What to do when your tire pressure monitor light comes on

A tire pressure monitor light means your car's sensors have detected that at least one tire is underinflated or overinflated, or that a sensor itself has failed. The light is usually a yellow exclamation mark inside a tire shape on your dashboard. The fastest fix is to check all four tires with a manual gauge, inflate or deflate them to the pressure listed on your driver's door jamb (not the sidewall of the tire), and then drive for a few miles so the system can recalibrate. If the light stays on after that, the problem is either a faulty sensor or a slow leak you haven't found yet.

Most tire pressure monitor systems reset automatically once all tires are at the correct pressure and the car has been driven. Some vehicles have a manual reset button under the steering wheel or in the glove compartment — your owner's manual will say whether yours does. If you've checked the pressure and the light won't go away, you're looking at either a bad sensor (which costs $50 to $200 per sensor to replace) or a puncture that needs a patch or plug.

Key Takeaways

  • Check all four tires with a gauge and inflate them to the pressure printed on your driver's door jamb, not the number on the tire sidewall.
  • Drive the car for a few miles at normal speed so the tire pressure monitor system can detect that pressures are correct and reset the light.
  • If the light stays on after proper inflation, you likely have a faulty sensor, a slow leak, or a puncture that needs repair.
  • A tire pressure sensor replacement costs between $50 and $200 per sensor depending on your vehicle and whether you do it yourself or use a shop.
  • Cold weather can cause tire pressure to drop naturally, so check pressure when tires are cold (before driving or at least three hours after driving).

Check tire pressure before assuming the sensor is broken

The most common reason the light comes on is straightforward underinflation. Temperature changes, especially a drop into cold weather, cause air inside tires to contract and pressure to fall. A tire that was at 32 psi in summer might drop to 28 psi in winter without any leak. Your car's sensors are set to alert you when pressure falls below a certain threshold — usually 25 percent below the recommended pressure.

Buy or borrow a tire pressure gauge (digital gauges are more reliable than stick gauges and cost $10 to $20). Check all four tires when they are cold — either before you've driven the car that day or at least three hours after driving, when the tires have cooled. Write down what you find. Then look at the driver's door jamb (the inside edge of the door frame) for a sticker that shows the correct pressure. It will list two pressures: one for the front tires and one for the rear. Inflate or deflate each tire to match.

After you've adjusted the pressure, drive the car normally for 10 to 20 minutes. The system needs to cycle through and detect that pressures are now correct. The light should go out on its own. If it doesn't, move to the next step.

Look for a manual reset button or procedure

Some vehicles have a tire pressure monitor reset button that forces the system to recalibrate. It is usually located under the steering wheel, in the glove compartment, or on the dashboard near the steering column. Check your owner's manual for the exact location and whether your car has one. If it does, press and hold the button until the light blinks three times, then release. Start the car and drive for a few minutes to let the system reset.

Other vehicles require you to use the steering wheel controls or infotainment screen to access the tire pressure monitor menu and select a reset option. Again, your owner's manual will walk you through this. If you don't have the manual, search online for "[your year, make, model] tire pressure monitor reset" and you'll find step-by-step instructions for your specific car.

Identify a slow leak or puncture

If the light stays on after you've inflated the tires to the correct pressure and attempted a reset, one of your tires is losing air. A slow leak can be hard to spot because the tire may look normal even though pressure is dropping. The leak could be from a puncture (a nail, screw, or sharp object in the tread), a damaged valve stem, a crack in the sidewall, or a bead leak where the tire meets the rim.

The easiest way to find a leak is to mix a spray bottle with dish soap and water, spray it on each tire (especially around the valve stem and the bead), and look for bubbles. Bubbles mean air is escaping. Mark the spot with a pen or piece of tape. If you find a puncture in the tread, a tire shop can patch it for $10 to $25. If the leak is in the sidewall, the tire cannot be repaired and must be replaced. If the valve stem is leaking, it can usually be replaced for $5 to $15.

If you can't find a visible leak but the tire keeps losing pressure, the leak may be at the bead (where the tire sits on the rim). This usually requires a tire shop to dismount the tire, inspect the rim, and reseat the tire. The cost varies but is typically $50 to $100.

When a tire pressure sensor has failed

If you've confirmed that all tires are at the correct pressure, you've reset the system, and the light is still on, the problem is almost certainly a faulty tire pressure sensor. Each tire has a small electronic sensor inside the tire or mounted on the valve stem. These sensors can fail due to age, corrosion, a dead battery inside the sensor, or physical damage.

A failed sensor must be replaced. The cost depends on the type of sensor your car uses and whether you replace it yourself or have a shop do it. Direct sensors (mounted on the valve stem) are cheaper and easier to replace — you can often do it yourself with basic tools for $50 to $100 total. Indirect sensors (which measure pressure by monitoring wheel speed) are part of the antilock brake system and require a shop visit, usually costing $150 to $200 per sensor.

Before you pay for a replacement, ask a tire shop to scan your car's computer to confirm which sensor has failed. Most shops will do this for free or for a small diagnostic fee. Once you know which tire has the bad sensor, you can decide whether to replace it yourself (if it's a direct sensor) or take it to a shop.

Temporary solutions if you can't fix it right away

The tire pressure monitor light is a warning, not an emergency stop signal. If a sensor is broken and you're waiting for a replacement, or if you're dealing with a slow leak you haven't located yet, you can still drive the car safely as long as you check tire pressure manually every week. Use your gauge to verify that all four tires are at the correct pressure. If any tire is losing more than 2 to 3 psi per week, there's an active leak that needs repair soon.

Do not ignore a tire that is losing pressure rapidly. A severely underinflated tire can overheat, fail suddenly, and cause a blowout. If a tire drops below 20 psi, do not drive the car — have it towed or drive very slowly to the nearest tire shop.

Frequently Asked Questions

Can I drive with the tire pressure monitor light on?

Yes, as long as your tires are actually at the correct pressure. If the light is on because of a faulty sensor, the tires themselves are fine. If the light is on because a tire is underinflated, you can drive it, but check pressure weekly and repair any leak you find. Do not drive if a tire is severely underinflated (below 20 psi).

Why does the light come on in winter?

Cold air contracts, so tire pressure naturally drops when the temperature falls. A 10-degree drop in outside temperature can lower tire pressure by 1 to 2 psi. Check and adjust pressure when the weather changes, especially in fall and winter.

Do I need to replace all four sensors if one fails?

No. You only need to replace the sensor that has failed. However, if your car is older and all four sensors are the same age, they may all fail soon. Some shops recommend replacing all four at once to avoid repeated visits, but it's not required.

What's the difference between the tire sidewall pressure and the door jamb pressure?

The sidewall shows the maximum pressure the tire can safely hold. The door jamb shows the correct pressure for your car's weight and suspension. Always inflate to the door jamb pressure, not the sidewall pressure. Using the sidewall pressure will overinflate your tires and cause uneven wear.

Can I reset the tire pressure monitor myself without going to a shop?

Yes, in most cases. Check pressure, inflate to the correct level, drive for 10 to 20 minutes, and the light should reset on its own. If your car has a manual reset button, use it. If the light stays on after that, the problem is a leak or a faulty sensor, which usually requires a shop visit.