Trailer tires wear faster than car tires and fail without warning
Trailer tires need replacement sooner than you might expect, and they fail differently than vehicle tires. A car tire that's worn or damaged usually gives you warning signs—pulling to one side, vibration, or a slow leak. Trailer tires often fail suddenly because they sit stationary for long periods, the sidewalls deteriorate from UV exposure and weather, and the load they carry is concentrated on a smaller contact patch. A blowout at highway speed can cause your trailer to swerve, jackknife, or detach.
The replacement interval depends on age, mileage, storage conditions, and load. Most trailer tires should be replaced every three to five years regardless of tread depth, because the rubber compound hardens and loses grip over time. If you tow regularly, inspect them every season. If your trailer sits unused for months, check the tires before you hook up and drive.
Key Takeaways
- Trailer tires should be replaced every three to five years even if tread looks acceptable, because age and UV damage weaken the rubber faster than mileage does.
- Check the tire sidewalls for cracks, bulges, or flat spots before each towing trip, and replace any tire showing these signs when ready.
- Replacement tires must match the load rating and size stamped on your trailer's placard, not just the old tire's markings.
- Trailer tires are sold individually or in sets, and you can replace one at a time if budget is tight, though matching pairs on the same axle is safer.
- Proper inflation pressure changes with load and temperature, so check the placard on your trailer frame, not the tire sidewall.
How to read the load rating and size on your trailer tire
The tire sidewall shows a code like "ST205/75R15" or "LT235/85R16". The letters at the start matter: ST means special trailer, and LT means light truck. Trailer tires are designed differently—they have stiffer sidewalls to resist the flexing that happens when a trailer bounces on the road. Never put a car tire or a standard LT tire on a trailer, even if the size number matches.
The load rating appears as a number and letter combination, often "C", "D", or "E". This tells you the maximum weight each tire can carry. Your trailer's capacity placard—a metal or plastic label bolted to the frame near the hitch or on the tongue—lists the tire size and load rating your trailer needs. Match that placard exactly when you order replacements. If you cannot find the placard, contact the trailer manufacturer with your VIN or model number.
Load rating matters because an undersized tire will overheat and fail under load, and an oversized tire may not fit your wheel wells or match your trailer's suspension geometry. The placard also lists the correct inflation pressure for your specific trailer and axle configuration.
When to replace a trailer tire before it wears out
Do not wait for tread to wear down. Inspect your tires before every towing trip and replace when ready if you see cracks in the sidewalls, bulges or blisters, flat spots on the bottom, or separation where the tread is peeling away from the carcass. These are signs of structural failure, not just wear. A tire with any of these defects can blow out without warning.
Check the valve stem too. If it's cracked, leaking, or corroded, replace it when you replace the tire. A bad valve stem will cause slow leaks that you might not notice until the tire is dangerously underinflated.
If your trailer has been sitting for more than six months, replace the tires even if they look fine. Rubber hardens and loses elasticity when exposed to sunlight and temperature swings. A tire that looks acceptable may fail within the first few miles of towing.
Matching tires on the same axle and replacing one at a time
Ideally, both tires on the same axle should be the same brand, model, and age. Mismatched tires can cause uneven wear and handling problems. However, if budget is tight, you can replace one tire at a time as long as the new tire matches the load rating and size of the remaining tire on that axle. Do not mix different load ratings on the same axle.
If you have a tandem axle trailer (two axles), you do not have to replace all four tires at once. Replace the pair on one axle first, then the pair on the second axle when those wear out or age to five years. Just keep track of when each pair was installed so you know when the second pair is due.
Avoid buying used trailer tires. You cannot know their history, how they were stored, or how much life remains in the rubber. New tires cost more upfront but are safer and last longer.
Inflation pressure and how temperature affects it
The correct inflation pressure is on your trailer's capacity placard, not on the tire sidewall. The sidewall shows the maximum pressure the tire can hold, which is higher than what your trailer needs. Underinflation causes the tire to flex excessively, generate heat, and fail. Overinflation makes the tire ride hard and wear unevenly in the center.
