What happens when you change a tyre yourself

Changing a tyre means removing the wheel from your car, taking off the damaged or flat tyre, fitting a new or repaired one, and putting the wheel back on. You do this with a jack (a device that lifts the car), a lug wrench (which loosens the bolts holding the wheel), and a spare tyre. The whole job takes 15 to 30 minutes once you know the steps, and it costs you nothing except the price of a replacement tyre later.

Most people change a tyre because they have a puncture — a hole from a nail, glass, or sharp object — or because the tyre has worn so thin it is no longer safe. A flat tyre is not always a puncture; sometimes the valve leaks or the tyre loses pressure over weeks. If you can get the tyre to a repair shop, they may patch a small puncture for £10 to £20. If the damage is too large or the tyre is old, you will need a new one, which costs £40 to £150 depending on the tyre size and quality.

Key Takeaways

  • You need a jack, a lug wrench, and a spare tyre; most cars come with these in the boot, though some modern cars have a space-saver spare that is smaller and temporary.
  • Always park on a flat, firm surface away from traffic, turn on your hazard lights, and loosen the lug nuts before you lift the car.
  • Lift the car only high enough to remove the wheel, keep the jack on solid ground, and never work under a car supported only by a jack.
  • After fitting the spare, drive slowly to a tyre shop to have the punctured tyre repaired or replaced and the spare removed.
  • If you are not confident or the car is on a slope or soft ground, call roadside information rather than risk injury.

What you need before you start

Check your boot for a jack, a lug wrench, and a spare tyre. Most cars come with these as standard. The jack is usually a small metal device that fits into a slot in the boot; the lug wrench is a cross-shaped or L-shaped metal tool; the spare is either a full-size tyre that matches your others or a smaller temporary one called a space-saver. If your car is missing any of these, you cannot change the tyre yourself and must call for roadside information.

Inspect your spare tyre before you need it. Press it with your thumb — it should feel firm, not soft or spongy. If it is flat or nearly flat, take it to a petrol station and inflate it to the pressure shown on the label inside your driver's door. A flat spare is useless in an emergency. Also check that the lug wrench fits the bolts on your wheels; some cars have locking bolts that need a special socket, which should be in the boot with the wrench.

Finding a safe place to stop and change the tyre

Do not change a tyre on the motorway or on a busy road. If you have a puncture on a motorway, turn on your hazard lights, slow down, and drive to the next service area or exit. If you cannot reach one, pull as far onto the hard shoulder as possible, turn on your hazard lights, and call roadside information. The risk of being hit by passing traffic is far greater than the cost of a tow.

On a quieter road, pull over as far from traffic as you can. Park on a flat, firm surface — not on gravel, mud, or a slope. If you are on a slight slope, position the car so the punctured wheel is on the downhill side; this helps the jack stay stable. Turn on your hazard lights so other drivers see you. If it is dark, turn on your headlights or use a torch so you can see what you are doing.

Loosening the lug nuts before lifting the car

This step is crucial and often forgotten: loosen the lug nuts while the car is still on the ground. The weight of the car holds the wheel steady, so the nuts come off more easily. If you wait until after you lift the car, the wheel will spin as you turn the wrench, and you may not be able to loosen the nuts at all.

Fit the lug wrench onto one of the bolts holding the wheel. Push or pull the wrench firmly — do not jerk it, as this can round off the bolt. Turn the wrench a quarter turn to loosen the nut; you do not need to remove it completely yet, just break it free. Do this for all the bolts on the wheel. Then you can lift the car.

Lifting the car and removing the wheel

Locate the jacking point on your car. This is a reinforced spot on the chassis designed to support the jack; it is usually marked by a small notch or raised area just behind the front wheel or just in front of the rear wheel. Consult your owner's manual if you cannot find it — using the wrong spot can damage the car or cause the jack to slip.

Position the jack on firm, level ground directly under the jacking point. Pump or turn the jack handle to lift the car slowly. Stop when the wheel is about 15 centimetres (6 inches) off the ground — high enough to remove the wheel but not so high that the car is unstable. Never work under a car supported only by a jack; if the jack fails, the car will fall on you. If you are nervous, place a concrete block or sturdy wood under the car as a backup support, though this is not a substitute for using the jack correctly.

