repaired?
The garage will tell you whether the puncture is repairable or whether the tyre needs to be replaced. Most small punctures in the tread can be patched. Large punctures, damage to the sidewall, or multiple punctures usually mean the tyre must be replaced.