You can replace a BMW key fob battery yourself in about five minutes with a coin and a replacement battery
Most BMW key fobs use a CR2032 or CR2025 coin cell battery that you can buy at any drugstore, grocery store, or online retailer for a few dollars. The fob itself is designed to open without tools — you just need a coin to gently pry the two halves apart, swap the old battery for the new one, and snap it back together. The whole job takes longer to find the right battery than to do the replacement.
If your key fob stops locking or unlocking your car, or the buttons feel sluggish, a dead battery is usually the culprit. Before you assume the fob is broken or pay a dealer $150 to $300 for a replacement, try a new battery first.
Key Takeaways
- BMW key fobs typically use a CR2032 or CR2025 battery, which you can buy at a pharmacy or supermarket for under $5.
- You open the fob by inserting a coin into the slot on the edge and gently twisting to separate the two halves.
- The battery sits in a small metal holder; note which side faces up before you remove it so you install the new one the same way.
- After inserting the new battery, press the fob halves together until they click, then test the buttons before putting it away.
What battery your BMW key fob needs
The battery type depends on your BMW model year and fob style, but the two most common are CR2032 and CR2025. Both are coin cell batteries about the size of a dime. A CR2032 is slightly thicker than a CR2025, so it matters which one your fob uses — putting the wrong one in can prevent the fob from closing properly or cause the battery to sit loose.
The easiest way to know which battery you need is to look at the old one after you open the fob. The battery itself is stamped with the model number. If you have lost or damaged the old battery, check your owner's manual or call your BMW dealer with your vehicle identification number (VIN) and they will tell you the correct size.
You can buy either battery at a pharmacy, supermarket, dollar store, or online. A single battery usually costs $2 to $5. Some retailers sell multipacks if you want spares for other devices.
How to open the key fob
Look at the edge of your key fob for a small slot or seam. This is where the two halves of the fob meet. Insert a coin — a dime, penny, or quarter works — into the slot and gently twist it as if you were opening a battery compartment on a remote control. You are not trying to force it; a light twisting motion is enough.
The two halves will separate slightly. Once you see a gap, you can usually pull the halves apart by hand. Be gentle — the plastic clips that hold the fob together are not fragile, but there is no reason to yank it.
Inside, you will see the circuit board and the battery holder. The battery sits in a small metal cradle or clip. Note which side of the battery faces up — the positive side (marked with a +) should face toward you or toward the circuit board, depending on your fob design. Take a photo with your phone if you are worried you will forget.
Removing the old battery and installing the new one
Gently pry the old battery out of its holder using your fingernail or the edge of a coin. It should come out easily. If it is stuck, do not force it; a tiny bit of gentle rocking usually frees it.
Once the old battery is out, insert the new battery into the holder with the positive side facing the same direction as the old one faced. The battery should sit flat and snug in the cradle. If it feels loose or tilted, remove it and try again — a loose battery will not make good contact and the fob will not work.
Some fobs have a small metal clip that holds the battery in place. If yours does, make sure the clip is not bent and that it sits over the battery properly before you close the fob.
Closing the fob and testing the buttons
Align the two halves of the fob so the seam is even all the way around. Press them together firmly until you hear or feel a click. The fob should be snug and not rattle when you shake it. If it feels loose, open it again and check that the battery is sitting flat in its holder.
Once the fob is closed, test the lock and unlock buttons. Stand near your car and press each button a few times. You should hear the car lock or unlock, and you may see the lights flash. If nothing happens, open the fob again and check that the battery is installed correctly — the most common mistake is installing it upside down.
If the fob still does not work after you have checked the battery twice, the problem may be something else, such as a broken button or a circuit board issue. At that point, contact your BMW dealer or a local locksmith who works on BMW fobs.
When to replace the whole fob instead of just the battery
If the buttons are cracked, the plastic is broken, or water has gotten inside the fob, a new battery will not fix it. In those cases, you will need a replacement fob. BMW dealers can order one and program it to your car, though the cost is usually $150 to $300 depending on the model.
Some independent locksmiths and online retailers also sell BMW key fobs at a lower price, but you will still need to have it programmed to your vehicle. Programming usually requires a dealer or a locksmith with BMW-specific equipment, so factor that cost into your decision.
If your fob is working but just slow to respond, a new battery almost always solves the problem. If the buttons work fine but the fob does not lock or unlock the car, the issue may be with your car's receiver, not the fob — in that case, contact your dealer.
Frequently Asked Questions
Can I use a different battery size if I cannot find the right one?
No. A CR2032 and CR2025 are different thicknesses, and using the wrong one can prevent the fob from closing properly or cause the battery to lose contact with the terminals. Stick with the size your fob was designed for. If you cannot find it locally, order it online — it will arrive in a day or two.
What do I do if the battery is stuck and I cannot get it out?
Do not pry hard or use sharp tools, as you can damage the battery holder. Try gently rocking the battery side to side with your fingernail, or use a plastic spoon handle to nudge it. If it still will not budge, let the fob sit for a few hours — sometimes a stuck battery will loosen on its own.
How often do BMW key fob batteries need to be replaced?
Most key fob batteries last two to four years, depending on how often you use the fob. If you use your fob multiple times a day, you may need a new battery sooner. There is no set schedule — replace it when the buttons stop working reliably.
Will replacing the battery erase my fob's programming?
No. The battery powers the fob, but the programming is stored on the circuit board and is not affected by a battery change. Your fob will work exactly as it did before once you install the new battery.
What if the fob still does not work after I put in a new battery?
Open the fob again and check that the battery is installed with the correct side facing up. If it is, try cleaning the battery terminals with a dry cloth to remove any dirt or corrosion. If the fob still does not work, the problem is likely a broken button or circuit board, and you will need a replacement fob.