Now finish removing the lug nuts by hand and set them somewhere you will not lose them — a cup or small container works well. Grip the wheel firmly and pull it straight toward you. It may be stuck; if so, rock it gently side to side or tap the tyre with your foot to loosen it. Once it comes free, set it flat on the ground so it does not roll away.

Fitting the spare tyre and tightening the bolts

Align the holes on the spare tyre with the bolts sticking out from the hub (the centre of the wheel). Push the spare straight onto the bolts until it sits flush against the hub. This takes some force; do not be afraid to push hard. Once it is seated, thread the lug nuts back on by hand and tighten them finger-tight — snug but not with all your strength.

Lower the car by turning the jack handle in reverse. Lower it slowly until the spare tyre is resting on the ground and the car's weight is off the jack. Then use the lug wrench to tighten the lug nuts fully. Tighten them in a star or cross pattern — if the bolts are at 12, 3, 6, and 9 o'clock, tighten 12, then 6, then 3, then 9. This ensures the wheel sits evenly. Tighten each bolt firmly but do not over-tighten; if you have to strain hard, you have done enough.

What to do after you fit the spare

Pack the punctured wheel, jack, and lug wrench back into the boot. Do not leave them at the roadside. If you used a space-saver spare (the smaller temporary one), remember that it is not designed for long-term use; drive slowly and carefully to a tyre shop, keeping your speed below 80 kilometres per hour (50 miles per hour) if possible. Space-savers can overheat and fail if driven too fast or too far.

Even if you fitted a full-size spare, drive to a tyre shop as soon as you can. Have the punctured tyre inspected to see if it can be repaired or if it needs to be replaced. Once the shop has repaired or replaced it, ask them to refit it to the car and remove the spare. Check that all four tyres are now properly inflated to the pressure shown inside your driver's door.

When to call for roadside information instead

Do not attempt to change a tyre if the car is on a slope, on soft ground like mud or sand, or in a dangerous location like a motorway. Do not attempt it if you do not have all the tools or if your spare is flat. Do not attempt it if you are injured, unwell, or uncomfortable working near traffic. Roadside information costs £50 to £150 depending on your provider and location, but it is worth it if the alternative is injury or damage to your car.

If you have breakdown cover through your car insurance or a membership with a motoring organisation like the AA or RAC, call them first — the service is usually included in your membership. If you do not have cover, search online for local tyre shops or recovery services and ask for a quote before you commit. Many will come to you rather than tow the car to their premises.

Frequently Asked Questions

Can I change a tyre in the rain or at night?

Yes, but it is harder and more dangerous. In rain, the ground is slippery and the jack may not grip properly; at night, you cannot see what you are doing. If you must change a tyre in these conditions, use a torch or headlights, work slowly, and consider calling roadside information if you feel unsafe.

What if the lug nuts are stuck and I cannot loosen them?

Spray the bolts with penetrating oil like WD-40 and wait 10 to 15 minutes for it to soak in. Try again with the lug wrench, pushing down on the handle with your full weight rather than jerking it. If they still will not budge, call roadside information; forcing a stuck bolt can round it off and make it impossible to remove.

Do I need to replace the spare tyre after I use it?

No. A space-saver spare is temporary and should be removed once the punctured tyre is repaired or replaced. A full-size spare can be used as a regular tyre, but have the punctured tyre fixed or replaced so you have a spare again for next time.

How do I know if my spare tyre is the right size?

Check the sidewall of your punctured tyre and the sidewall of the spare. They should show the same size code, such as 205/55R16. If the spare is smaller (a space-saver), it will say so on the tyre. Your owner's manual also lists the correct spare size.

What if the punctured tyre cannot be repaired?

A tyre shop will tell you whether a puncture can be patched or whether the tyre must be replaced. Punctures in the tread (the part that touches the road) can usually be repaired; punctures in the sidewall cannot. A new tyre costs £40 to £150 depending on size and quality, and the shop can fit it while you wait.