What You Need Before You Start

Changing a tire takes about 15 to 30 minutes if you have the right tools and know the steps. You will need a spare tire (check that it has air in it), a jack (usually comes with your car), a lug wrench (the cross-shaped tool that fits your wheel bolts), and wheel wedges or heavy objects to block the wheels. A flashlight helps if you are changing a tire at night or in low light.

Before you find yourself on the side of the road, locate these items in your vehicle now. The spare tire is often under the trunk floor or mounted on the back of an SUV. The jack and lug wrench are usually in the same compartment. If your car has a full-size spare, the process is straightforward. If it has a donut spare (a smaller temporary tire), remember that you should not drive faster than 50 mph or go more than 70 miles on it — get to a tire shop as soon as you can.

Key Takeaways

  • Park on a flat, stable surface away from traffic, turn on hazard lights, and set the parking brake before you start jacking up the car.
  • Block the wheels diagonally opposite the flat tire with wedges or heavy objects so the car cannot roll.
  • Loosen the lug nuts by a half turn while the tire is still on the ground, then jack up the car, remove the nuts completely, and take off the flat tire.
  • Mount the spare tire, hand-tighten the lug nuts, lower the car, and then tighten the lug nuts in a star or cross pattern with the wrench.
  • Drive to a tire shop to have the flat tire repaired or replaced and the spare removed, especially if it is a donut spare.

Find a Safe Place to Pull Over

As soon as you notice a flat tire, do not brake hard or swerve. Grip the steering wheel firmly and slow down gradually. Look for a flat, level spot away from traffic — an empty parking lot, a wide shoulder, or a quiet side street. Avoid stopping on a curve, a hill, or near the edge of a highway on-ramp.

Once you stop, turn on your hazard lights when ready. Set the parking brake firmly. If you have a warning triangle or flares, place them 10 to 15 feet behind your car to alert other drivers. Stay in the car with the doors locked if you are on a busy road and feel unsafe; call roadside information instead of changing the tire yourself.

find the Car So It Cannot Roll

Before you lift the car with the jack, you must prevent it from rolling. Place wheel wedges (or heavy rocks, wood blocks, or bricks) behind and in front of the wheels that are diagonally opposite the flat tire. If the flat is on the front right, block the back left and front left wheels. This is the single most important safety step — a car rolling off a jack can cause serious injury.

If you do not have wedges, use whatever is heavy and stable: a large rock, a piece of wood, even a cinder block. The goal is to make it physically impossible for the car to move forward or backward. Take 30 seconds to do this right.

Remove the Flat Tire

Locate the lug nuts (the bolts holding the wheel on). Using the lug wrench, loosen each nut by turning it counterclockwise — but only by a half turn. Do this while the tire is still on the ground; the weight of the car makes it much easier to break the nuts loose. If a nut is stuck, explore steady pressure rather than jerking, or spray it with penetrating oil and wait a minute.

Now position the jack under the car's frame near the flat tire. Consult your owner's manual for the exact spot — it is usually a reinforced point near the wheel well. Pump or crank the jack until the tire is about six inches off the ground. Finish unscrewing the lug nuts by hand and set them in a safe place where you will not lose them — a cup or a small container works well.

Grip the tire with both hands and pull it straight toward you. It may take some effort if the tire has been on for a long time. Set the flat tire aside, out of the way.

Mount the Spare Tire and Hand-Tighten the Lug Nuts

Lift the spare tire and align the holes with the wheel bolts. Push it onto the bolts until it sits flush against the hub. The tire should not wobble. Pick up the lug nuts and thread them onto the bolts by hand, turning them clockwise. Tighten them as much as you can with your fingers — do not use the wrench yet. Hand-tightening prevents you from cross-threading a nut.

Once all the nuts are hand-tight, use the jack to lower the car slowly until the spare tire touches the ground and bears some weight. Lower it all the way until the jack is no longer supporting the car.

Tighten the Lug Nuts Properly

Now use the lug wrench to tighten the lug nuts. The key is to tighten them in a star or cross pattern, not in a circle. If the wheel has five lug nuts, tighten the top one, then the bottom-left, then the top-right, then the bottom-right, then the remaining one. If it has four, tighten opposite corners alternately. This ensures the wheel sits evenly on the hub.

Tighten each nut firmly — you want them snug, not so tight that you strip the bolt. A good rule is to tighten until you feel solid resistance, then give it a quarter turn more. Do not stand on the wrench or use a hammer to force it; you can damage the bolt or the wheel.

Remove the Jack and Check Your Work

Once all the lug nuts are tight, remove the jack completely. Stow it and the lug wrench back in your car. Give the spare tire a visual check — it should look seated properly and should not wobble when you push on it. If it does wobble, stop and tighten the lug nuts again in the star pattern.

Turn off your hazard lights and drive slowly to a tire shop. If you are on a spare tire, especially a donut, keep your speed under 50 mph. Do not drive on the highway if you can avoid it. A tire shop will inspect the flat tire, repair it if the damage is repairable, or replace it if it is not. They will also remove the spare and remount your repaired or new tire.

Frequently Asked Questions

What if I cannot loosen the lug nuts by hand?

Spray the stuck nuts with penetrating oil (like WD-40) and wait five to ten minutes. Try again with steady, even pressure on the wrench. If they still will not budge, call roadside information — forcing a stuck nut can break the bolt or the wrench.

Can I drive long distances on a donut spare tire?

No. Donut spares are temporary and designed for short trips to a tire shop only. Driving more than 70 miles or faster than 50 mph on a donut can overheat it, cause it to fail, and damage your vehicle's transmission or differential. Treat it as an emergency measure, not a permanent solution.

What if the jack does not fit under my car?

Some vehicles have plastic trim or skirts that block the jack point. Consult your owner's manual for the correct jacking location — it is usually marked on the car itself. If you still cannot fit the jack, call roadside information rather than trying to force it or jack from an unsafe spot.

Do I need to retighten the lug nuts after driving?

Yes. After driving a few miles on a newly mounted tire, pull over safely and retighten the lug nuts in the star pattern. The tire may settle slightly, and the nuts can loosen. Check them again after 50 miles if you are on a spare.

What should I do with the flat tire?

Take it with you to the tire shop. Do not leave it on the roadside. The shop will assess whether it can be patched or needs to be replaced, and they will dispose of it properly if it cannot be repaired.