Most key fob batteries cost $3 to $8 and take less than five minutes to swap out yourself
You can replace almost any car key fob battery without tools, a mechanic, or a trip to the dealership. The battery itself is cheap — usually between $3 and $8 — and the job involves opening the fob case, removing the old battery, and sliding in a new one. The hardest part is finding the seam where the fob opens, which manufacturers hide on purpose.
The process is the same whether your fob is for a Ford, Honda, Toyota, or any other brand. The only variable is the battery type your specific fob uses, which you can find by opening it and reading the number printed on the battery itself.
Key Takeaways
- Open your fob by finding the seam (usually on the side or back) and gently prying with a coin, flathead screwdriver, or plastic spoon.
- Write down or photograph the battery type number before removing the old battery so you buy the exact replacement.
- Common key fob batteries are CR2032, CR2025, and CR2016 — all available at drugstores, supermarkets, and online for under $10.
- Insert the new battery with the positive side facing up (the side marked with a + symbol) and snap the fob back together.
- If your fob still does not work after a new battery, the problem is likely a worn button contact or internal damage, not the battery.
Finding the seam and opening your fob
The fob case is held together by a seam, not screws. Run your fingernail or thumb along the edges — you will feel a thin line where the two halves meet. On most fobs this seam runs horizontally around the middle, but some manufacturers put it on the side or along the back edge.
Once you locate the seam, use a coin (a dime or penny works well), a flathead screwdriver, or the edge of a plastic spoon to gently pry the two halves apart. Start at one end of the seam and work your way around. Do not force it — if you are meeting hard resistance, you are probably not in the seam. The case should separate with light, steady pressure.
Inside you will see the battery sitting in a small metal or plastic holder. It is round and flat, about the size of a dime. The battery holder usually has a small lip or tab that you can use to lift the battery out, or you can gently pry it up with your fingernail.
Identifying and buying the correct battery
Before you remove the old battery, look at the top surface and write down the number you see printed there. Key fob batteries are labeled with codes like CR2032, CR2025, CR2016, or sometimes just the numbers without the "CR" prefix. This code tells you the exact size and chemistry your fob needs.
Take that number to any drugstore, supermarket, or pharmacy — the battery section usually has a display with common fob batteries. You can also order online from Amazon, eBay, or battery specialty sites. A single replacement battery costs $3 to $8, though multi-packs are often cheaper per battery if you have multiple fobs or want spares.
Do not guess at the battery type. Using the wrong size can damage the fob's contacts or not fit in the holder at all. The code on the old battery is your exact specification.
Removing the old battery and installing the new one
Lift or pry the old battery out of its holder. You may see a small metal spring or contact underneath — do not lose this. If it falls out, note which end it was touching (usually the negative end, marked with a minus sign).
Before inserting the new battery, look at it closely. One side has a + symbol printed on it (the positive terminal) and the other side is blank or marked with a minus sign (the negative terminal). The positive side must face up toward the top of the fob. This is the most common orientation, though a few older fobs reverse this — if your fob did not work before and you are certain the battery is correct, try flipping it.
Slide the new battery into the holder with the positive side up. It should sit flat and snug. If there is a metal spring underneath, make sure it is still in place and touching the negative side of the battery.
Closing the fob and testing the buttons
Align the two halves of the fob and press them together firmly until you hear or feel a click. The seam should be flush — if there is a gap, the case is not fully seated. Press around the edges until it closes completely.
Test each button on the fob — lock, unlock, trunk, panic, or whatever functions yours has. Point the fob at your car from a few feet away and press each button. You should see your car respond (lights flash, doors lock, trunk opens). If nothing happens, the battery may be installed backward or the fob may have a deeper problem.
What to do if the new battery does not fix the problem
If your fob still does not work after installing a fresh battery, the issue is not the battery. The most common culprit is worn button contacts — the rubber pads inside the fob that complete the circuit when you press a button. These wear out over time and cannot be replaced without specialized tools.
The second possibility is internal water damage or corrosion on the circuit board, which happens if the fob has been dropped in water or exposed to moisture. A new battery will not fix this.
Your options at this point are to buy a replacement fob from your car's manufacturer (usually $100 to $300 depending on the car), buy an aftermarket fob (often $20 to $60), or have a locksmith reprogram an existing fob if you have a spare. Some dealerships will reprogram a fob you buy elsewhere, though many charge a programming fee on top of the fob cost.
Common battery types and where to find them
The three most common key fob batteries are CR2032, CR2025, and CR2016. The first four digits tell you the size (20 millimeters in diameter), and the last two digits tell you the thickness (3.2 millimeters, 2.5 millimeters, and 1.6 millimeters respectively). Most modern fobs use CR2032 because it holds more charge.
All three types are stocked at CVS, Walgreens, Target, Walmart, and most grocery stores in the battery aisle. You can also order them from Amazon, Best Buy, or battery-specific sites like Batteries Plus. A single battery typically costs $4 to $8 at a retail store, but buying a multi-pack online often brings the per-battery cost down to $1 to $2.
Frequently Asked Questions
Can I replace a key fob battery if I do not have a coin or screwdriver?
Yes. A plastic spoon, butter knife, or even a credit card edge can work. The goal is to gently separate the two halves along the seam without scratching the plastic. Avoid metal tools if you are worried about damaging the fob's finish.
What if I put the battery in backward?
The fob straightforward will not work. The battery holder is designed so that the positive and negative terminals touch specific contacts inside the fob. If you reverse the battery, those contacts do not connect. Remove the battery, flip it, and try again.
How long does a key fob battery last?
Most key fob batteries last three to four years with normal use. Heavy use — pressing the buttons many times per day — can shorten this to two years. You will notice the range getting shorter (you have to stand closer to the car) before the battery dies completely.
Do I need to reprogram my fob after changing the battery?
No. Changing the battery does not erase the fob's programming. The code that tells your car to recognize the fob is stored in the fob's circuit board, not in the battery. A new battery straightforward powers the existing code.
Can I use a rechargeable battery in my key fob?
Not recommended. Rechargeable batteries (like NiMH types) have a different voltage than disposable batteries and may not provide enough power to transmit the signal reliably. Stick with the disposable battery type printed on your old battery.