Pressure changes with temperature. Cold weather lowers pressure, and hot weather raises it. Check pressure when the tires are cold—before you tow or at least three hours after towing stops. If you tow in summer heat, expect pressure to rise 5 to 10 pounds per square inch (psi) above the cold reading. That is normal and acceptable as long as you started at the correct cold pressure.
Check pressure at least monthly during towing season and before every long trip. A slow leak can develop without obvious signs, and a tire that is 10 psi low will overheat and fail faster than you might realize.
Tools and steps for replacing a trailer tire yourself
You need a lug wrench that fits your wheel bolts, a jack rated for your trailer's weight, jack stands, and a tire iron or breaker bar to break the lug nuts loose before jacking. Do not use a car jack on a trailer—it may not be rated for the weight, and the trailer frame geometry is different. A trailer-rated hydraulic jack or a bottle jack rated for at least the weight of one axle is safer.
Loosen the lug nuts slightly while the tire is still on the ground, then jack the trailer until the tire clears the ground by a few inches. Place jack stands under the frame on both sides of the tire for safety. Remove the lug nuts completely, pull the tire straight toward you, and set it aside. Mount the new tire, push it onto the hub, and hand-tighten the lug nuts. Lower the trailer onto the tire, then tighten the lug nuts in a star or cross pattern to may support even pressure. Tighten firmly but do not over-torque—hand-tight plus a quarter turn with the wrench is usually correct for trailer wheels.
If you are not confident with this process, a tire shop can replace the tire for you. The cost is usually $30 to $50 per tire for labor, plus the tire itself.
Where to buy trailer tires and what they cost
Trailer tires are sold at tire shops, truck supply stores, online retailers, and some big-box automotive stores. Prices vary by size and load rating. A single ST tire in common sizes (like ST205/75R15) typically costs $80 to $150, while larger or higher-load-rating tires can cost $150 to $250 each. Buying a pair or set usually offers a small discount.
Online retailers often have lower prices than local shops, but you will need to arrange installation. Some tire shops will install tires you buy elsewhere for a fee, usually $15 to $30 per tire. Factor installation cost into your total when comparing prices.
Ask whether the shop includes a new valve stem with the tire. Some do, some charge extra. A valve stem costs $5 to $15, so confirm before you finalize the order.
Frequently Asked Questions
Can I use car tires or truck tires on my trailer?
No. Car and truck tires are designed for vehicles that steer and brake. Trailer tires have reinforced sidewalls to handle the flexing and bouncing of a towed load. Using the wrong tire type will cause premature failure and is unsafe. Always use tires marked ST (special trailer) or specifically rated for trailer use.
How do I know if my trailer tires are too old to tow with?
Check the sidewall for the DOT code, a series of numbers and letters at the end. The last four digits are the week and year of manufacture—for example, "2419" means week 24 of 2019. If the tire is more than five years old, replace it regardless of tread depth. If it is more than ten years old, do not tow with it under any circumstances.
What should I do if a trailer tire blows out while I'm towing?
Ease off the accelerator and steer firmly to keep the trailer straight. Do not brake hard—this can cause the trailer to jackknife. Pull over to a safe location away from traffic, turn on hazard lights, and inspect the damage. If the tire is destroyed or the rim is damaged, do not attempt to drive to a shop. Call a tow truck or a mobile tire service to replace it on-site.
Do I need to replace both tires on an axle at the same time?
Ideally yes, but you can replace one at a time if needed. Just make sure the new tire matches the load rating and size of the tire remaining on that axle. Avoid mixing different load ratings on the same axle, as this can cause uneven wear and handling problems.
Why does my trailer tire look fine but the shop says it needs replacement?
Tread depth is not the main reason trailer tires fail. Age, UV damage, and sidewall deterioration matter more. A tire that looks acceptable on the outside may have internal damage or hardened rubber that will fail under load. If the tire is over five years old or shows any cracks, bulges, or flat spots, replacement is the safe choice.