The tire pressure light reset process depends on your CR-V model year

Honda CR-Vs from 2007 onward have a Tire Pressure Monitoring System (TPMS) that displays a light on your dashboard when one or more tires fall below the target pressure. Resetting the light is not the same as fixing the underlying pressure problem — you must first inflate your tires to the correct pressure, then clear the warning from the dashboard. The reset method varies slightly by model year, but all CR-Vs use either a dashboard button or the infotainment menu.

The target pressure for your CR-V is printed on a sticker inside the driver's door jamb, not on the tire sidewall itself. That sidewall number is the tire's maximum pressure, which is higher than what Honda recommends. Check your door jamb sticker first, inflate all four tires to that pressure using a reliable gauge, then follow the reset steps for your model year.

Key Takeaways

  • The correct tire pressure for your CR-V is on the driver's door jamb sticker, not the tire sidewall, and typically ranges from 32 to 36 psi depending on model year and trim.
  • You must physically inflate the tires to the correct pressure before resetting the light — the light will not clear if pressure is still low.
  • CR-Vs from 2007 to 2014 use a dashboard button near the steering wheel; CR-Vs from 2015 onward use the infotainment touchscreen menu.
  • The reset process takes less than a minute once tires are properly inflated, and you do not need a dealer or special equipment.

Reset steps for 2007 to 2014 CR-V models

Locate the TPMS reset button on the left side of the steering column, below the dashboard. It is a small round button, usually black or gray, and may be labeled "TPMS" or "SET." With the engine off or in the accessory position (key turned one click without starting), press and hold this button for three seconds until you see the tire pressure light blink twice on the dashboard. Release the button — the light should turn off within a few seconds.

If the light does not turn off, turn the key to the off position, wait 30 seconds, and repeat. Some 2007 to 2009 models require the engine to be running during the reset; if the button method does not work, start the engine and try again. Once the light is off, drive the vehicle for a few minutes at highway speed to allow the TPMS sensors to recalibrate and confirm all pressures are correct.

Reset steps for 2015 and newer CR-V models

Turn the key to the accessory position without starting the engine. Press the menu button on the steering wheel or use the touchscreen to navigate to Settings, then Vehicle, then TPMS Calibration or Tire Pressure. The exact menu path varies by infotainment system (some use Maintenance instead of Vehicle), but the TPMS option is always in the settings area. Select Calibrate or Reset and confirm when prompted.

The dashboard light should turn off when ready. If your CR-V has a physical button on the dashboard instead of a touchscreen (some 2015 to 2017 models), look for a small button labeled "TPMS" or "SET" on the lower left of the instrument panel. Press and hold it for three seconds until the light blinks twice, then release. Drive for a few minutes to confirm the sensors have recalibrated.

What to do if the light comes back on after reset

A light that returns within a few minutes of reset means at least one tire is still below the target pressure. Check all four tires with a reliable gauge — do not rely on visual inspection or a gas station air pump's built-in gauge, which are often inaccurate. Inflate any tire that is more than 2 psi below the door jamb target, then repeat the reset process.

If the light returns after you have confirmed all tires are at the correct pressure, one of your TPMS sensors may be faulty. TPMS sensors are small battery-powered devices mounted inside each wheel and typically last five to ten years. A failed sensor will trigger the light even when pressure is correct. You will need a dealer or tire shop to diagnose which sensor has failed and replace it — this is not a DIY reset issue.

Tire pressure changes with temperature and driving conditions

Your tire pressure naturally drops in cold weather — roughly 1 psi for every 10 degrees Fahrenheit below 70 degrees. If the TPMS light appears only in winter, this is normal. Check your tires and inflate them to the door jamb pressure, then reset the light. As the weather warms, the pressure will rise again, and the light should not return.

Tire pressure also increases slightly during and when ready after driving due to heat buildup. Always check pressure when tires are cold — either first thing in the morning or at least three hours after driving. If you check pressure right after a drive and find it high, wait a few hours and recheck before inflating further.

Why the TPMS light is not the same as a low-pressure warning

Honda CR-Vs display two different warnings for tire pressure: the TPMS light (usually a tire with an exclamation mark) and a low-pressure warning message on the instrument cluster. The TPMS light indicates that one or more sensors has detected pressure below the target. The low-pressure message is a separate alert that appears when pressure drops significantly — usually 25% below target or lower.

If you see the low-pressure message, your tires are dangerously underinflated and you should not drive at highway speed. Pull over, check the pressure, and inflate when ready. Once you have restored proper pressure and reset the TPMS light, the low-pressure message will clear on its own.

Frequently Asked Questions

Can I reset the TPMS light without inflating the tires first?

No. The light will turn off temporarily, but it will come back on within a few minutes because the sensors will detect that pressure is still low. You must inflate all four tires to the pressure listed on your door jamb sticker before resetting.

What is the correct tire pressure for my CR-V?

Open the driver's door and look at the sticker on the inside of the door jamb. It lists the target pressure for your specific model year and trim — typically between 32 and 36 psi. This is the pressure you should maintain, not the number printed on the tire sidewall.

Do I need to reset the TPMS light after replacing a tire?

Yes. After installing a new tire, inflate it to the door jamb pressure and follow the reset steps for your model year. The system needs to recalibrate and recognize the new sensor in that wheel.

What if I do not have the door jamb sticker anymore?

You can find the correct pressure in your owner's manual or by searching online for your specific CR-V model year and trim. Honda also lists this information on their website. Do not guess or use the tire sidewall number, which is the maximum pressure, not the recommended pressure.

How often should I check my tire pressure?

Check pressure at least once a month and before long trips. Cold weather can drop pressure by several psi, so check more frequently in winter. Proper pressure extends tire life, improves fuel economy, and keeps the TPMS light off.