What the Tr3300de is and where it mounts
The Saddlemen Tr3300de is a soft luggage bag that sits on top of your motorcycle's rear rack, held down by straps rather than bolted to the frame. It's designed for bikes with existing luggage racks — usually cruisers, touring bikes, and adventure models — and it gives you about 3,300 cubic inches of storage without permanent modification to your bike.
The bag itself is made from ballistic nylon with a waterproof liner, and it has a rigid base that sits flat on your rack. The mounting system uses four heavy-duty straps with quick-release buckles that wrap around the rack rails and tighten down. Installation takes about 15 minutes once you have the bag out of the box and your rack is clean.
Key Takeaways
- The Tr3300de mounts to your existing rear rack using four straps with quick-release buckles, not bolts or welding.
- You need a clean, dry rack surface and access to the underside of your rack to thread the straps through properly.
- The bag's rigid base should sit centered on the rack, with the straps pulling evenly from all four corners.
- Test the tightness by lifting the bag by hand before riding — it should not shift or slide when you push it sideways.
Tools and materials you'll need
You don't need many tools for this job. Have a clean, dry cloth or rag on hand to wipe down your rack before you start, because dirt or moisture under the bag's base can cause it to slip during riding. A flashlight or headlamp is useful if your rack is in shadow or if you're working in low light, since you'll need to see the underside of the rack to route the straps.
The bag comes with all four straps and buckles already attached. You won't need to buy additional hardware unless a strap is damaged when the bag arrives. If you're mounting this on a bike with a painted or powder-coated rack, consider laying a thin rubber mat or towel under the bag's base to prevent the nylon from rubbing the finish during long rides — this is optional but recommended for bikes with custom paint.
Step-by-step installation process
Step 1: Position the bag on the rack. Place the Tr3300de on top of your rear rack with the bag centered front-to-back and side-to-side. The rigid base should sit flat and stable. If your rack has a slight curve or crown, the base will conform slightly, but the bag should not rock or tilt. Adjust it until it feels balanced.
Step 2: Route the front straps. The two front straps (the ones closest to the rider) need to wrap around the front edge of the rack rails. Lift the front of the bag slightly and slide each strap under the rack from the top, then pull it back up and over the front edge. The strap should wrap around the rail in a U-shape, with the buckle facing forward. Do this on both sides.
Step 3: Route the rear straps. The two rear straps work the same way but attach to the back of the rack. Lift the rear of the bag, slide each strap under the rack from the top, and pull it back up and over the rear edge. Again, the buckles should face outward and be straightforward to reach without removing the bag.
Step 4: Tighten all four straps evenly. Start with the front-left strap and pull it snug — not so tight that you're straining, but tight enough that there's no slack. Move to the front-right, then rear-left, then rear-right. Go around a second time and tighten each one a bit more. The goal is even tension across all four corners so the bag doesn't tilt or shift.
Step 5: Test the installation. Grab the bag by the handle and try to lift it straight up. It should not come free from the rack. Push it sideways, forward, and backward with moderate force. The bag should not slide or rotate. If it moves, go back and tighten the straps another notch on whichever side is loose.
Common mistakes that cause the bag to shift or slip
The most frequent problem is uneven strap tension. If the front straps are much tighter than the rear ones, the bag will tilt backward and the rear corners will lift slightly during acceleration. This creates movement and can eventually damage the straps or the bag's attachment points. Tighten all four straps in a cross pattern — front-left, rear-right, front-right, rear-left — rather than finishing one side completely before moving to the other.
The second common issue is a dirty or wet rack surface. If dust, road grime, or moisture sits between the bag's base and the rack, the bag will slide forward or backward under braking or acceleration. Wipe your rack clean with a dry cloth before mounting the bag, and if you've been riding in rain, dry the rack before reinstalling the bag after a stop.
A third mistake is not routing the straps correctly under the rack. If a strap sits on top of the rack rail instead of wrapping underneath and around it, the bag will shift sideways during cornering. Take time to make sure each strap goes under the rail, comes back up on the other side, and wraps around the top. You should be able to see the strap on both sides of the rail.
Checking your installation before your first ride
Before you ride, sit on the bike and rock it side to side gently. The bag should move with the bike, not independently. Bounce slightly on the seat a few times — the bag should not bounce or rattle. If you hear any noise or feel movement, stop and retighten the straps.
Take a short test ride at low speed in a parking lot or quiet street. Listen for rattling or creaking from the bag. Feel whether the bike handles normally or if the weight distribution feels off. The Tr3300de is designed to sit high and centered, so it shouldn't affect handling noticeably, but a poorly secured bag can create vibration or noise that becomes annoying on longer rides.
After your first 20 to 30 miles of riding, pull over and check the straps again. New nylon can settle slightly, and the straps may have loosened a bit from vibration. Tighten them if needed. After that, check them every few hundred miles or whenever you notice the bag moving.
Removing and reinstalling the bag
To remove the bag, straightforward release all four quick-release buckles. The straps will stay attached to the bag, so you don't have to rethread them each time. Lift the bag straight up and off the rack. To reinstall, place the bag back on the rack in the same position, route the straps under the rails (they should already be in the right position), and tighten the buckles.
If you need to remove the straps completely — for example, if one is damaged and you're replacing it — they are sewn to the bag at the base. You can have a leather or canvas repair shop resew a strap, or contact Saddlemen directly for a replacement strap assembly. Most riders never need to do this, but it's worth knowing the bag is repairable if a strap tears or a buckle breaks.
Frequently Asked Questions
Can I install the Tr3300de on a rack that's not made by Saddlemen?
Yes. The bag works on any rear rack with horizontal rails that are at least 1 inch in diameter. The straps wrap around the rails, so the exact brand doesn't matter. If your rack has very thin rails (less than 1 inch) or an unusual shape, the straps may not grip securely — test it in a parking lot before highway riding.
What if my rack is too small or oddly shaped for the straps to wrap around?
If the straps won't wrap properly, you have two options: use a different bag designed for your specific rack, or add a small luggage rack extension or adapter plate that gives the straps something to grip. Some riders use a bungee cord or ratchet strap as a backup, but this is not ideal because it can damage the bag over time.
Does the bag need to be waterproof, or is the liner enough?
The bag itself is made from ballistic nylon, which is water-resistant but not fully waterproof. The interior has a waterproof liner that keeps rain out of your gear. For heavy rain or water crossings, make sure the top flap is fully closed and sealed. The bag is not designed for submersion, so avoid riding through deep water.
How often should I retighten the straps?
Check the straps every few hundred miles or whenever you notice movement. After the first 20 to 30 miles, tighten them once. After that, most riders find they stay tight for weeks or months of normal riding. If you frequently ride on rough roads or do a lot of hard braking and acceleration, check them more often.
Can I carry the bag off the bike, or does it have to stay mounted?
The bag is designed to stay on the rack, but you can remove it and carry it by the handle. It's not a backpack or shoulder bag, so carrying it for long distances is awkward. Most riders leave it mounted and use it as permanent luggage storage on the bike.